Airworthiness Directives: Air Tractor, Inc. Models AT 200, AT 300, AT 400 etc.

Federal Register: December 24, 2008 (Volume 73, Number 248)

Rules and Regulations

Page 78944-78946

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

DOCID:fr24de08-9

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration 14 CFR Part 39

Docket No. FAA-2008-1120; Directorate Identifier 2008-CE-064-AD;

Amendment 39-15767; AD 2008-26-01

RIN 2120-AA64

Airworthiness Directives; Air Tractor, Inc. Models AT-200, AT- 300, AT-400, AT-500, AT-600, and AT-800 Series Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of

Transportation (DOT).

ACTION: Final rule.

SUMMARY: We are adopting a new airworthiness directive (AD) to supersede AD 2008-11-17, which applies to certain Air Tractor, Inc.

Models AT-200, AT-300, AT-400, AT-500, AT-600, and AT-800 series airplanes. AD 2008-11-17 currently requires you to install an overturn skid plate kit or a modification to the overturn skid plate already installed. Since we issued AD 2008-11-17, the manufacturer has notified us that Model AT-401B airplanes also need a modification to the overturn skid plate. Consequently, this AD would retain the actions of

AD 2008-11-17 and add the requirement to modify the overturn skid plate installed on Model AT-401B airplanes. We are issuing this AD to prevent the front and rear connections of the overturn skid plate to the airplane from breaking, which could allow foreign debris to enter the cockpit during an airplane overturn. This condition, if not corrected, could lead to pilot injury.

DATES: This AD becomes effective on January 28, 2009.

On January 28, 2009, the Director of the Federal Register approved the incorporation by reference of Snow Engineering Co. Service Letter 97, revised September 19, 2008, listed in this AD.

As of July 7, 2008 (73 FR 31351, June 2, 2008), the Director of the

Federal Register approved the incorporation by reference of Snow

Engineering Co. Service Letter 97, revised November 7, 2007, listed in this AD.

ADDRESSES: For service information identified in this AD, contact Air

Tractor Inc., P.O. Box 485, Olney, Texas 76374; telephone: (940) 564- 5616; fax: (940) 564-5612; e-mail: airmail@airtractor.com; Internet: http://www.airtractor.com.

To view the AD docket, go to U.S. Department of Transportation,

Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200

New Jersey Avenue, SE., Washington, DC 20590, or on the Internet at http://www.regulations.gov. The docket number is FAA-2008-1120;

Directorate Identifier 2008-CE-064-AD.

FOR FURTHER INFORMATION CONTACT: Andy McAnaul, Aerospace Engineer, ASW- 150, FAA San Antonio MIDO-43, 10100 Reunion Pl., Ste. 650, San Antonio,

Texas 78216; telephone: (210) 308-3365; fax: (210) 308-3370.

SUPPLEMENTARY INFORMATION:

Discussion

On October 14, 2008, we issued a proposal to amend part 39 of the

Federal Aviation Regulations (14 CFR part 39) to include an AD that would apply to certain Air Tractor, Inc. Models AT-200, AT-300, AT-400,

AT-500, AT-600, and AT-800 series airplanes. This proposal was published in the Federal Register as a notice of proposed rulemaking

(NPRM) on October 23, 2008 (73 FR 63096). The NPRM proposed to supersede AD 2008-11-17 with a new AD that would retain the actions of

AD 2008-11-17 and add the requirement to modify the overturn skid plate installed on Model AT-401B airplanes.

Comments

We provided the public the opportunity to participate in developing this AD. We received no comments on the proposal or on the determination of the cost to the public.

Conclusion

We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial corrections. We have determined that these minor corrections:

Are consistent with the intent that was proposed in the

NPRM for correcting the unsafe condition; and

Do not add any additional burden upon the public than was already proposed in the NPRM.

Costs of Compliance

We estimate that this AD affects 1,309 airplanes in the U.S. registry.

In determining the total cost on U.S. operators, we presume all airplanes in the U.S. fleet have an overturn skid plate installed (as required by AD 2002-25-09) and the only cost is to incorporate the modification kit P/N 11411-1-501. We estimate the following costs to do the modification of installing the overturn skid plate modification kit

P/N 11411-1-501 to those planes that

Page 78945

currently have the overturn skid plate installed:

Total cost per Total cost on

Labor cost

Parts cost

airplane

U.S. operators

2 work-hours x $80 per hour = $160...........................

$42

$202

$264,418

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106 describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the agency's authority.

We are issuing this rulemaking under the authority described in

Subtitle VII, Part A, Subpart III, Section 44701, ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this AD.

Regulatory Findings

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a summary of the costs to comply with this AD (and other information as included in the Regulatory Evaluation) and placed it in the AD Docket. You may get a copy of this summary by sending a request to us at the address listed under ADDRESSES. Include ``Docket

No. FAA-2008-1120; Directorate Identifier 2008-CE-064-AD'' in your request.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment 0

Accordingly, under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal

Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by removing Airworthiness Directive (AD) 2008-11-17, Amendment 39-15540 (73 FR 31351, June 2, 2008), and adding the following new AD: 2008-26-01 Air Tractor, Inc.: Amendment 39-15767; Docket No. FAA- 2008-1120; Directorate Identifier 2008-CE-064-AD.

Effective Date

(a) This AD becomes effective on January 28, 2009.

Affected ADs

(b) This AD supersedes AD 2008-11-17, Amendment 39-15540.

Applicability

(c) This AD applies to the following airplane models and serial numbers that are certificated in any category:

Group 1 models

Serial Nos.

AT-250, AT-300, AT-301,

-0001 through -1196.

AT-302, AT-400, AT-400A,

AT-401, AT-401A, AT-402,

AT-402A, and AT-402B.

AT-501, AT-502, AT-502A, -0001 through -2620. and AT-502B.

AT-602................... -0337 through -1153.

AT-802A.................. -0003 through -0282.

Group 2 models

Serial Nos.

AT-401B.................. -0952 through -1196.

Unsafe Condition

(d) Since we issued AD 2008-11-17, the manufacturer has notified us that Model AT-401B airplanes also need a modification to the overturn skid plane. Consequently, this AD retains the actions of AD 2008-11-17 and adds the requirement to modify the overturn skid plate installed on Model AT-401B airplanes. We are issuing this AD to prevent the front and rear connections of the overturn skid plate to the airplane from breaking, which could allow foreign debris to enter the cockpit during an airplane overturn. This condition, if not corrected, could lead to pilot injury.

Compliance

(e) To address this problem, you must do the following, unless already done:

Actions

Compliance

Procedures

(1) For Group 1 airplanes:

Within the next 180 Follow Snow

If overturn skid plate part days after July 7,

Engineering Co. number (P/N) 11411-1-500 or 2008 (the effective Service Letter an FAA-approved equivalent date of AD 2008-11- 97,

P/N is already installed

17).

revised November 7, then install P/N 11411-1-

2007; or Snow 501 modification kit.

Engineering Co.

Service Letter 97, revised September 19, 2008.

Page 78946

(2) For Group 1 airplanes:

Within the next 180 Follow Snow

If there is no overturn

days after July 7,

Engineering Co. skid plate installed, then 2008 (the effective Service Letter install overturn skid plate date of AD 2008-11- 97, kit P/N 11411-1-502 or an

17).

revised November 7,

FAA-approved equivalent

2007; or Snow part number.

Engineering Co.

Service Letter 97, revised September 19, 2008.

(3) For Group 2 airplanes:

Within the next 180 Follow Snow

Install P/N 11411-1-501

days after January

Engineering Co. modification kit.

28, 2009 (the

Service Letter effective date of

97, this AD).

revised September 19, 2008.

Alternative Methods of Compliance (AMOCs)

(f) The Manager, Fort Worth Airplane Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Andy

McAnaul, Aerospace Engineer, ASW-150, FAA San Antonio MIDO-43, 10100

Reunion Pl., Ste. 650, San Antonio, Texas 78216; telephone: (210) 308-3365; fax: (210) 308-3370. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office

(FSDO), or lacking a PI, your local FSDO.

Material Incorporated by Reference

(h) You must use Snow Engineering Co. Service Letter 97, revised November 7, 2007; or Snow Engineering Co.

Service Letter 97, revised September 19, 2008, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of Snow Engineering Co. Service Letter 97, revised September 19, 2008, under 5 U.S.C. 552(a) and 1

CFR part 51.

(2) On July 7, 2008 (73 FR 31351, June 2, 2008), the Director of the Federal Register approved the incorporation by reference of Snow

Engineering Co. Service Letter 97, revised November 7, 2007.

(3) For service information identified in this AD, contact Air

Tractor Inc., P.O. Box 485, Olney, Texas 76374; telephone: (940) 564-5616; fax: (940) 564-5612; e-mail: airmail@airtractor.com;

Internet: http://www.airtractor.com.

(4) You may review copies of the service information incorporated by reference for this AD at the FAA, Central Region,

Office of the Regional Counsel, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the

Central Region, call (816) 329-3768.

(5) You may also review copies of the service information incorporated by reference for this AD at the National Archives and

Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http:// www.archives.gov/federal_register/code_of_federal_regulations/ ibr_locations.html.

Issued in Kansas City, Missouri, on December 9, 2008.

John Colomy,

Acting Manager, Small Airplane Directorate, Aircraft Certification

Service.

FR Doc. E8-29568 Filed 12-23-08; 8:45 am

BILLING CODE 4910-13-P