Airworthiness directives: Empresa Brasileira de Aeronautica S.A. (EMBRAER); withdrawn,

[Federal Register: May 9, 2006 (Volume 71, Number 89)]

[Proposed Rules]

[Page 26880-26882]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr09my06-20]

[[Page 26880]]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2006-24696; Directorate Identifier 2006-NM-038-AD]

RIN 2120-AA64

Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model EMB-145, -145ER, -145MR, -145LR, -145XR, -145MP, and - 145EP Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION: Notice of proposed rulemaking (NPRM).

SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain EMBRAER Model EMB-145, -145ER, -145MR, -145LR, -145XR, - 145MP, and -145EP airplanes. This proposed AD would require replacing the electrical bonding clamps inside the fuel tanks and adjacent areas. This proposed AD results from a report of a failure of fitting clamp of an electrical bonding cable for the fuel tubing. We are proposing this AD to prevent loss of bonding protection in the interior of the fuel tanks or adjacent areas, and a consequent potential source of ignition in a fuel tank and possible fire or explosion.

DATES: We must receive comments on this proposed AD by June 8, 2006.

ADDRESSES: Use one of the following addresses to submit comments on this proposed AD.

DOT Docket Web site: Go to http://dms.dot.gov and follow

the instructions for sending your comments electronically.

Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your

comments electronically.

Mail: Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, room PL-401, Washington, DC 20590.

Fax: (202) 493-2251.

Hand Delivery: Room PL-401 on the plaza level of the Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

Contact Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box 343--CEP 12.225, Sao Jose dos Campos--SP, Brazil, for service information identified in this proposed AD.

FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2125; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to submit any relevant written data, views, or arguments regarding this proposed AD. Send your comments to an address listed in the ADDRESSES section. Include the docket number ``FAA-2006- 24696; Directorate Identifier 2006-NM-038-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the proposed AD. We will consider all comments received by the closing date and may amend the proposed AD in light of those comments.

We will post all comments we receive, without change, to http://dms.dot.gov , including any personal information you provide. We will

also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of that Web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78), or you may visit http://dms.dot.gov.

Examining the Docket

You may examine the AD docket on the Internet at http://dms.dot.gov , or in person at the Docket Management Facility office

between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Management Facility office (telephone (800) 647- 5227) is located on the plaza level of the Nassif Building at the DOT street address stated in the ADDRESSES section. Comments will be available in the AD docket shortly after the Docket Management System receives them.

Discussion

The Departmento de Aviacao Civil (DAC), which is the airworthiness authority for Brazil, notified us that an unsafe condition may exist on all EMBRAER Model EMB-145, -145ER, -145MR, -145LR, -145XR, -145MP, and -145EP airplanes. The DAC advises that it received a report of one failure of fitting clamp of an electrical bonding cable for the fuel tubing. Investigation into the failure identified a batch of electrical bonding cable fitting clamps that was manufactured with incorrect material; the incorrect aluminum alloy Type 1100, which is more ductile than the correct Type 2602 aluminum alloy, deforms during the installation process. The batch of clamps made from incorrect material was installed on numerous airplanes. This condition, if not corrected, could result in loss of bonding protection in the interior of the fuel tanks or adjacent areas, and a consequent potential source of ignition in a fuel tank and possible fire or explosion.

Relevant Service Information

EMBRAER has issued Service Bulletin 145-28-0028, dated November 7, 2005. The service bulletin describes procedures for replacing the electrical bonding clamps, having part numbers AN735D6 and AN735D4, inside the ventral, wing stub, and wing fuel tanks, and adjacent areas. The replacement includes measuring the electrical resistance between the tubes joined by the electrical bonding jumper. If the resistance is greater than 200 milliohms, the service bulletin describes repeating the clamp replacement and measuring the resistance until the resistance value is 200 milliohms or less. When the resistance is 200 milliohms or less, the service bulletin describes procedures for making the bonding protection inside the ventral, wing stub, and wing fuel tanks. Accomplishing the actions specified in the service information is intended to adequately address the unsafe condition. The DAC mandated the service information and issued Brazilian airworthiness directive 2006-02-03, effective February 24, 2006, to ensure the continued airworthiness of these airplanes in Brazil.

FAA's Determination and Requirements of the Proposed AD

These airplane models are manufactured in Brazil and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, the DAC has kept the FAA informed of the situation described above. We have examined the DAC's findings, evaluated all pertinent information, and determined that we need to issue an AD for airplanes of this type design that are certificated for operation in the United States.

[[Page 26881]]

Therefore, we are proposing this AD, which would require accomplishing the actions specified in the service information described previously, except as discussed under ``Difference Between the Proposed AD and Brazilian Airworthiness Directive.''

Difference Between the Proposed AD and Brazilian Airworthiness Directive

Brazilian airworthiness directive 2006-02-03, dated February 24, 2006, is applicable to ``all EMB-145( ) aircraft models in operation.'' However, this does not agree with EMBRAER Service Bulletin 145-28-0028, dated November 7, 2005, which states that only certain EMB-145 airplanes are affected and identifies them by serial number. This proposed AD would be applicable only to the airplanes listed in the service bulletin. This difference has been coordinated with the DAC.

Costs of Compliance

The following table provides the estimated costs for U.S. operators to comply with this proposed AD.

Estimated Costs

Average Work labor

Number of U.S.- Action

hours rate per

Parts

Cost per airplane registered

Fleet cost hour

airplanes

Replacement of bonding clamp (all

2

$80 Between $57 and $87 Between $217 and $247

18 Between $3,906 and airplane groups).

(depending on kit/

(depending on kit/

$4,446 (depending on airplane group).

airplane group).

kit/airplane group).

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in subtitle VII, part A, subpart III, section 44701, ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that the proposed regulation:

1. Is not a ``significant regulatory action'' under Executive Order 12866;

2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

   We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.

   List of Subjects in 14 CFR Part 39

   Air transportation, Aircraft, Aviation safety, Safety.

   The Proposed Amendment

   Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

   PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. The Federal Aviation Administration (FAA) amends Sec. 39.13 by adding the following new airworthiness directive (AD):

   Empresa Brasileira de Aeronautica S.A. (EMBRAER): Docket No. FAA- 2006-24696; Directorate Identifier 2006-NM-038-AD.

   Comments Due Date

   (a) The FAA must receive comments on this AD action by June 8, 2006.

   Affected ADs

   (b) None.

   Applicability

   (c) This AD applies to EMBRAER Model EMB-145, -145ER, -145MR, - 145LR, -145XR, -145MP, and -145EP airplanes; certificated in any category; as identified in EMBRAER Service Bulletin 145-28-0028, dated November 7, 2005.

   Unsafe Condition

   (d) This AD results from a report of a failure of fitting clamp of an electrical bonding cable for the fuel tubing. We are issuing this AD to prevent loss of bonding protection in the interior of the fuel tanks or adjacent areas, and a consequent potential source of ignition in a fuel tank and possible fire or explosion.

   Compliance

   (e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

   Electrical Bonding Clamp Replacement

   (f) Within 5,000 flight hours after the effective date of this AD: Replace the electrical bonding clamps having part numbers AN735D6 and AN735D4 inside the ventral, wing stub, and wing fuel tanks, and adjacent areas, by accomplishing all actions specified in the Accomplishment Instructions of EMBRAER Service Bulletin 145-28- 0028, dated November 7, 2005.

   Alternative Methods of Compliance (AMOCs)

   (g)(1) The Manager, International Branch ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.

   (2) Before using any AMOC approved in accordance with Sec. 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office.

   Related Information

   (h) Brazilian airworthiness directive 2006-02-03, effective February 24, 2006, also addresses the subject of this AD.

   [[Page 26882]]

   Issued in Renton, Washington, on April 28, 2006. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E6-7013 Filed 5-8-06; 8:45 am]

   BILLING CODE 4910-13-P