Airworthiness Directives; DASSAULT AVIATION Airplanes
Federal Register, Volume 78 Issue 24 (Tuesday, February 5, 2013)
Federal Register Volume 78, Number 24 (Tuesday, February 5, 2013)
Proposed Rules
Pages 8052-8054
From the Federal Register Online via the Government Printing Office www.gpo.gov
FR Doc No: 2013-02450
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2012-1322; Directorate Identifier 2012-NM-155-AD
RIN 2120-AA64
Airworthiness Directives; DASSAULT AVIATION Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for certain DASSAULT AVIATION Model MYSTERE-FALCON 900 and FALCON 900EX airplanes. This proposed AD was prompted by reports of chafing between the tail strobe power supply and a hydraulic line. This proposed AD would require modifying the tail strobe power supply wire routing. We are proposing this AD to prevent chafing between the tail strobe power supply and a hydraulic line, which could result in hydraulic fluid leakage and possible fire due to arcing, and consequent loss of control of the airplane due to structural failure of the tail.
DATES: We must receive comments on this proposed AD by March 22, 2013.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, NJ 07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-
227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No.
Page 8053
FAA-2012-1322; Directorate Identifier 2012-NM-155-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2012-0162, dated August 29, 2012 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for the specified products. The MCAI states:
Two reports were received concerning Falcon 900 aeroplanes, where chafing between the tail strobe power supply and a hydraulic line was found. In the latest reported occurrence, the chafing damaged the power line and created an electrical arcing which created a pin hole in the hydraulic line, leading to hydraulic fluid leakage.
This condition, if not corrected, could jeopardize the aeroplane's safe flight.
To address this potential unsafe condition, Dassault Aviation developed modification (M5741) of the routing of the tail strobe power supply wire, which is available for accomplishment in service through Dassault Service Bulletin (SB) F900-431 or SB F900EX-437, as applicable to aeroplane model.
For the reasons described above, this EASA AD requires modification of the routing of the tail strobe power supply wire.
The unsafe condition is chafing between the tail strobe power supply and a hydraulic line, which could result in hydraulic fluid leakage and possible fire due to arcing, and consequent loss of control of the airplane due to structural failure of the tail. You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information
Dassault has issued Mandatory Service Bulletin F900-431, dated November 8, 2011 (for Model MYSTERE-FALCON 900 airplanes); and Mandatory Service Bulletin F900EX-437, dated November 8, 2011 (for Model FALCON 900EX airplanes). The actions described in these service bulletins are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance
Based on the service information, we estimate that this proposed AD would affect about 180 products of U.S. registry. We also estimate that it would take about 2 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $31 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $36,180, or $201 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
-
Is not a ``significant regulatory action'' under Executive Order 12866;
-
Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
-
Will not affect intrastate aviation in Alaska; and
-
Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
-
The FAA amends Sec. 39.13 by adding the following new AD:
DASSAULT AVIATION: Docket No. FAA-2012-1322; Directorate Identifier 2012-NM-155-AD.
(a) Comments Due Date
We must receive comments by March 22, 2013.
(b) Affected ADs
None.
(c) Applicability
This AD applies to the airplanes specified in paragraphs (c)(1) and (c)(2) of this AD, certificated in any category.
(1) DASSAULT AVIATION Model MYSTERE-FALCON 900 airplanes, serial numbers (S/N) 142 and subsequent.
(2) DASSAULT AVIATION Model FALCON 900EX airplanes, all serial numbers
Page 8054
except those on which Dassault Aviation modification M5741 has been embodied in production.
(d) Subject
Air Transport Association (ATA) of America Code 24, Electrical Power.
(e) Reason
This AD was prompted by reports of chafing between the tail strobe power supply and a hydraulic line. We are issuing this AD to prevent chafing between the tail strobe power supply and a hydraulic line, which could result in hydraulic fluid leakage and possible fire due to arcing, and consequent loss of control of the airplane due to structural failure of the tail.
(f) Compliance
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Actions
Within 65 days or 200 flight hours after the effective date of this AD, whichever occurs first: Modify the tail strobe power supply wire routing, in accordance with the Accomplishment Instructions of Dassault Mandatory Service Bulletin F900-431, dated November 8, 2011 (for Model MYSTERE-FALCON 900 airplanes); or Dassault Mandatory Service Bulletin F900EX-437, dated November 8, 2011 (for FALCON 900EX airplanes).
(h) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(i) Related Information
(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) European Aviation Safety Agency Airworthiness Directive 2012-
0162, dated August 29, 2012, and the service information specified in paragraphs (j)(1)(i) and (j)(1)(ii) of this AD, for related information.
(i) Dassault Mandatory Service Bulletin F900-431, dated November 8, 2011.
(ii) Dassault Mandatory Service Bulletin F900EX-437, dated November 8, 2011.
(2) For service information identified in this AD, contact Dassault Falcon Jet, P.O. Box 2000, South Hackensack, NJ 07606; telephone 201-440-6700; Internet http://www.dassaultfalcon.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
Issued in Renton, Washington, on January 28, 2013.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2013-02450 Filed 2-4-13; 8:45 am
BILLING CODE 4910-13-P
