Airworthiness standards: Special conditions— Jetcruzer model 500 airplane,

[Federal Register: February 10, 1999 (Volume 64, Number 27)]

[Rules and Regulations]

[Page 6510-6512]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr10fe99-5]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 23

[Docket No. CE151, Special Condition 23-095-SC]

Special Conditions; Jetcruzer Model 500 Airplane

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final special conditions; request for comments.

SUMMARY: These special conditions are issued to Advanced Aerodynamics & Structures, Incorporated (AASI), 3501 Lakewood Blvd., Long Beach Airport, California 90808, for an Amended Type Certificate for the Jetcruzer Model 500 airplane. This airplane will have novel and unusual design features when compared to the state of technology envisaged in the applicable airworthiness standards. These novel and unusual design features include the installation of electronic flight instrument system (EFIS) displays for which the applicable regulations do not contain adequate or appropriate airworthiness standards for the protection of these systems from the effects of high intensity radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to the airworthiness standards applicable to these airplanes.

EFFECTIVE DATE: The effective date of these special conditions is January 29, 1999.

Comments must be received on or before March 12, 1998.

ADDRESSES: Comments may be mailed in duplicate to: Federal Aviation Administration, Regional Counsel, ACE-7, Attention: Rules Docket Clerk, Docket No. CE151, Room 1558, 601 East 12th Street, Kansas City, Missouri 64106. All comments must be marked: Docket No. CE151. Comments may be inspected in the Rules Docket weekdays, except Federal holidays, between 7:30 a.m. and 4:00 p.m.

FOR FURTHER INFORMATION CONTACT: Ervin Dvorak, Aerospace Engineer, Standards Office (ACE-110), Small Airplane Directorate, Aircraft Certification Service, Federal Aviation Administration, 601 East 12th Street, Kansas City, Missouri 64106; telephone (816) 426-6941.

SUPPLEMENTARY INFORMATION: The FAA has determined that notice and opportunity for prior public comment hereon are impracticable because these procedures would significantly delay insurance of the approval design and thus delivery of the affected aircraft. In addition, the substance of these special conditions has been subject to the public comment process in several prior instances with no substantive comments received. The FAA, therefore, finds that good cause exists for making these special conditions effective upon issuance.

Comments Invited

Interested persons are invited to submit such written data, views, or arguments as they may desire. Communications should identify the regulatory docket or notice number and be submitted in duplicate to the address specified above. All communications received on or before the closing date for comments will be considered by the Administrator. The special conditions may be changed in light of the comments received. All comments received will be available in the Rules Docket for examination by interested persons, both before and after the closing date for comments. A report summarizing each substantive public contact with FAA personnel concerning this rulemaking will be filedin the docket. Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this notice must include a self- addressed, stamped postcard on which the following statement is made: ``Comments to CE151.'' The postcard will be date stamped and returned to the commenter.

Background

On October 7, 1996, Advanced Aerodynamics & Structures, Incorporated, 3501 Lakewood Blvd., Long Beach Airport, CA 90808, made an

[[Page 6511]]

application to the FAA for an Amendment to Type Certificate No. A49NM to include the Jetcruzer Model 500 airplane. The Jetcruzer model 500 is a derivative of the Model 450 currently approved under TC No. A49NM. The proposed modification incorporates a novel or unusual design feature, such as digital avionics consisting of an EFIS, that is vulnerable to HIRF external to the airplane.

Type Certification Basis

Under the provisions of 14 CFR part 21, Sec. 21.101, Advanced Aerodynamics & Structures, Incorporated must show that the Jetcruzer Model 500 meets the regulations incorporated by reference in TC No. A49NM, which are the following provisions, or the applicable regulations in effect on the date of application for the change to the Jetcruzer Model 500:

Federal Aviation Regulations part 23 effective February 1, 1965, as amended by Amendments 23-1 through 23-52; Federal Aviation Regulations part 34 effective September 10, 1990, as amended by the amendment in effect on the date of certification; Federal Aviation Regulations part 36 effective December 1, 1969, as amended by amendment 36-1 through the amendment in effect on the day of certification; The Noise Control Act of 1972; exemptions, if any; and the special conditions adopted by this rulemaking action.

Discussion

If the Administrator finds that the applicable airworthiness standards do not contain adequate or appropriate safety standards because of novel or unusual design features of an airplane, special conditions are prescribed under the provisions of Sec. 21.16 to establish a level of safety equivalent to that established in the regulations.

Special conditions are normally issued in accordance with Sec. 11.49, after public notice, as required by Secs. 11.28 and 11.29(b), effective October 14, 1980, and become a part of the type certification basis in accordance with Sec. 21.191(b)(2).

Special conditions are initially applicable to the model for which they are issued. Should the type certificate for that model be amended later to include any other model that incorporates the same novel or unusual design feature, or should any other model already included on the same type certificate be modified to incorporate the same novel or unusual design feature, the special conditions would also apply to the other model under the provisions of Sec. 21.101(a)(1).

Novel or Unusual Design Features

Advanced Aerodynamics & Structures, Incorporated plans to incorporate certain novel and unusual design features into an airplane for which the airworthiness standards do not contain adequate or appropriate safety standards for protection from the effects of HIRF. These features include EFIS, which are susceptible to the HIRF environment, that were not envisaged by the existing regulations for this type of airplane.

Protection of Systems From High Intensity Radiated Fields (HIRF)

Recent advances in technology have given rise to the application in aircraft designs of advanced electrical and electronic systems that perform functions required for continued safe flight and landing. Due to the use of sensitive solid state advanced components in analog and digital electronics circuits, these advanced systems are readily responsive to the transient effects of induced electrical current and voltage caused by the HIRF. The HIRF can degrade electronic systems performance by damaging components or upsetting system functions.

Furthermore, the HIRF environment has undergone a transformation that was not foreseen when the current requirements were developed. Higher energy levels are radiated from transmitters that are used for radar, radio, and television. Also, the number of transmitters has increased significantly. There is also uncertainty concerning the effectiveness of airframe shielding for HIRF. Furthermore, coupling to cockpit-installed equipment through the cockpit window apertures is undefined.

The combined effect of the technological advances in airplane design and the changing environment has resulted in an increased level of vulnerability of electrical and electronic systems required for the continued safe flight and landing of the airplane. Effective measures against the effects of exposure to HIRF must be provided by the design and installation of these systems. The accepted maximum energy levels in which civilian airplane systems installations must be capable of operating safely are based on surveys and analysis of existing radio frequency emitters. These special conditions require that the airplane be evaluated under these energy levels for the protection of the electronic system and its associated wiring harness. These external threat levels, which are lower than previous required values, are believed to represent the worst case to which an airplane would be exposed in the operating environment.

These special conditions require qualification of systems that perform critical functions, as installed in aircraft, to the defined HIRF environment in paragraph 1 or, as an option to a fixed value using laboratory tests, in paragraph 2, as follows:

(1) The applicant may demonstrate that the operation and operational capability of the installed electrical and electronic systems that perform critical functions are not adversely affected when the aircraft is exposed to the HIRF environment defined below:

Field strength (volts per meter) Frequency

--------------------- Peak Average

10 kHz-100 kHz....................................

50

50 100 kHz-500 kHz...................................

50

50 500 kHz-2 MHz.....................................

50

50 2 MHz-30 MHz......................................

100

100 30 MHz-70 MHz.....................................

50

50 70 MHz-100 MHz....................................

50

50 100 MHz-200 MHz...................................

100

100 200 MHz-400 MHz...................................

100

100 400 MHz-700 MHz...................................

700

50 700 MHz-1 GHz.....................................

700

100 1 GHz-2 GHz....................................... 2000

200 2 GHz-4 GHz....................................... 3000

200 4 GHz-6 GHz....................................... 3000

200 6 GHz-8 GHz....................................... 1000

200 8 GHz-12 GHz...................................... 3000

300 12 GHz-18 GHz..................................... 2000

200 18 GHz-40 GHz.....................................

600

200

The field strengths are expressed in terms of peak root-mean-square (rms) values.

or,

(2) The applicant may demonstrate by a system test and analysis that the electrical and electronic systems that perform critical functions can withstand a minimum threat of 100 volts per meter, peak electrical field strength, from 10 KHz to 18 GHz. When using this test to show compliance with the HIRF requirements, no credit is given for signal attenuation due to installation.

A preliminary hazard analysis must be performed by the applicant, for approval by the FAA, to identify electrical and/or electronic systems that perform critical functions. The term ``critical'' means those functions whose failure would contribute to, or cause, a failure condition that would prevent the continued safe flight and landing of the airplane. The systems identified by the hazard analysis that perform critical functions are candidates for the application of HIRF requirements. A system may perform both critical and non-critical functions. Primary electronic flight display systems, and

[[Page 6512]]

their associated components, perform critical functions such as attitude, altitude, and airspeed indication. The HIRF requirements apply only to critical functions.

Compliance with HIRF requirements may be demonstrated by tests, analysis, models, similarity with existing systems, or any combination of these. Service experience alone is not acceptable since normal flight operations may not include an exposure to the HIRF environment. Reliance on a system with similar design features for redundancy as a means of protection against the effects of external HIRF is generally insufficient since all elements of a redundant system are likely to be exposed to the fields concurrently.

Applicability

As discussed above, these special conditions are applicable to the Advanced Aerodynamics & Structures, Incorporated Jetcruzer Model 500. Should Advanced Aerodynamics & Structures, Incorporated apply at a later date for a change to the type certificate to include any other model incorporating the same novel or unusual design feature, the special conditions would apply to that model as well under the provisions of Sec. 21.101(a)(1).

Conclusion

This action affects only certain novel or unusual design features on one model of airplane. It is not a rule of general applicability and affects only the applicant who applied to the FAA for approval of these features on the airplane.

The substance of these special conditions has been subjected to the notice and comment period in several prior instances and has been derived without substantive change from those previously issued. It is unlikely that prior public comment would result in a significant change from the substance contained herein. For this reason, and because a delay would significantly affect the certification of the airplane, which is imminent, the FAA has determined that prior public notice and comment are unnecessary and impracticable, and good cause exists for adopting these special conditions upon issuance. The FAA is requesting comments to allow interested persons to submit views that may not have been submitted in response to the prior opportunities for comment described above.

List of Subjects in 14 CFR Part 23

Aircraft, Aviation safety, Signs and symbols.

Citation

The authority citation for these special conditions is as follows:

Authority: 49 U.S.C. 106(g), 40113 and 44701, 14 CFR part 21, Secs. 21.16 and 21.17, and 14 CFR part 11, Secs. 11.28 and 11.49.

The Special Conditions

Accordingly, pursuant to the authority delegated to me by the Administrator, the following special conditions are issued as part of the type certification basis for the Advanced Aerodynamics & Structures, Incorporated Jetcruzer Model 500 airplane:

  1. Protection of Electrical and Electronic Systems from High Intensity Radiated Fields (HIRF). Each system that performs critical functions must be designed and installed to ensure that the operations, and operational capabilities of these systems to perform critical functions, are not adversely affected when the airplane is exposed to high intensity radiated electromagnetic fields external to the airplane.

  2. For the purpose of these special conditions, the following definition applies: Critical Functions: Functions whose failure would contribute to, or cause, a failure condition that would prevent the continued safe flight and landing of the airplane.

Issued in Kansas City, Missouri on January 29, 1999. Michael Gallagher, Manager, Small Airplane Directorate, Aircraft Certification Service.

[FR Doc. 99-3290Filed2-9-99; 8:45 am]

BILLING CODE 4910-13-M

VLEX uses login cookies to provide you with a better browsing experience. If you click on 'Accept' or continue browsing this site we consider that you accept our cookie policy. ACCEPT