Airworthiness Directives; Dassault Aviation Airplanes
Federal Register, Volume 81 Issue 211 (Tuesday, November 1, 2016)
Federal Register Volume 81, Number 211 (Tuesday, November 1, 2016)
Proposed Rules
Pages 75757-75758
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2016-26325
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2016-9303; Directorate Identifier 2016-NM-093-AD
RIN 2120-AA64
Airworthiness Directives; Dassault Aviation Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for all Dassault Aviation Model FAN JET FALCON airplanes; all Model FAN JET FALCON SERIES C, D, E, F, and G airplanes; and all Model MYSTERE-FALCON 20-C5, 20-D5, 20-E5, and 20-F5 airplanes. This proposed AD was prompted by a determination that inspections for discrepancies of the fuselage bulkhead are necessary. This proposed AD would require repetitive inspections for discrepancies of the fuselage bulkhead, and repair if necessary. We are proposing this AD to detect and correct discrepancies of the fuselage bulkhead; such discrepancies could result in the deterioration and failure of the bulkhead, which could result in rapid decompression of the airplane and consequent injury to occupants.
DATES: We must receive comments on this proposed AD by December 16, 2016.
ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
9303; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone: 425-227-1137; fax: 425-227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2016-9303; Directorate Identifier 2016-NM-093-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA Airworthiness Directive 2016-0096, dated May 19, 2016 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Dassault Aviation Model FAN JET FALCON airplanes; all Model FAN JET FALCON SERIES C, D, E, F, and G airplanes; and all Model MYSTERE-FALCON 20-C5, 20-D5, 20-
E5, and 20-F5 airplanes. The MCAI states:
A detailed inspection (DET) of the fuselage bulkhead at frame (FR) 33 is established through a subset of inspection/check maintenance procedure referenced in the applicable aircraft maintenance manual (AMM), task 53-10-0-6 ``MAIN FRAME--INSPECTION/
CHECK'', with periodicity established in Chapter 5-10, at every C-
Check. Failure to accomplish this DET could lead to deterioration of the affected structure.
This condition, if not detected and corrected, could lead to bulkhead failure, possibly resulting in a rapid depressurization of the aeroplane and consequent injury to occupants.
For the reasons described above, this EASA AD requires repetitive DET of the bulkhead at FR33 for discrepancies, such as buckling, deformations, cracks, loose countersinks, scratches, dents, and corrosion, and depending on findings, repair of the affected structure.
You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
9303.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of these same type designs.
Costs of Compliance
We estimate that this proposed AD affects 133 airplanes of U.S. registry.
We also estimate that it would take about 8 work-hours per product to
Page 75758
comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Based on these figures, we estimate the cost of this proposed AD on U.S. operators to be $90,440, or $680 per product.
We have received no definitive data that would enable us to provide cost estimates for the on-condition actions specified in this proposed AD.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
Dassault Aviation: Docket No. FAA-2016-9303; Directorate Identifier 2016-NM-093-AD.
(a) Comments Due Date
We must receive comments by December 16, 2016.
(b) Affected ADs
None.
(c) Applicability
This AD applies to the Dassault Aviation airplanes specified in paragraphs (c)(1) and (c)(2) of this AD, certificated in any category, all manufacturer serial numbers.
(1) Model FAN JET FALCON and FAN JET FALCON SERIES C, D, E, F, and G airplanes.
(2) Model MYSTERE-FALCON 20-C5, 20-D5, 20-E5, and 20-F5 airplanes.
(d) Subject
Air Transport Association (ATA) of America Code 53, Fuselage.
(e) Reason
This AD was prompted by a determination that inspections for discrepancies of the fuselage bulkhead at frame (FR) 33 are necessary. We are issuing this AD to detect and correct discrepancies of the fuselage bulkhead; such discrepancies could result in the deterioration and subsequent failure of the bulkhead, which could result in rapid decompression of the airplane and consequent injury to occupants.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Repetitive Inspections
Before exceeding 5,000 total flight cycles since first flight of the airplane, or within 500 flight cycles after the effective date of this AD, whichever occurs later: Do a detailed inspection for discrepancies of the fuselage bulkhead at FR 33 using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Dassault Aviation's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-
authorized signature. Repeat the inspection thereafter at intervals not to exceed 5,000 flight cycles.
(h) Repair
If any discrepancy is found during any inspection required by paragraph (g) of this AD: Before further flight, repair using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the EASA; or Dassault Aviation's EASA DOA. If approved by the DOA, the approval must include the DOA-authorized signature. Repair of an airplane as required by this paragraph does not constitute terminating action for the repetitive actions required by paragraph (g) of this AD, unless specified otherwise in the repair instructions.
(i) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone: 425-227-1137; fax: 425-227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the EASA; or Dassault Aviation's EASA DOA. If approved by the DOA, the approval must include the DOA-authorized signature.
(j) Related Information
Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA Airworthiness Directive 2016-0096, dated May 19, 2016, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-9303.
Issued in Renton, Washington, on October 26, 2016.
Dionne Palermo,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2016-26325 Filed 10-31-16; 8:45 am
BILLING CODE 4910-13-P
