Airworthiness Directives; Bombardier, Inc. Airplanes

Federal Register, Volume 79 Issue 224 (Thursday, November 20, 2014)

Federal Register Volume 79, Number 224 (Thursday, November 20, 2014)

Rules and Regulations

Pages 69037-69039

From the Federal Register Online via the Government Printing Office www.gpo.gov

FR Doc No: 2014-26985

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

Docket No. FAA-2014-0489; Directorate Identifier 2014-NM-048-AD; Amendment 39-18022; AD 2014-23-06

RIN 2120-AA64

Airworthiness Directives; Bombardier, Inc. Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This AD was prompted by a report indicating that inboard and outboard hydraulic lines of the brakes were found connected to the incorrect ports on the swivel assembly of the main landing gear (MLG). This AD requires modifying the MLG by installing a new bracket on the left and right lower aft-wing planks. We are issuing this AD to prevent incorrect installation of the brake hydraulic lines, which could cause the brakes and the anti-skid system to operate incorrectly, and consequent catastrophic failure of the airplane during a high-speed rejected takeoff.

DATES: This AD becomes effective December 26, 2014.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of December 26, 2014.

ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov/#!docketDetail;D=FAA-2014-0489 or in person at the Docket Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC.

For service information identified in this AD, contact contact Bombardier, Inc., 400 Cocircte-Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

Page 69038

FOR FURTHER INFORMATION CONTACT: Fabio Buttitta, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7303; fax 516-794-5531.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. The NPRM published in the Federal Register on August 4, 2014 (79 FR 45135).

Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-

2014-10, dated February 12, 2014 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for certain Bombardier, Inc. Model CL-600-

2B19 (Regional Jet Series 100 & 440) airplanes. The MCAI states:

Cases of inboard and outboard hydraulic brake lines connected to the incorrect port of the swivel assembly on the main landing gear were found in service, including a runway overrun event. Cross-

connected brake hydraulic lines can cause the brakes and/or the anti-skid system to operate incorrectly. During a high speed rejected take-off, inability for the brakes to operate correctly could be catastrophic.

This Canadian AD mandates the modification to prevent inadvertent cross-connection of the inboard and outboard hydraulic brake lines.

The required action in this AD includes installing a new bracket on the left and right lower aft-wing planks of the MLG. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0489-0002.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (79 FR 45135, August 4, 2014) or on the determination of the cost to the public.

Conclusion

We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed, except for minor editorial changes. We have determined that these minor changes:

Are consistent with the intent that was proposed in the NPRM (79 FR 45135, August 4, 2014) for correcting the unsafe condition; and

Do not add any additional burden upon the public than was already proposed in the NPRM (79 FR 45135, August 4, 2014).

Costs of Compliance

We estimate that this AD affects 526 airplanes of U.S. registry.

We also estimate that it will take about 6 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts will cost about $375 per product. Based on these figures, we estimate the cost of this AD on U.S. operators to be $465,510, or $885 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

  1. Is not a ``significant regulatory action'' under Executive Order 12866;

  2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);

  3. Will not affect intrastate aviation in Alaska; and

  4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

    Examining the AD Docket

    You may examine the AD docket on the Internet at http://www.regulations.gov/#!docketDetail;D=FAA-2014-0489; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone 800-647-

    5527) is in the ADDRESSES section.

    List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

    Adoption of the Amendment

    Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

    PART 39--AIRWORTHINESS DIRECTIVES

    0

  5. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    Sec. 39.13 Amended

    0

  6. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):

    2014-23-06 Bombardier, Inc.: Amendment 39-18022. Docket No. FAA-

    2014-0489; Directorate Identifier 2014-NM-048-AD.

    (a) Effective Date

    This AD becomes effective December 26, 2014.

    (b) Affected ADs

    None.

    (c) Applicability

    This AD applies to Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes, certificated in any category, serial numbers 7003 and subsequent.

    (d) Subject

    Air Transport Association (ATA) of America Code 32, Landing Gear.

    (e) Reason

    This AD was prompted by a report indicating that inboard and outboard hydraulic lines of the brakes were found connected to the incorrect ports on the swivel assembly of the main landing gear (MLG). We are issuing this AD to prevent incorrect installation of the brake hydraulic lines, which could cause the brakes and the anti-skid system to operate incorrectly, and consequent catastrophic failure of the airplane during a high-speed rejected take-off.

    Page 69039

    (f) Compliance

    Comply with this AD within the compliance times specified, unless already done.

    (g) Modification

    Within 6,600 flight hours after the effective date of this AD, but no later than 36 months after the effective date of this AD: Modify the MLG by installing a new bracket on the left and right lower aft-wing planks, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 601R-32-110, dated December 19, 2013.

    (h) Other FAA AD Provisions

    The following provisions also apply to this AD:

    (1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the New York ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516 228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/

    certificate holding district office. The AMOC approval letter must specifically reference this AD.

    (2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO, ANE-170, Engine and Propeller Directorate, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.

    (i) Related Information

    (1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian Airworthiness Directive CF-2014-10, dated February 12, 2014, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0489-0002.

    (j) Material Incorporated by Reference

    (1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

    (2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.

    (i) Bombardier Service Bulletin 601R-32-110, dated December 19, 2013.

    (ii) Reserved.

    (3) For service information identified in this AD, contact Bombardier, Inc., 400 Cocircte-Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-

    7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com.

    (4) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

    (5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

    Issued in Renton, Washington, on November 5, 2014.

    Jeffrey E. Duven,

    Manager, Transport Airplane Directorate, Aircraft Certification Service.

    FR Doc. 2014-26985 Filed 11-19-14; 8:45 am

    BILLING CODE 4910-13-P

VLEX uses login cookies to provide you with a better browsing experience. If you click on 'Accept' or continue browsing this site we consider that you accept our cookie policy. ACCEPT