Airworthiness directives: McDonnell Douglas,

[Federal Register: April 14, 2000 (Volume 65, Number 73)]

[Rules and Regulations]

[Page 20319-20321]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr14ap00-18]

[[Page 20319]]

Part V

Department of Transportation

Federal Aviation Administration

14 CFR Part 39

Airworthiness Directives; McDonnell Douglas Model MD-11; AD 2000-07-14, et al.; Final Rules

[[Page 20320]]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-NM-263-AD; Amendment 39-11668; AD 2000-07-14]

RIN 2120-AA64

Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to certain McDonnell Douglas Model MD-11 series airplanes, that requires a one-time detailed visual inspection of a certain passenger seat wire assembly to detect chafed or damaged wires; repair, if necessary; and installation of protective sleeving. This amendment is prompted by a report of arcing emanating from a certain passenger seat wire assembly. The actions specified by this AD are intended to prevent chafing of the passenger seat wire assembly against a bracket at the lower sidewall panel due to insufficient clearance between the bracket and seat wire assembly, which could result in arcing damage to the passenger seat wire assembly and consequent smoke and fire in the main cabin.

DATES: Effective May 19, 2000.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of May 19, 2000.

ADDRESSES: The service information referenced in this AD may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Technical Publications Business Administration, Dept. C1-L51 (2-60). This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Transport Airplane Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Brett Portwood, Aerospace Engineer, Systems and Equipment Branch, ANM-130L, FAA, Transport Airplane Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5350; fax (562) 627-5210.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model MD-11 series airplanes was published in the Federal Register on February 1, 2000 (65 FR 4781). That action proposed to require a one- time detailed visual inspection of a certain passenger seat wire assembly to detect chafed or damaged wires; repair, if necessary; and installation of protective sleeving.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. Due consideration has been given to the single comment received.

The commenter supports the proposed rule.

Conclusion

After careful review of the available data, including the comment noted above, the FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact

There are approximately 128 airplanes of the affected design in the worldwide fleet. The FAA estimates that 32 airplanes of U.S. registry will be affected by this AD.

It will take approximately 2 work hours per airplane to accomplish the required inspection, at an average labor rate of $60 per work hour. Based on these figures, the cost impact of the inspection required by this AD on U.S. operators is estimated to be $3,840, or $120 per airplane.

It will take approximately 2 work hours per airplane to accomplish the required installation of protective sleeving, at an average labor rate of $60 per work hour. Based on these figures, the cost impact of the installation required by this AD on U.S. operators is estimated to be $3,840, or $120 per airplane.

The cost impact figures discussed above are based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

  1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.

    Sec. 39.13 [Amended]

  2. Section 39.13 is amended by adding the following new airworthiness directive:

    2000-07-14 McDonnell Douglas: Amendment 39-11668. Docket 99-NM-263- AD.

    Applicability: Model MD-11 series airplanes, as listed in McDonnell Douglas Alert Service Bulletin MD11-24A152, dated August 9, 1999; certificated in any category.

    Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an

    [[Page 20321]]

    alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

    Compliance: Required as indicated, unless accomplished previously.

    To prevent chafing of the passenger seat wire assembly against a bracket at the lower sidewall panel due to insufficient clearance between the bracket and seat wire assembly, which could result in arcing damage to the passenger seat wire assembly and consequent smoke and fire in the main cabin, accomplish the following:

    Inspection, Installation, and Repair, If Necessary

    (a) Within 6 months after the effective date of this AD, perform a detailed visual inspection of the passenger seat wire assembly to detect chafed or damaged wires, and install protective sleeving, in accordance with McDonnell Douglas Alert Service Bulletin MD11- 24A152, dated August 9, 1999. If any chafed or damaged wire is found, prior to further flight, repair in accordance with the service bulletin.

    Note 2: For the purposes of this AD, a detailed visual inspection is defined as: ``An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.''

    Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO.

    Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.

    Special Flight Permits

    (c) Special flight permits may be issued in accordance with Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

    Incorporation by Reference

    (d) The actions shall be done in accordance with McDonnell Douglas Alert Service Bulletin MD11-24A152, dated August 9, 1999. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Technical Publications Business Administration, Dept. C1-L51 (2-60). Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Transport Airplane Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register 800 North Capitol Street, NW., suite 700, Washington, DC.

    (e) This amendment becomes effective on May 19, 2000.

    Issued in Renton, Washington, on April 4, 2000. Donald L. Riggin, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

    [FR Doc. 00-8810Filed4-13-00; 8:45 am]

    BILLING CODE 4910-13-P

VLEX uses login cookies to provide you with a better browsing experience. If you click on 'Accept' or continue browsing this site we consider that you accept our cookie policy. ACCEPT