Airworthiness Directives:
Federal Register Volume 76, Number 126 (Thursday, June 30, 2011)
Proposed Rules
Pages 38332-38334
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
FR Doc No: 2011-16479
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration 14 CFR Part 39
Docket No. FAA-2011-0649; Directorate Identifier 2011-NM-076-AD
RIN 2120-AA64
Airworthiness Directives; The Boeing Company Model MD-11 and MD- 11F Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
SUMMARY: We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD would require replacing the rub strips of the tail fuel tank access door with new rub strips. This proposed AD was prompted by a report that the rub strips of the tail fuel tank access door were manufactured improperly. We are proposing this AD to prevent inadequate electrical bonding between the rub strips and the fuel access door, which can contribute to possible ignition of flammable fuel vapor in the tail fuel tank as a result of a lightning strike.
DATES: We must receive comments on this proposed AD by August 15, 2011.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.
Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact
Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, California 90846- 0001; telephone 206-544-5000, extension 2; fax 206-766-5683; e-mail dse.boecom@boeing.com; Internet https://www.myboeingfleet.com. You may review copies of the referenced service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington. For information on the availability of this material at the
FAA, call 425-227-1221.
Page 38333
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Philip Kush, Aerospace Engineer,
Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification
Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; phone: 562-627-5263; fax: 562-627-5210; e-mail: philip.kush@faa.gov.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2011-0649;
Directorate Identifier 2011-NM-076-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
We received a report that the rub strips of the tail fuel tank access door were manufactured improperly. These rub strips were inadvertently anodized (electrically non-conductive) instead of alodined (electrically conductive) as prescribed in design drawings.
Anodization of the rub strips may prevent adequate electrical bonding between the rub strips and the doors. Inadequate electrical bonding can contribute to possible ignition of flammable fuel vapor in the tail fuel tank as a result of a lightning strike.
Relevant Service Information
We reviewed Boeing Special Attention Service Bulletin MD11-55-027, dated March 17, 2011. The service information describes procedures for replacing the rub strips of the tail fuel tank access door with new rub strips. Replacing anodized rub strips with alodined rub strips will provide adequate electrical bonding between the rub strips and the fuel access doors.
FAA's Determination
We are proposing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.
Proposed AD Requirements
This proposed AD would require accomplishing the actions specified in the service information described previously.
Costs of Compliance
We estimate that this proposed AD affects 120 airplanes of U.S. registry.
We estimate the following costs to comply with this proposed AD:
Estimated Costs
Cost per
Cost on U.S.
Action
Labor cost
Parts cost
product
operators
Replace rub strips................ 32 work-hours x $85 per
$0
$2,720
$326,400 hour = $2,720.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
Subtitle VII, Part A, Subpart III, Section 44701: ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended] 2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
The Boeing Company: Docket No. FAA-2011-0649; Directorate Identifier 2011-NM-076-AD.
Page 38334
Comments Due Date
(a) We must receive comments by August 15, 2011.
Affected ADs
(b) None.
Applicability
(c) The Boeing Company Model MD-11 and MD-11F airplanes, certificated in any category, as identified in Boeing Special
Attention Service Bulletin MD11-55-027, dated March 17, 2011.
Subject
(d) Joint Aircraft System Component (JASC)/Air Transport
Association (ATA) of America Code 5510: Tail Fuel Tank Access Door.
Unsafe Condition
(e) This AD was prompted by a report that the rub strips of the tail fuel tank access door were manufactured improperly. We are issuing this AD to prevent inadequate electrical bonding between the rub strips and the fuel access door, which can contribute to possible ignition of flammable fuel vapor in the tail fuel tank as a result of a lightning strike.
Compliance
(f) Comply with this AD within the compliance times specified, unless already done.
Installation
(g) Within 60 months after the effective date of this AD, replace the rub strips of the tail fuel tank access door with new rub strips, in accordance with the Accomplishment Instructions of
Boeing Special Attention Service Bulletin MD11-55-027, dated March 17, 2011.
Alternative Methods of Compliance (AMOCs)
(h)(1) The Manager, Los Angeles Aircraft Certification Office
(ACO), Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District
Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in the Related Information section of this AD.
(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
Related Information
(i) For more information about this AD, contact Philip Kush,
Aerospace Engineer, Propulsion Branch, ANM-140L, FAA, Los Angeles
ACO, 3960 Paramount Boulevard, Lakewood, California 90712-4137; phone: 562-627-5263; fax: 562-627-5210; e-mail: philip.kush@faa.gov.
(j) For service information identified in this AD, contact
Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, California 90846- 0001; telephone 206-544-5000, extension 2; fax 206-766-5683; e-mail dse.boecom@boeing.com; Internet https://www.myboeingfleet.com. You may review copies of the referenced service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington 98057. For information on the availability of this material at the FAA, call 425-227-1221.
Issued in Renton, Washington, on June 22, 2011.
Kalene C. Yanamura,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
FR Doc. 2011-16479 Filed 6-29-11; 8:45 am
BILLING CODE 4910-13-P
