Airworthiness directives: Saab,
[Federal Register: March 5, 2004 (Volume 69, Number 44)]
[Proposed Rules]
[Page 10370-10372]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr05mr04-25]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
[Docket No. 2002-NM-259-AD]
RIN 2120-AA64
Airworthiness Directives; Saab Model SAAB 2000 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Notice of proposed rulemaking (NPRM).
SUMMARY: This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain Saab Model SAAB 2000 series airplanes. This proposal would require an inspection of roll and pitch disconnect handles for spring forces outside limits, and adjustment of the spring force of the handles, if necessary. This action is necessary to prevent the roll and pitch disconnect handles from being difficult to operate, which could result in an increase in pilot workload and subsequent reduced controllability of the airplane. This action is intended to address the identified unsafe condition.
DATES: Comments must be received by April 5, 2004.
ADDRESSES: Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2002-NM-259-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: 9-anm-nprmcomment@faa.gov. Comments sent via fax or the Internet must
contain ``Docket No. 2002-NM-259-AD'' in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.
The service information referenced in the proposed rule may be obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S- 581.88, Link[ouml]ping, Sweden. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington.
FOR FURTHER INFORMATION CONTACT: Rosanne Ryburn, Aerospace Engineer,
[[Page 10371]]
International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2139; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.
Submit comments using the following format:
Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
For each issue, state what specific change to the proposed AD is being requested.
Include justification (e.g., reasons or data) for each request.
Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: ``Comments to Docket Number 2002-NM-259-AD.'' The postcard will be date stamped and returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2002-NM-259-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.
Discussion
The Luftfartsverket (LFV), which is the airworthiness authority for Sweden, notified the FAA that an unsafe condition may exist on certain Saab Model SAAB 2000 series airplanes. The LFV advises that there have been two instances during C-checks in which the roll and pitch disconnect handles were difficult to operate. An abnormal force is needed to pull the handles. This condition, if not corrected, could result in an increase in pilot workload and subsequent reduced controllability of the airplane.
Explanation of Relevant Service Information
Saab has issued Service Bulletin 2000-27-047, dated August 30, 2002, which describes procedures for inspection of the roll and pitch disconnect handles for difficult operation, and adjustment of the handles, if necessary. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition. The LFV classified this service bulletin as mandatory and issued Swedish airworthiness directive 1-177, dated August 30, 2002, in order to assure the continued airworthiness of these airplanes in Sweden.
FAA's Conclusions
This airplane model is manufactured in Sweden and is type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, the LFV has kept the FAA informed of the situation described above. The FAA has examined the findings of the LFV, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.
Explanation of Requirements of Proposed Rule
Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.
Cost Impact
The FAA estimates that 3 airplanes of U.S. registry would be affected by this proposed AD, that it would take approximately 4 work hours per airplane to accomplish the proposed inspection, and that the average labor rate is $65 per work hour. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $780, or $260 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
Regulatory Impact
The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this proposed regulation (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
[[Page 10372]]
Sec. 39.13 [Amended]
-
Section 39.13 is amended by adding the following new airworthiness directive:
SAAB Aircraft AB: Docket 2002-NM-259-AD.
Applicability: Model SAAB 2000 series airplanes, serial numbers -004 through -063 inclusive; certificated in any category.
Compliance: Required as indicated, unless accomplished previously.
To prevent the roll and pitch disconnect handles from being difficult to operate, which could result in an increase in pilot workload and subsequent reduced controllability of the airplane, accomplish the following:
Inspection and Modification
(a) Within 400 flight hours after the effective date of this AD, perform an inspection of the roll and pitch disconnect handles for difficult operation, in accordance with the Accomplishment Instructions of Saab Service Bulletin 2000-27-047, dated August 30, 2002. If the force required to move any disconnect handle is found to be outside the limits specified in the service bulletin, before further flight, adjust the spring force of the handle in accordance with the Accomplishment Instructions of the service bulletin.
Parts Installation
(b) As of the effective date of this AD, no person may install on any airplane a roll disconnect handle, part number 7339056-503, or pitch disconnect handle, part number 7339056-504, unless it has been inspected and the spring force has been adjusted as applicable, per paragraph (a) of this AD.
Alternative Methods of Compliance
(c) In accordance with 14 CFR 39.19, the Manager, International Branch, ANM-116, FAA, is authorized to approve alternative methods of compliance (AMOCs) for this AD.
Note 1: The subject of this AD is addressed in Swedish airworthiness directive 1-177, dated August 30, 2002.
Issued in Renton, Washington, on February 25, 2004. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 04-4925 Filed 3-4-04; 8:45 am]
BILLING CODE 4910-13-P
