Airworthiness Directives:

Federal Register: November 9, 2010 (Volume 75, Number 216)

Rules and Regulations

Page 68682-68684

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

DOCID:fr09no10-2

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration 14 CFR Part 39

Docket No. FAA-2010-0700; Directorate Identifier 2010-NM-123-AD;

Amendment 39-16500; AD 2010-23-11

RIN 2120-AA64

Airworthiness Directives; Bombardier, Inc. Model CL-600-2C10

(Regional Jet Series 700, 701, & 702), CL-600-2D15 (Regional Jet Series 705), and CL-600-2D24 (Regional Jet Series 900) Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of

Transportation (DOT).

ACTION: Final rule.

SUMMARY: We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The manufacturer has informed Transport Canada that a certain number of the resolver stators, which were installed in the angle of attack (AOA) transducers, were not cleaned correctly. This condition can degrade the AOA transducer performance at low temperatures resulting in freezing of the AOA transducer resolver, which may provide inaccurate AOA data to the Stall Protection System (SPS). If not corrected, this condition can result in early or late activation of the stick shaker and/or stick pusher.

These conditions could result in reduced ability of the flight crew to maintain a safe flight and landing of the airplane. We are issuing this

AD to require actions to correct the unsafe condition on these products.

DATES: This AD becomes effective December 14, 2010.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of December 14, 2010.

ADDRESSES: You may examine the AD docket on the Internet at http:// www.regulations.gov or in person at the U.S. Department of

Transportation, Docket Operations, M-30, West Building Ground Floor,

Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

FOR FURTHER INFORMATION CONTACT: Joseph Licata, Aerospace Engineer,

Avionics and Flight Test Branch, ANE-172, FAA, New York Aircraft

Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury,

New York 11590; telephone (516) 228-7361; fax (516) 794-5531.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products.

That NPRM was published in the Federal Register on July 27, 2010 (75 FR 43882). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

The manufacturer has informed Transport Canada that a certain number of the resolver stators, which were installed in the angle of attack (AOA) transducers, were not cleaned correctly. This condition can degrade the AOA transducer performance at low temperatures resulting in freezing of the AOA transducer resolver, which may provide inaccurate AOA data to the Stall Protection System (SPS). If not corrected, this condition

Page 68683

can result in early or late activation of the stick shaker and/or stick pusher.

These conditions could result in reduced ability of the flight crew to maintain a safe flight and landing of the airplane. The required actions include an inspection to determine if certain AOA transducers are installed and replacement of affected transducers. You may obtain further information by examining the MCAI in the AD docket.

Comments

We gave the public the opportunity to participate in developing this AD. We considered the comment received. Air Line Pilots

Association, International (ALPA), supports the NPRM.

Conclusion

We reviewed the available data, including the comment received, and determined that air safety and the public interest require adopting the

AD as proposed.

Differences Between This AD and the MCAI or Service Information

We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the

AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a NOTE within the AD.

Costs of Compliance

We estimate that this AD will affect 380 products of U.S. registry.

We also estimate that it will take about 1 work-hour per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $32,300, or $85 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation

Programs,'' describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in

``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the

ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment 0

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2010-23-11 Bombardier, Inc.: Amendment 39-16500. Docket No. FAA- 2010-0700; Directorate Identifier 2010-NM-123-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective December 14, 2010.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Bombardier, Inc. Model CL-600-2C10

(Regional Jet Series 700, 701, & 702), CL-600-2D15 (Regional Jet

Series 705), and CL-600-2D24 (Regional Jet Series 900) airplanes, certificated in any category, equipped with Thales angle of attack transducers having part number (P/N) C16258AA.

Subject

(d) Air Transport Association (ATA) of America Code 27: Flight

Controls.

Reason

(e) The mandatory continuing airworthiness information (MCAI) states:

The manufacturer has informed Transport Canada that a certain number of the resolver stators, which were installed in the angle of attack (AOA) transducers, were not cleaned correctly. This condition can degrade the AOA transducer performance at low temperatures resulting in freezing of the AOA transducer resolver, which may provide inaccurate AOA data to the Stall Protection System (SPS). If not corrected, this condition can result in early or late activation of the stick shaker and/or stick pusher.

These conditions could result in reduced ability of the flight crew to maintain a safe flight and landing of the airplane.

Compliance

(f) You are responsible for having the actions required by this

AD performed within the compliance times specified, unless the actions have already been done.

Inspection

(g) Within 750 flight hours after the effective date of this AD, inspect the serial number of each AOA transducer having P/N C16258AA to determine if the serial number is identified in paragraph 1.A. of

Bombardier Alert Service Bulletin A670BA-27-054, Revision A, dated

January 18, 2010, in accordance with the Accomplishment Instructions of Bombardier Alert Service Bulletin A670BA-27-054, Revision A, dated January 18, 2010. A review of airplane maintenance records is acceptable in lieu of this inspection if the serial number of the

AOA transducer can be conclusively determined from that review.

(1) If the serial number is not listed in paragraph 1.A. of

Bombardier Alert Service Bulletin A670BA-27-054, Revision A, dated

January 18, 2010, no further action is

Page 68684

required by this AD other than compliance with paragraph (h) of this

AD.

(2) If the serial number is listed in paragraph 1.A. of

Bombardier Alert Service Bulletin A670BA-27-054, Revision A, dated

January 18, 2010, and has the suffix ``C'', no further action is required by this AD other than compliance with paragraph (h) of this

AD.

(3) If the serial number is listed paragraph 1.A. of Bombardier

Alert Service Bulletin A670BA-27-054, Revision A, dated January 18, 2010, and does not have the suffix ``C'', before further flight, replace the AOA transducer with a new or serviceable transducer, in accordance with Part C of the Accomplishment Instructions of

Bombardier Alert Service Bulletin A670BA-27-054, Revision A, dated

January 18, 2010.

Note 1: To replace any AOA transducer, the replacement AOA transducer must either be outside of the affected serial numbers as identified in paragraph 1.A. of Bombardier Alert Service Bulletin

A670BA-27-054, Revision A, dated January 18, 2010, or have the suffix ``C''.

(h) As of the effective date of this AD, no AOA transducer having both a serial number and P/N C16258AA as identified in paragraph 1.A. of Bombardier Alert Service Bulletin A670BA-27-054,

Revision A, dated January 18, 2010, may be installed on any airplane unless the AOA transducer has been inspected by the manufacturer and identified with the suffix ``C''.

FAA AD Differences

Note 2: This AD differs from the MCAI and/or service information as follows: No differences.

Other FAA AD Provisions

(i) The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, New

York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Program

Manager, Continuing Operational Safety, FAA, New York ACO, 1600

Stewart Avenue, Suite 410, Westbury, New York 11590; telephone 516- 228-7300; fax 516-794-5531. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight

Standards District Office. The AMOC approval letter must specifically reference this AD.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered

FAA-approved if they are approved by the State of Design Authority

(or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act (44

U.S.C. 3501 et seq.), the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned

OMB Control Number 2120-0056.

Related Information

(j) Refer to MCAI Canadian Airworthiness Directive CF-2010-13, dated May 6, 2010; and Bombardier Alert Service Bulletin A670BA-27- 054, Revision A, dated January 18, 2010; for related information.

Material Incorporated by Reference

(k) You must use Bombardier Alert Service Bulletin A670BA-27- 054,

Revision A, dated January 18, 2010, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5

U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact

Bombardier, Inc., 400 C[ocirc]te-Vertu Road West, Dorval,

Qu[eacute]bec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855- 7401; e-mail thd.crj@aero.bombardier.com; Internet http:// www.bombardier.com.

(3) You may review copies of the service information at the FAA,

Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,

Washington. For information on the availability of this material at the FAA, call 425-227-1221.

(4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records

Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http:// www.archives.gov/federal_register/code_of_federal_regulations/ ibr_locations.html.

Issued in Renton, Washington, on October 21, 2010.

Michael Kaszycki,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

FR Doc. 2010-28089 Filed 11-8-10; 8:45 am

BILLING CODE 4910-13-P