Airworthiness Directives: Boeing Model 757 Airplanes

Federal Register: April 14, 2008 (Volume 73, Number 72)

Rules and Regulations

Page 19982-19983

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

DOCID:fr14ap08-11

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration 14 CFR Part 39

Docket No. FAA-2008-0011; Directorate Identifier 2007-NM-203-AD;

Amendment 39-15460; AD 2008-08-08

RIN 2120-AA64

Airworthiness Directives; Boeing Model 757 Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule.

SUMMARY: We are adopting a new airworthiness directive (AD) for certain

Boeing Model 757 airplanes. This AD requires an inspection to determine the manufacturer and manufacture date of the oxygen masks in the passenger service units and the lavatory and attendant box assemblies, and corrective action if necessary. This AD results from a report that several passenger masks with broken in-line flow indicators were found following a mask deployment. We are issuing this AD to prevent the in- line flow indicators of the passenger oxygen masks from fracturing and separating, which could inhibit oxygen flow to the masks and consequently result in exposure of the passengers and cabin attendants to hypoxia following a depressurization event.

DATES: This AD is effective May 19, 2008.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of May 19, 2008.

ADDRESSES: For service information identified in this AD, contact

Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124- 2207.

Examining the AD Docket

You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The address for the

Docket Office (telephone 800-647-5527) is the Document Management

Facility, U.S. Department of Transportation, Docket Operations, M-30,

West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE.,

Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT: Robert Hettman, Aerospace Engineer,

Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle

Aircraft Certification Office, 1601 Lind Avenue, SW., Renton,

Washington 98057-3356; telephone (425) 917-6457; fax (425) 917-6590.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an airworthiness directive (AD) that would apply to certain Boeing Model 757 airplanes. That NPRM was published in the

Federal Register on January 14, 2008 (73 FR 2195). That NPRM proposed to require an inspection to determine the manufacturer and manufacture date of the oxygen masks in the passenger service units and the lavatory and attendant box assemblies, and corrective action if necessary.

Comments

We gave the public the opportunity to participate in developing this AD. We considered the comment received. Boeing supports the NPRM.

Conclusion

We reviewed the relevant data, considered the comments received, and determined that air safety and the public interest require adopting the AD as proposed.

Costs of Compliance

There are about 1,035 airplanes of the affected design in the worldwide fleet. This AD affects about 640 airplanes of U.S. registry.

The required actions take about 20 work hours per airplane, for an average of 240 oxygen masks per airplane, at an average labor rate of

$80 per work hour. Based on these figures, the estimated cost of the AD for U.S. operators is $1,024,000, or $1,600 per airplane.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation

Programs,'' describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in

``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a ``significant regulatory action'' under Executive

Order 12866,

(2) Is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979), and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

You can find our regulatory evaluation and the estimated costs of compliance in the AD Docket.

Page 19983

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment 0

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2008-08-08 Boeing: Amendment 39-15460. Docket No. FAA-2008-0011;

Directorate Identifier 2007-NM-203-AD.

Effective Date

(a) This airworthiness directive (AD) is effective May 19, 2008.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Boeing Model 757-200, -200CB, -200PF, and

-300 series airplanes, certificated in any category; as identified in Boeing Special Attention Service Bulletin 757-35-0028, dated

April 9, 2007.

Unsafe Condition

(d) This AD results from a report that several passenger masks with broken in-line flow indicators were found following a mask deployment. We are issuing this AD to prevent the in-line flow indicators of the passenger oxygen masks from fracturing and separating, which could inhibit oxygen flow to the masks and consequently result in exposure of the passengers and cabin attendants to hypoxia following a depressurization event.

Compliance

(e) You are responsible for having the actions required by this

AD performed within the compliance times specified, unless the actions have already been done.

Inspection and Corrective/Other Specified Actions if Necessary

(f) Within 60 months after the effective date of this AD, do a general visual inspection to determine the manufacturer and manufacture date of the oxygen masks in the passenger service units and the lavatory and attendant box assemblies, and do the applicable corrective action, by accomplishing all of the applicable actions specified in the Accomplishment Instructions of Boeing Special

Attention Service Bulletin 757-35-0028, dated April 9, 2007; except where the service bulletin specifies repairing the oxygen mask assembly, replace it with a new or modified oxygen mask assembly having an improved flow indicator. The corrective action and other specified action must be done before further flight.

Note 1: The service bulletin refers to B/E Aerospace Service

Bulletin 174080-35-01, dated February 6, 2006; and Revision 1, dated

May 1, 2006; as additional sources of service information for modifying the oxygen mask assembly by replacing the flow indicator with an improved flow indicator.

Alternative Methods of Compliance (AMOCs)

(g)(1) The Manager, Seattle Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.

(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19.

Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA

Flight Standards District Office (FSDO), or lacking a PI, your local

FSDO.

Material Incorporated by Reference

(h) You must use Boeing Special Attention Service Bulletin 757- 35-0028, dated April 9, 2007, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5

U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact

Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207.

(3) You may review copies of the service information incorporated by reference at the FAA, Transport Airplane

Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the

National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_ regulations/ibr_locations.html.

Issued in Renton, Washington, on March 31, 2008.

Dionne Palermo,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

FR Doc. E8-7297 Filed 4-11-08; 8:45 am

BILLING CODE 4910-13-P