Airworthiness Directives; Fokker Services B.V. Airplanes
Federal Register, Volume 81 Issue 238 (Monday, December 12, 2016)
Federal Register Volume 81, Number 238 (Monday, December 12, 2016)
Rules and Regulations
Pages 89373-89375
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2016-29243
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2015-7530; Directorate Identifier 2014-NM-257-AD; Amendment 39-18730; AD 2016-25-04
RIN 2120-AA64
Airworthiness Directives; Fokker Services B.V. Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for all Fokker Services B.V. Model F28 Mark 0070 and 0100 airplanes. This AD was prompted by a report of cracking in a certain section of the secondary structure of the wing. This AD requires a one-time inspection of the trailing edge rib, and corrective action if necessary. We are issuing this AD to address the unsafe condition on these products.
DATES: This AD is effective January 17, 2017.
The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of January 17, 2017.
ADDRESSES: For service information identified in this final rule, contact Fokker Services B.V., Technical Services Dept., P.O. Box 1357, 2130 EL Hoofddorp, the Netherlands; telephone +31 (0)88-6280-350; fax +31 (0)88-6280-111; email technicalservices@
Page 89374
fokker.com; Internet http://www.myfokkerfleet.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-7530.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
7530; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone 800-647-5527) is Docket Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer, ANM 116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1137; fax 425-227-1139.
SUPPLEMENTARY INFORMATION:
Discussion
We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all Fokker Services B.V. Model F28 Mark 0070 and 0100 airplanes. The NPRM published in the Federal Register on December 24, 2015 (80 FR 80299) (``the NPRM'').
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA Airworthiness Directive 2014-0271, dated December 12, 2014 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Fokker Services B.V. Model F28 Mark 0070 and 0100 airplanes. The MCAI states:
Service experience with the Fokker 100 type design has shown that cracking can occur in the secondary structure of the wing at station 8700, rib Part Number (P/N) D15445-013/-014 (or lower dash number) in the trailing edge section. The hydraulic actuator assembly, hydraulic lines, the cable pulleys, the anti-upfloat quadrant and the associated mechanical linkages including flutter dampers are all positioned in the affected area, between wing stations 8200 and 9270.
This condition, if not detected and corrected, could lead to failure of the affected rib, possibly resulting in reduced control of the aeroplane.
To address this potential unsafe condition, Fokker Services published Service Bulletin (SB) SBF100-57-048, which provides inspection instructions to detect any cracks in the affected area.
For the reasons described above, this EASA AD requires a one-
time detailed inspection of the trailing edge rib at wing station 8700 and, depending on findings, accomplishment of applicable corrective action(s).
This EASA AD is considered to be an interim action and further AD action may follow, possibly to introduce new ALS Airworthiness Limitations Section tasks, if justified by the inspection results.
Corrective actions include repair of cracking in the secondary structure of the wing at station 8700, rib part number (P/N) D15445-
013/-014 (or lower dash number), in the trailing edge section.
You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
7530.
Comments
We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.
Conclusion
We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM.
Related Service Information Under 1 CFR Part 51
We reviewed Fokker Service Bulletin SBF100-57-048, dated October 27, 2014. This service information describes procedures for inspecting the trailing edge section at the rib of wing station 8700 for cracking. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.
Costs of Compliance
We estimate that this AD affects 8 airplanes of U.S. registry.
We also estimate that it will take about 1 work-hour per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $0 per product. Based on these figures, we estimate the cost of this AD on U.S. operators to be $680, or $85 per product.
We have received no definitive data that will enable us to provide cost estimates for the on-condition actions specified in this AD.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
Page 89375
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
2016-25-04 Fokker Services B.V.: Amendment 39-18730; Docket No. FAA-
2015-7530; Directorate Identifier 2014-NM-257-AD.
(a) Effective Date
This AD is effective January 17, 2017.
(b) Affected ADs
None.
(c) Applicability
This AD applies to all Fokker Services B.V. Model F28 Mark 0070 and 0100 airplanes, certificated in any category.
(d) Subject
Air Transport Association (ATA) of America Code 57, Wings.
(e) Reason
This AD was prompted by report of cracking in the secondary structure of the wing at station 8700. We are issuing this AD to detect and correct cracking that could lead to failure of the affected rib and consequent reduced control of the airplane.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Inspection
Within 12 months after the effective date of this AD: Do a detailed inspection for cracking of the trailing edge rib at wing station 8700, in accordance with the Accomplishment Instructions of Fokker Service Bulletin SBF100-57-048, dated October 27, 2014. If any crack is found, before further flight, repair using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA); or Fokker Services B.V.'s EASA Design Organization Approval (DOA).
(h) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1405; fax 425-227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the EASA; or Fokker B.V. Service's EASA DOA. If approved by the DOA, the approval must include the DOA-authorized signature.
(i) Related Information
Refer to Mandatory Continuing Airworthiness Information (MCAI) European AD 2014-0271, dated December 12, 2014, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-7530.
(j) Material Incorporated by Reference
(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Fokker Service Bulletin SBF100-57-048, dated October 27, 2014.
(ii) Reserved.
(3) For service information identified in this AD, contact Fokker Services B.V., Technical Services Dept., P.O. Box 1357, 2130 EL Hoofddorp, the Netherlands; telephone +31 (0)88-6280-350; fax +31 (0)88-6280-111; email technicalservices@fokker.com; Internet http://www.myfokkerfleet.com.
(4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.
Issued in Renton, Washington, on November 25, 2016.
John P. Piccola, Jr.,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2016-29243 Filed 12-9-16; 8:45 am
BILLING CODE 4910-13-P
