Airworthiness Directives:

Federal Register Volume 76, Number 192 (Tuesday, October 4, 2011)

Rules and Regulations

Pages 61255-61257

From the Federal Register Online via the Government Printing Office [www.gpo.gov]

FR Doc No: 2011-25481

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration 14 CFR Part 39

Docket No. FAA-2011-0935; Directorate Identifier 2011-NE-28-AD;

Amendment 39-16813; AD 2011-18-51R1

RIN 2120-AA64

Airworthiness Directives; Honeywell International Inc. TPE331

Model Turboprop Engines With Certain Dixie Aerospace, LLC Main Shaft

Bearings

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule; request for comments.

SUMMARY: We are revising an existing emergency airworthiness directive

(AD) for all Honeywell International Inc. TPE331 model turboprop engines with a part manufacturer approval (PMA) replacement Dixie

Aerospace, LLC main shaft bearing part number (P/N) 3108098-1WD, installed. That emergency AD was not published in the Federal Register, but was sent to all known U.S. owners and operators of these engines.

That AD currently requires an inspection of the airplane records to determine if a Dixie Aerospace, LLC main shaft bearing, P/N 3108098- 1WD, is installed in the engine, and if installed, removal of that bearing from service, before further flight. This AD requires the same actions. This AD revision was prompted by the need to list the affected bearings by serial number (S/N) in the AD for clarification. We are issuing this AD to correct the unsafe condition on these products.

DATES: This AD is effective October 19, 2011.

We must receive comments on this AD by November 18, 2011.

ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

Page 61256

Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.

Fax: 202-493-2251.

Mail: U.S. Department of Transportation, Docket

Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New

Jersey Avenue, SE., Washington, DC 20590.

Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations Office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Juanita Craft, Aerospace Engineer,

FAA, Atlanta Aircraft Certification Office, 1701 Columbia Avenue,

College Park, GA 30337; phone: 404-474-5584; fax: 404-474-5606; e-mail: juanita.craft@faa.gov.

SUPPLEMENTARY INFORMATION:

Discussion

On August 17, 2011, we issued Emergency AD 2011-18-51, for all

Honeywell International Inc. TPE331 model turboprop engines with a PMA replacement Dixie Aerospace, LLC main shaft bearing, P/N 3108098-1WD, installed. That AD requires inspection of the airplane records to determine if a Dixie Aerospace, LLC main shaft bearing, part number (P/

N) 3108098-1WD, is installed in the engine, and if installed, removal of that bearing from service, before further flight. That emergency AD resulted from an excessive failure rate of PMA main shaft bearings, P/N 3108098-1WD, manufactured by Dixie Aerospace, LLC. That emergency AD was not published in the Federal Register, but was sent to all known

U.S. owners and operators of these engines. This AD requires the same actions. We are issuing this AD to prevent engine main rotor seizure resulting in engine damage, shutdown, and damage to the airplane.

Under 14 CFR 39.1, the Engine & Propeller Directorate is only authorized to issue airworthiness directives that apply to aircraft engines, propellers, or appliances (hereinafter referred to in this AD as ``products'') when an unsafe condition exists in a product; and that unsafe condition is likely to exist or develop in other products of the same type design. Therefore, although the unsafe condition is caused by the failure of certain PMA parts manufactured by Dixie Aerospace, LLC, for the product affected, we must include the type certificate (TC) holder's legal name in the subject line of the AD. For this AD, the TC holder is Honeywell International Inc.

Actions Since AD 2011-18-51 Was Issued

We are revising Emergency AD 2011-18-51 with this final rule because we determined the need to list the affected bearings by serial number (S/N) in the AD for clarification.

FAA's Determination

We are issuing this AD because we evaluated all relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.

AD Requirements

This AD requires an inspection of records to determine if certain

S/N Dixie Aerospace, LLC main shaft bearings, P/N 3108098-1WD, are installed in Honeywell International Inc. TPE331 model turboprop engines. Within 10 operating hours, affected bearings must be removed from service.

FAA's Justification and Determination of the Effective Date

An unsafe condition exists that requires the immediate adoption of this AD. The FAA has found that the risk to the flying public justifies waiving notice and comment prior to adoption of this rule because the bearing failure mechanism is severe and sudden. Therefore, we find that notice and opportunity for prior public comment are impracticable and that good cause exists for making this amendment effective in less than 30 days.

Comments Invited

This AD is a final rule that involves requirements affecting flight safety and we did not provide you with notice and an opportunity to provide your comments before it becomes effective. However, we invite you to send any written data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include the docket number FAA-2011-0935 and Directorate Identifier 2011-NE-28-

AD at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this AD.

Costs of Compliance

We estimate that this AD will require 1,000 engines installed on airplanes of U.S. registry to have their records inspected, and the inspection will take about 0.5 hour per engine. We also estimate that one engine will require the affected main shaft bearing to be removed from service. We also estimate that it will take about 24 work-hours per engine to remove the bearing from service and that the average labor rate is $85 per work-hour. A replacement bearing will cost about

$5,750. Based on these figures, we estimate the total cost of the AD to

U.S. operators to be $50,290.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in subtitle VII, part A, subpart III, section 44701: ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

Page 61257

For the reasons discussed above, I certify that this AD:

(1) Is not a ``significant regulatory action'' under Executive

Order 12866,

(2) Is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Accordingly, under the authority delegated to me by the

Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD): 2011-18-51R1 Honeywell International Inc.: Amendment 39-16813;

Docket No. FAA-2011-0935; Directorate Identifier 2011-NE-28-AD.

Effective Date

(a) This AD is effective October 19, 2011.

Affected ADs

(b) This AD revises emergency AD 2011-18-51.

Applicability

(c) This AD applies to all Honeywell International Inc. TPE331 model turboprop engines with the serial numbers (S/Ns) of part manufacturer approval (PMA) replacement Dixie Aerospace, LLC main shaft bearings, part number (P/N) 3108098-1WD, listed by S/N in

Table 1 of this AD, installed. Bearings having the P/N 3108098-1, but not the WD at the end of the P/N, are not affected by this AD.

Table 1--Affected S/Ns of Dixie Aerospace, LLC Main Shaft Bearings, P/N 3108098-1WD

A10-1727

A10-1762

A10-1764

A10-1770

A10-1771

A10-1775

A10-1776

A10-1780

A10-1786

A10-1789

A10-1796

A10-1798

A10-1799

A10-1800

A10-1801

A10-1803

A10-1804

A10-1805

A10-1809

A10-1810

A10-1811

A10-1814

A10-1818

A10-1822

A10-1825

Unsafe Condition

(d) This AD revision was prompted by the need to list the affected bearings by S/N in the AD for clarification. We are issuing this AD to prevent engine main rotor seizure resulting in engine damage, shutdown, and damage to the airplane.

Compliance

(e) Comply with this AD within the compliance times specified, unless already done.

(f) For all airplanes with a Honeywell International Inc. TPE331 model turboprop engine installed, where the engine was overhauled or replaced since February 1, 2010:

(1) Within 10 operating hours, inspect the airplane records to determine if any of the S/Ns of Dixie Aerospace, LLC main shaft bearing, P/N 3108098-1WD, listed in Table 1 of this AD, are installed in the engine.

(2) Remove all S/Ns of Dixie Aerospace, LLC main shaft bearings listed in Table 1 of this AD, from service, before further flight.

Installation Prohibition

(g) After the effective date of this AD, do not install any of the bearings listed in Table 1 of this AD into any engine.

Alternative Methods of Compliance (AMOCs)

(h) The Manager, Atlanta Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19.

Related Information

(i) For further information about this AD, contact: Juanita

Craft, Aerospace Engineer, Atlanta Aircraft Certification Office,

FAA, Atlanta Aircraft Certification Office, 1701 Columbia Avenue,

College Park, GA 30337; phone: 404-474-5584; fax: 404-474-5606; e- mail: juanita.craft@faa.gov.

Issued in Burlington, Massachusetts, on September 16, 2011.

Peter A. White,

Manager, Engine & Propeller Directorate, Aircraft Certification

Service.

FR Doc. 2011-25481 Filed 10-3-11; 8:45 am

BILLING CODE 4910-13-P

VLEX uses login cookies to provide you with a better browsing experience. If you click on 'Accept' or continue browsing this site we consider that you accept our cookie policy. ACCEPT