Airworthiness Directives: Pilatus Aircraft Ltd. Model PC-6 Airplanes

Federal Register: August 13, 2008 (Volume 73, Number 157)

Rules and Regulations

Page 47039-47041

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

DOCID:fr13au08-5

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration 14 CFR Part 39

Docket No. FAA-2008-0626 Directorate Identifier 2008-CE-035-AD;

Amendment 39-15637; AD 2008-16-19

RIN 2120-AA64

Airworthiness Directives; Pilatus Aircraft Ltd. Model PC-6

Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of

Transportation (DOT).

ACTION: Final rule.

SUMMARY: We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This Airworthiness Directive (AD) is prompted due to the discovery of loose self-locking stop nuts Part Number (P/N) 938.07.65.105 in the tail landing gear fastener assemblies of some

PC-6 aircraft.

It is believed that this occurrence could also exist in other fastener assemblies using nuts P/N 938.07.65.105 at various identified locations in the aircraft.

If left uncorrected, the identified assemblies may become loose and not function as designed and could lead to hazardous situations.

We are issuing this AD to require actions to correct the unsafe condition on these products.

DATES: This AD becomes effective September 17, 2008.

On September 17, 2008, the Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD.

ADDRESSES: You may examine the AD docket on the Internet at http:// www.regulations.gov or in person at Document Management Facility, U.S.

Department of Transportation, Docket Operations, M-30, West Building

Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.

FOR FURTHER INFORMATION CONTACT: Doug Rudolph, Aerospace Engineer, FAA,

Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; fax: (816) 329-4090.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products.

That NPRM was published in the Federal Register on June 9, 2008 (73 FR 32497). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

This Airworthiness Directive (AD) is prompted due to the discovery of loose self-locking stop nuts Part Number (P/N) 938.07.65.105 in the tail landing gear fastener assemblies of some

PC-6 aircraft.

It is believed that this occurrence could also exist in other fastener assemblies using nuts P/N 938.07.65.105 at various identified locations in the aircraft.

If left uncorrected, the identified assemblies may become loose and not function as designed and could lead to hazardous situations.

In order to prevent those conditions, the present AD requires you to replace self-locking stop nuts P/N 938.07.65.105 from the

Tail Landing Gear Assembly, the Parachute Cable Assembly, the Water

Tank Assembly, the Cable Tensioner Assembly, the Fuel Filter

Assembly, the Hydraulic Pump Assembly and the Engine Mounts Assembly in accordance with Pilatus PC-6 Service Bulletin No. 53-002 Revision 2.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

Page 47040

Differences Between This AD and the MCAI or Service Information

We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the

AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

We might also have required different actions in this AD from those in the MCAI in order to follow FAA policies. Any such differences are highlighted in a NOTE within the AD.

Costs of Compliance

Based on the service information, we estimate that this AD will affect 50 products of U.S. registry. We also estimate that it will take about 7 work-hours per product to comply with basic requirements of this AD. The average labor rate is $80 per work-hour. Required parts will cost about $310 per product.

Based on these figures, we estimate the cost of this AD to the U.S. operators to be $43,500, or $870 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation

Programs,'' describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in

``Subtitle VII, part A, subpart III, section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

(1) Is not a ``significant regulatory action'' under Executive

Order 12866;

(2) Is not a ``significant rule'' under DOT Regulatory Policies and

Procedures (44 FR 11034, February 26, 1979); and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD Docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment 0

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2008-16-19 Pilatus Aircraft Ltd.: Amendment 39-15637; Docket No.

FAA-2008-0626; Directorate Identifier 2008-CE-035-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective

September 17, 2008.

Affected ADs

(b) None.

Applicability

(c) This AD applies to PC-6, PC-6-H1, PC-6-H2, PC-6/350, PC-6/ 350-H1, PC-6/350-H2, PC-6/A, PC-6/A-H1, PC-6/A-H2, PC-6/B-H2, PC-6/

B1-H2, PC-6/B2-H2, PC-6/B2-H4, PC-6/C-H2, and PC-6/C1-H2 airplanes, manufacturer serial numbers (MSN) MSN 101 through MSN 949 and MSN 2001 through MSN 2092, certificated in any category.

Note 1: These airplanes may also be identified as Fairchild

Republic Company PC-6 airplanes, Fairchild Heli Porter PC-6 airplanes, or Fairchild-Hiller Corporation PC-6 airplanes.

Subject

(d) Air Transport Association of America (ATA) Code 53:

Fuselage.

Reason

(e) The mandatory continuing airworthiness information (MCAI) states:

This Airworthiness Directive (AD) is prompted due to the discovery of loose self-locking stop nuts Part Number (P/N) 938.07.65.105 in the tail landing gear fastener assemblies of some

PC-6 aircraft.

It is believed that this occurrence could also exist in other fastener assemblies using nuts P/N 938.07.65.105 at various identified locations in the aircraft.

If left uncorrected, the identified assemblies may become loose and not function as designed and could lead to hazardous situations.

In order to prevent those conditions, the present AD requires you replace self-locking stop nuts P/N 938.07.65.105 from the Tail

Landing Gear Assembly, the Parachute Cable Assembly, the Water Tank

Assembly, the Cable Tensioner Assembly, the Fuel Filter Assembly, the Hydraulic Pump Assembly and the Engine Mounts Assembly in accordance with Pilatus PC-6 Service Bulletin No. 53-002 Revision 2.

Actions and Compliance

(f) Unless already done, do the following actions:

(1) Within the next 12 months after September 17, 2008 (the effective date of this AD), inspect and modify the fastener assemblies as instructed in paragraph 3 of Pilatus Aircraft Ltd.

Pilatus PC-6 Service Bulletin No. 53-002, Revision No. 2, dated

September 24, 2007.

(2) As of September 17, 2008 (the effective date of this AD), no person shall install on any PC-6 series aircraft, water tank assemblies and hydraulic pump assemblies, unless they have been previously modified following paragraph 4 of Pilatus Aircraft Ltd.

Pilatus PC-6 Service Bulletin No. 53-002, Revision No. 2, dated

September 24, 2007.

FAA AD Differences

Note 2: This AD differs from the MCAI and/or service information as follows: No differences.

Other FAA AD Provisions

(g) The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager,

Standards Office, FAA, has the authority to approve AMOCs for this

AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Doug Rudolph, Aerospace Engineer, FAA, Small

Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106;

Page 47041

telephone: (816) 329-4059; fax: (816) 329-4090. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards

District Office (FSDO), or lacking a PI, your local FSDO.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered

FAA-approved if they are approved by the State of Design Authority

(or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44

U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned

OMB Control Number 2120-0056.

Related Information

(h) Refer to MCAI European Aviation Safety Agency EASA AD No.: 2008-0083, dated May 5, 2008; and Pilatus Aircraft Ltd. Pilatus PC-6

Service Bulletin No. 53-002, Revision No. 2, dated September 24, 2007, for related information.

Material Incorporated by Reference

(i) You must use Pilatus Aircraft Ltd. Pilatus PC-6 Service

Bulletin No. 53-002, Revision No. 2, dated September 24, 2007, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5

U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact

Pilatus Aircraft Ltd., Customer Liaison Manager, CH-6371 STANS,

Switzerland; telephone: +41 41 619 65 80; fax: +41 41 619 65 76; e- mail: fodermatt@pilatus-aircraft.com.

(3) You may review copies at the FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 64106; or at the National Archives and Records Administration

(NARA). For information on the availability of this material at

NARA, call 202-741-6030, or go to: http://www.archives.gov/federal- register/cfr/ibr-locations.html.

Issued in Kansas City, Missouri, on August 1, 2008.

James E. Jackson,

Acting Manager, Small Airplane Directorate, Aircraft Certification

Service.

FR Doc. E8-18236 Filed 8-12-08; 8:45 am

BILLING CODE 4910-13-P

VLEX uses login cookies to provide you with a better browsing experience. If you click on 'Accept' or continue browsing this site we consider that you accept our cookie policy. ACCEPT