Airworthiness Directives; Bombardier, Inc. Airplanes
Federal Register, Volume 81 Issue 145 (Thursday, July 28, 2016)
Federal Register Volume 81, Number 145 (Thursday, July 28, 2016)
Proposed Rules
Pages 49577-49579
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2016-17717
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2016-8180; Directorate Identifier 2016-NM-083-AD
RIN 2120-AA64
Airworthiness Directives; Bombardier, Inc. Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes, Model CL-600-2D15 (Regional Jet Series 705) airplanes, Model CL-600-2D24 (Regional Jet Series 900) airplanes, and Model CL-600-2E25 (Regional Jet Series 1000) airplanes. This proposed AD was prompted by a determination that the protective polyurethane tapes applied to the upper surfaces of the aluminum and titanium floor structural members may not be trimmed properly, and on some places may overhang the profiles of the floor structural parts. Subsequent tests revealed that the overhanging pieces of tapes that are not bonded to the structure do not meet the flammability requirements and may allow fire propagation below the floor structure. This proposed AD would require an inspection of the polyurethane protective tapes installed on the floor structure for excess tape or incorrect tape installation, and corrective actions if necessary. We are proposing this AD to detect and correct overhanging pieces of protective polyurethane tapes, which are not bonded to the structure and do not meet the flammability requirements; this condition may allow fire propagation below the floor structure.
DATES: We must receive comments on this proposed AD by September 12, 2016.
ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
Page 49578
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this NPRM, contact Bombardier, Inc., 400 Cocircte-Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
8180; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Fabio Buttitta, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7303; fax 516-794-5531.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2016-8180; Directorate Identifier 2016-NM-083-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-
2016-14, dated May 18, 2016 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for certain Bombardier, Inc. Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes, Model CL-600-2D15 (Regional Jet Series 705) airplanes, Model CL-600-2D24 (Regional Jet Series 900) airplanes, and Model CL-600-2E25 (Regional Jet Series 1000) airplanes. The MCAI states:
An inspection revealed that the protective polyurethane tapes applied to the upper surfaces of the aluminum and titanium floor structural members installed on CRJ 700/900/1000 aeroplanes may not be trimmed properly and on some places may overhang the profiles of the floor structural parts. Subsequent tests revealed that the overhanging pieces of tapes which are not bonded to the structure, do not meet the flammability requirements. If not corrected, this condition may allow fire propagation below the floor structure.
This Canadian AD was issued to mandate the detailed inspection and removal of any excessive pieces of overhanging tape or replacing incorrectly installed tape found on the floor structure.
You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
8180.
Related Service Information Under 1 CFR Part 51
Bombardier has issued Service Bulletin 670BA-53-055, dated December 3, 2015. The service information describes procedures for inspecting the polyurethane protective tapes for any excess tape or incorrect tape installation on the floor structure and corrective actions, which include removing any excess tape or replacing any incorrect tape installation found. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of these same type designs.
Costs of Compliance
We estimate that this proposed AD affects 569 airplanes of U.S. registry.
We estimate the following costs to comply with this proposed AD:
Estimated Costs
--------------------------------------------------------------------------------------------------------------------------------------------------------
Cost per Cost on U.S.
Action Labor cost Parts cost product operators
--------------------------------------------------------------------------------------------------------------------------------------------------------
Inspection and repair........................... 190 work-hours x $85 per hour = $16,150............ $0 $16,150 $9,189,350
--------------------------------------------------------------------------------------------------------------------------------------------------------
The repair is done at the same time as the inspection. Therefore, we have not specified separate on-condition repair costs.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with
Page 49579
promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
Bombardier, Inc.: Docket No. FAA-2016-8180; Directorate Identifier 2016-NM-083-AD.
(a) Comments Due Date
We must receive comments by September 12, 2016.
(b) Affected ADs
None.
(c) Applicability
This AD applies to the Bombardier, Inc. airplanes identified in paragraphs (c)(1), (c)(2), and (c)(3) of this AD, certificated in any category.
(1) Model CL-600-2C10 (Regional Jet Series 700, 701, & 702) airplanes, serial numbers 10002 through 10342 inclusive.
(2) Model CL-600-2D15 (Regional Jet Series 705) airplanes and Model CL-600-2D24 (Regional Jet Series 900) airplanes, serial numbers 15001 through 15347 inclusive.
(3) Model CL-600-2E25 (Regional Jet Series 1000) airplanes, serial numbers 19001 through 19040 inclusive.
(d) Subject
Air Transport Association (ATA) of America Code 53, Fuselage.
(e) Reason
This AD was prompted by a determination that the protective polyurethane tapes applied to the upper surfaces of the aluminum and titanium floor structural members may not be trimmed properly, and on some places may overhang the profiles of the floor structural parts. Subsequent tests revealed that the overhanging pieces of tapes that are not bonded to the structure do not meet the flammability requirements and may allow fire propagation below the floor structure. We are issuing this AD to detect and correct overhanging pieces of protective polyurethane tapes, which are not bonded to the structure and do not meet the flammability requirements; this condition may allow fire propagation below the floor structure.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Inspection and Corrective Actions
Within 12,600 flight hours after the effective date of this AD: Do a detailed visual inspection for excess tape or incorrect tape installation of the polyurethane protective tapes installed between floor panels and floor structure between fuselage station (FS) 280.00 and FS969.00; and do all applicable corrective actions; in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 670BA-53-055, dated December 3, 2015, except as specified in paragraph (h) of this AD. Do all applicable corrective actions before further flight.
(h) Exception to Service Information
Where Bombardier Service Bulletin 670BA-53-055, dated December 3, 2015, specifies to contact Bombardier, Inc., to ``get an approved disposition to complete this service bulletin,'' before further flight, repair using a method approved by the Manager, New York ACO, ANE-170, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO).
(i) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO, ANE-170, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO). If approved by the DAO, the approval must include the DAO-authorized signature.
(j) Related Information
(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian Airworthiness Directive CF-2016-14, dated May 18, 2016, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-8180.
(2) For service information identified in this AD, contact Bombardier, Inc., 400 Cocircte-Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-
7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com. You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
Issued in Renton, Washington, on July 21, 2016.
Michael Kaszycki,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2016-17717 Filed 7-27-16; 8:45 am
BILLING CODE 4910-13-P
