Airworthiness Directives; Bombardier, Inc. Airplanes
Federal Register, Volume 80 Issue 110 (Tuesday, June 9, 2015)
Federal Register Volume 80, Number 110 (Tuesday, June 9, 2015)
Rules and Regulations
Pages 32449-32451
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2015-11389
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2014-0754; Directorate Identifier 2014-NM-136-AD; Amendment 39-18156; AD 2015-10-01
RIN 2120-AA64
Airworthiness Directives; Bombardier, Inc. Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400 series airplanes. This AD was prompted by reports of hydraulic fluid loss from the reservoir of the main landing gear (MLG) alternate extension system. This AD requires inspection for correct assembly of the MLG alternate extension system reservoir lid, and corrective action if necessary. We are issuing this AD to, in the event of a failure of the primary MLG extension system, prevent failure of the alternate MLG extension system to fully extend the MLG into a down-and-locked position, which could result in collapse of both left-hand and right-hand MLG sides during touchdown.
DATES: This AD becomes effective July 14, 2015.
The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of July 14, 2015.
ADDRESSES: You may examine the AD docket on the Internet at http://www.regulations.gov/#!docketDetail;D=FAA-2014-0754; or in person at the Docket Management Facility, U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC.
For Bombardier service information identified in this AD, contact Bombardier, Inc., Q-Series Technical Help Desk, 123 Garratt Boulevard, Toronto, Ontario M3K 1Y5, Canada; telephone 416-375-4000; fax 416-375-
4539; email thd.qseries@aero.bombardier.com; Internet http://www.bombardier.com. For Parker service information identified in this AD, contact Parker Aerospace, 14300 Alton Parkway, Irvine, CA 92618; phone: 949-833-3000; Internet: http://www.parker.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. It is also available on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0754.
FOR FURTHER INFORMATION CONTACT: Fabio Buttitta, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7303; fax 516-794-5531.
SUPPLEMENTARY INFORMATION:
Discussion
We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to certain Bombardier, Inc. Model DHC-8-400 series airplanes. The NPRM published in the Federal Register on October 23, 2014 (79 FR 63341).
Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-
2014-15, dated June 6, 2014 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for certain Bombardier, Inc. Model DHC-8-400 series airplanes. The MCAI states:
Several cases have been reported of hydraulic fluid loss from the main landing gear (MLG) alternate extension system reservoir and in one case, the reservoir was found empty. The cause was determined to be an incorrectly assembled reservoir lid. In the event of a failed primary MLG extension system, an alternate MLG extension system with an empty reservoir may not be able to fully extend the MLG into the down and locked position, resulting in an unsafe landing configuration.
This Canadian AD mandates the general visual inspection of the MLG alternate extension system reservoir lid for correct assembly and the required rectification i.e., corrective action which consists of repairing the lid assembly.
You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0754-0002.
Comments
We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (79 FR 63341, October 23, 2014) or on the determination of the cost to the public.
Conclusion
We reviewed the relevant data and determined that air safety and the public interest require adopting this AD as proposed except for minor editorial changes. We have determined that these minor changes:
Are consistent with the intent that was proposed in the NPRM (79 FR 63341, October 23, 2014) for correcting the unsafe condition; and
Do not add any additional burden upon the public than was already proposed in the NPRM (79 FR 63341, October 23, 2014).
Related Service Information Under 1 CFR Part 51
Bombardier has issued Service Bulletin 84-29-34, dated May 9, 2013, with the attached Parker Service Bulletin 82910012-29-431, dated October 22, 2012. This service information describes procedures to inspect the lid assembly of the MLG alternate extension system reservoir for correct assembly and corrective actions. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of this AD.
Costs of Compliance
We estimate that this AD affects 173 airplanes of U.S. registry.
We also estimate that it will take about 4 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Based on these figures, we estimate the cost of this AD on U.S. operators to be $58,820, or $340 per product.
In addition, we estimate that any necessary follow-on actions will take
Page 32450
about 2 work-hours and require parts costing $0, for a cost of $170 per product. We have no way of determining the number of aircraft that might need this action.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
-
Is not a ``significant regulatory action'' under Executive Order 12866;
-
Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
-
Will not affect intrastate aviation in Alaska; and
-
Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov/#!docketDetail;D=FAA-2014-0754; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone 800-647-
5527) is in the ADDRESSES section.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
-
The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
2015-10-01 Bombardier, Inc.: Amendment 39-18156. Docket No. FAA-
2014-0754; Directorate Identifier 2014-NM-136-AD.
(a) Effective Date
This AD becomes effective July 14, 2015.
(b) Affected ADs
None.
(c) Applicability
This AD applies to Bombardier, Inc. Model DHC-8-401, -402, and -
403 airplanes, certificated in any category, serial numbers 4001 through 4424 inclusive.
(d) Subject
Air Transport Association (ATA) of America Code 29, Hydraulic Power.
(e) Reason
This AD was prompted by reports of hydraulic fluid loss from the reservoir of the main landing gear (MLG) alternate extension system. We are issuing this AD to, in the event of a failure of the primary MLG extension system, prevent failure of the alternate MLG extension system to fully extend the MLG into a down-and-locked position, which could result in collapse of both left-hand and right-hand MLG sides during touchdown.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Inspection and Corrective Action
Within 2,000 flight hours or 12 months after the effective date of this AD, whichever occurs first: Do a general visual inspection of the MLG alternate extension system reservoir lid for correct assembly, and do all applicable corrective actions, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 84-29-34, dated May 9, 2013, and with the attached Parker Service Bulletin 82910012-29-431, dated October 22, 2012, as referenced in Bombardier Service Bulletin 84-29-34, dated May 9, 2013. Do all applicable corrective actions within 2,000 flight hours or 12 months after the effective date of this AD, whichever occurs first.
(h) Credit for Previous Actions
This paragraph provides credit for actions required by paragraph (g) of this AD, if those actions were performed before the effective date of this AD using Bombardier All Operator Message 543, dated October 17, 2012, which is not incorporated by reference in this AD.
(i) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO, ANE-170, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.
(j) Related Information
(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian Airworthiness Directive CF-2014-15, dated June 6, 2014, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov/#!documentDetail;D=FAA-2014-0754-0002.
(2) Service information identified in this AD that is not incorporated by reference is available at the addresses specified in paragraphs (k)(3) and (k)(5) of this AD.
(k) Material Incorporated by Reference
(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Bombardier Service Bulletin 84-29-34, dated May 9, 2013.
(ii) Parker Service Bulletin 82910012-29-431, dated October 22, 2012.
Page 32451
(3) For Bombardier service information identified in this AD, contact Bombardier, Inc., Q-Series Technical Help Desk, 123 Garratt Boulevard, Toronto, Ontario M3K 1Y5, Canada; telephone 416-375-4000; fax 416-375-4539; email thd.qseries@aero.bombardier.com; Internet http://www.bombardier.com.
(4) For Parker service information identified in this AD, contact Parker Aerospace, 14300 Alton Parkway, Irvine, CA, 92618; phone: 949-833-3000; Internet: http://www.parker.com.
(5) You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
(6) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.
Issued in Renton, Washington, on May 1, 2015.
Jeffrey E. Duven,
Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2015-11389 Filed 6-8-15; 8:45 am
BILLING CODE 4910-13-P
