Airworthiness directives: Aerospatiale,

[Federal Register: August 27, 1998 (Volume 63, Number 166)]

[Rules and Regulations]

[Page 45692-45693]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr27au98-11]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-158-AD; Amendment 39-10720; AD 98-18-04]

RIN 2120-AA64

Airworthiness Directives; Aerospatiale Model SN-601 (Corvette) Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to all Aerospatiale Model SN-601 (Corvette) series airplanes, that requires repetitive inspections to detect corrosion, cracking, or rupture of the support arms of the aileron balance weights; and repair, if necessary. Accomplishment of the repair terminates the repetitive inspection requirement of this AD. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to prevent corrosion, cracking, or rupture of the support arms of the aileron balance weights, which may cause reduced flutter damping or jamming of the aileron, and consequent reduced controllability of the airplane.

DATES: Effective October 1, 1998.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of October 1, 1998.

ADDRESSES: The service information referenced in this AD may be obtained from Aerospatiale, 316 Route de Bayonne, 31060 Toulouse, Cedex 03, France. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to all Aerospatiale Model SN-601 (Corvette) series airplanes was published in the Federal Register on July 7, 1998 (63 FR 36626). That action proposed to require repetitive inspections to detect corrosion, cracking, or rupture of the support arms of the aileron balance weights; and repair, if necessary. Accomplishment of the repair terminates the repetitive inspection requirement of this AD.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact

The FAA estimates that 2 airplanes of U.S. registry will be affected by this AD, that it will take approximately 2 work hours per airplane to accomplish the required inspection, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the inspection required by this AD on U.S. operators is estimated to be $240, or $120 per airplane, per inspection cycle.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

Regulatory Impact

The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

   98-18-04 Aerospatiale: Amendment 39-10720. Docket 98-NM-158-AD.

   Applicability: All Model SN-601 (Corvette) series airplanes, certificated in any category.

   Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

   Compliance: Required as indicated, unless accomplished previously.

   To prevent corrosion, cracking, or rupture of the support arms of the aileron balance weights, which may cause reduced flutter damping or jamming of the aileron, and consequent reduced controllability of the airplane, accomplish the following:

   [[Page 45693]]

   (a) Within 10 landings or 10 days after the effective date of this AD, whichever occurs later: Perform a detailed visual inspection to detect corrosion, cracking, or rupture of the support arms of the aileron balance weights, in accordance with Aerospatiale All Operators Telex (AOT) A/BTE/AM 499.368/95, dated March 7, 1995.

   (1) If no corrosion, cracking, or rupture is detected on the support arms, repeat the inspection thereafter at intervals not to exceed 200 flight hours or 6 months, whichever occurs earlier.

   (2) If any corrosion, cracking, or rupture is detected on the support arms: Except as provided by paragraph (b) of this AD, prior to further flight, repair in accordance with the AOT. Accomplishment of this repair constitutes terminating action for the repetitive inspection requirements of this AD.

   (b) If any corrosion, cracking, or rupture is detected on the support arms, and Aerospatiale All Operators Telex (AOT) A/BTE/AM 499.368/95, dated March 7, 1995, specifies to contact Aerospatiale for an appropriate repair: Prior to further flight, repair in accordance with a method approved by either the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate; or the Direction Generale de l'Aviation Civile (or its delegated agent).

   (c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

   Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

   (d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

   (e) Except as provided by paragraph (b) of this AD, the actions shall be done in accordance with Aerospatiale All Operators Telex (AOT) A/BTE/AM 499.368/95, dated March 7, 1995. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Aerospatiale, 316 Route de Bayonne, 31060 Toulouse, Cedex 03, France. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

   Note 3: The subject of this AD is addressed in French airworthiness directive 95-054-019 (B), dated March 29, 1995.

   (f) This amendment becomes effective on October 1, 1998.

   Issued in Renton, Washington, on August 19, 1998. Darrell M. Pederson, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 98-22815Filed8-26-98; 8:45 am]

   BILLING CODE 4910-13-U