Airworthiness Directives; Airbus Airplanes
Federal Register, Volume 77 Issue 187 (Wednesday, September 26, 2012)
Federal Register Volume 77, Number 187 (Wednesday, September 26, 2012)
Proposed Rules
Pages 59149-59151
From the Federal Register Online via the Government Printing Office www.gpo.gov
FR Doc No: 2012-23638
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2012-1002; Directorate Identifier 2012-NM-052-AD
RIN 2120-AA64
Airworthiness Directives; Airbus Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for certain Airbus Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called A300-600 series airplanes); and Model A310 series airplanes. This proposed AD was prompted by reports of cracking through the honeycomb core closed with phenolic resin. This condition could result in extended debonding and could adversely affect the structural integrity of the rudder. This proposed AD would require inspecting to determine the serial number of a certain rudder and replacing the rudder with a new or serviceable rudder if necessary. We are proposing this AD to prevent extended de-bonding, which could result in loss of the rudder and consequent reduced controllability of the airplane.
DATES: We must receive comments on this proposed AD by November 13, 2012.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-2125; fax 425-227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2012-1002; Directorate Identifier 2012-NM-052-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any
Page 59150
personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2012-0006, dated January 12, 2012 (referred to after this as ``the MCAI''), to correct an unsafe condition for the specified products. The MCAI states:
Following in-service findings reported by an operator, rudder laboratory investigation revealed the existence of a crack through the honeycomb core closed with phenolic resin. This condition if not detected and corrected, could result in extended de-bonding, which would adversely affect the structural integrity of the rudder. The loss of the rudder could lead to degradation of the handling qualities and reduces the controllability of the aeroplane.
Further investigations identified a batch of five affected rudders.
For the reasons described above, this EASA AD requires inspecting to determine the serial number (S/N) of a certain rudder and the replacement of the five affected rudders with new or serviceable ones.
You may obtain further information by examining the MCAI in the AD docket.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance
Based on the service information, we estimate that this proposed AD would affect about 170 products of U.S. registry. We also estimate that it would take about 1 work-hour per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $14,450, or $85 per product.
In addition, we estimate that any necessary follow-on actions would take about 10 work-hours and require parts costing $714,100, for a cost of $714,950 per product. We have no way of determining the number of products that may need these actions.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
-
Is not a ``significant regulatory action'' under Executive Order 12866;
-
Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
-
Will not affect intrastate aviation in Alaska; and
-
Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
-
The FAA amends Sec. 39.13 by adding the following new AD:
Airbus: Docket No. FAA-2012-1002; Directorate Identifier 2012-NM-
052-AD.
(a) Comments Due Date
We must receive comments by November 13, 2012.
(b) Affected ADs
None.
(c) Applicability
This AD applies to Airbus Model A300 B4-601, B4-603, B4-620, B4-
622, B4-605R, B4-622R, F4-605R, F4-622R, and C4-605R Variant F airplanes; and Model A310-203, -204, -221, -222, -304, -322, -324, and -325 airplanes; certificated in any category; all serial numbers, except those airplanes on which Airbus modification 08827 has been incorporated in production.
(d) Subject
Air Transport Association (ATA) of America Code 55, Stabilizers.
(e) Reason
This AD was prompted by reports of cracking through the honeycomb core closed with phenolic resin. This condition could result in extended debonding and could adversely affect the structural integrity of the rudder. We are issuing this AD to prevent extended de-bonding, which could result in loss of the rudder and consequent reduced controllability of the airplane.
(f) Compliance
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Inspection
Within 3 months after the effective date of this AD, inspect the rudder having part number (P/N) A55471500, to determine if the rudder has serial number (S/N) HF1010, HF1036, HF1059, HF1061, or HF1064. A review of airplane maintenance records is acceptable in lieu of this inspection if the serial number of the rudder can be conclusively determined from that review.
(h) Rudder Replacement
If, during the inspection required by paragraph (g) of this AD, any rudder having S/N HF1010, HF1036, HF1059, HF1061, or HF1064 is found, before further flight, replace the rudder with a new or serviceable rudder, using a method approved by either the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the European Aviation Safety Agency (EASA) (or its delegated agent).
Note 1 to Paragraph (h) of this AD: Rudders having S/N HF1010, HF1036, HF1059,
Page 59151
HF1061, and HF1064 were installed on airplanes having S/N 0295, 0297, 0321, 0355, and 0500; however, each rudder may have been moved to another airplane.
(i) Parts Installation Prohibition
As of the effective date of this AD, no person may install a rudder P/N A55471500, having S/N HF1010, HF1036, HF1059, HF1061, or HF1064, on any airplane.
(j) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-
116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-2125; fax 425-227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(k) Related Information
Refer to MCAI European Aviation Safety Agency (EASA) Airworthiness Directive 2012-0006, dated January 12, 2012, for related information.
Issued in Renton, Washington, on September 12, 2012.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2012-23638 Filed 9-25-12; 8:45 am
BILLING CODE 4910-13-P
