Airworthiness directives: Boeing,

[Federal Register: October 17, 2007 (Volume 72, Number 200)]

[Proposed Rules]

[Page 58773-58774]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr17oc07-15]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2007-0049; Directorate Identifier 2007-NM-168-AD]

RIN 2120-AA64

Airworthiness Directives; Boeing Model 737-600, -700, -700C, - 800, and -900 Series Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).

ACTION: Notice of proposed rulemaking (NPRM).

SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain Boeing Model 737-600, -700, -700C, -800, and -900 series airplanes. This proposed AD would require replacing the drain tube assemblies and support clamps on the aft fairings of the engine struts. This proposed AD results from reports of failure of the drain tube assembly and clamp on the aft fairings of an engine strut. We are proposing this AD to prevent failure of the drain tube assemblies and clamps on the aft fairings of the engine struts. Such a failure could allow leaked flammable fluids in the drain systems to discharge on to the heat shields of the aft fairings of the engine struts, which could result in an undetected and uncontrollable fire.

DATES: We must receive comments on this proposed AD by December 3, 2007.

ADDRESSES: You may send comments by any of the following methods:

Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.

Fax: 202-493-2251.

Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.

Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this AD, contact Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov ; or in person at the Docket Management Facility

between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Kathrine Rask, Aerospace Engineer, Propulsion Branch, ANM-140S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6505; fax (425) 917-6590.

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2007-0049; Directorate Identifier 2007-NM-168-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov , including any personal information you provide. We

will also post a report summarizing each substantive verbal contact we receive about this proposed AD.

Discussion

We have received reports of failure of the drain tube assembly and support clamp on the aft fairing of an engine strut. In most of the reports, the failure occurred at the brazed joint between the tube and the drain cast fitting. Failure of the drain tube assembly and support clamp on the aft fairing of an engine strut, if not corrected, could allow leaked flammable fluids in the drain system to discharge on to the heat shield of the aft fairing of an engine strut, which may result in an undetected and uncontrollable fire.

Relevant Service Information

We have reviewed Boeing Special Attention Service Bulletin 737-54- 1043, dated May 2, 2007. The service information describes procedures for replacing the drain tube assemblies and support clamps on the aft fairing of the struts of the number 1 and number 2 engines with new drain tube assemblies and new support clamps. Accomplishing the actions specified in the service information is intended to adequately address the unsafe condition.

FAA's Determination and Requirements of the Proposed AD

We have evaluated all pertinent information and identified an unsafe condition that is likely to exist or develop on other airplanes of this same type design. For this reason, we are proposing this AD, which would require accomplishing the actions specified in the service information described previously.

Costs of Compliance

There are about 2,058 airplanes of the affected design in the worldwide fleet. This proposed AD would affect about 721 airplanes of U.S. registry. The proposed actions would take about 4 work hours per airplane, at an average labor rate of $80 per work hour. Required parts would cost about $2,351 per airplane. Based on these figures, the estimated cost of the proposed AD for U.S. operators is $1,925,791, or $2,671 per airplane.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I,

[[Page 58774]]

Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that the proposed regulation:

1. Is not a ``significant regulatory action'' under Executive Order 12866;

2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

   We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.

   List of Subjects in 14 CFR Part 39

   Air transportation, Aircraft, Aviation safety, Safety.

   The Proposed Amendment

   Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

   PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. The Federal Aviation Administration (FAA) amends Sec. 39.13 by adding the following new airworthiness directive (AD):

   Boeing: Docket No. FAA-2007-0049; Directorate Identifier 2007-NM- 168-AD.

   Comments Due Date

   (a) The FAA must receive comments on this AD action by December 3, 2007.

   Affected ADs

   (b) None.

   Applicability

   (c) This AD applies to Boeing Model 737-600, -700, -700C, -800, and -900 series airplanes, certificated in any category; as identified in Boeing Special Attention Service Bulletin 737-54-1043, dated May 2, 2007.

   Unsafe Condition

   (d) This AD results from reports of failure of the drain tube assembly and support clamp on the aft fairing of an engine strut. We are issuing this AD to prevent failure of the drain tube assemblies and clamps on the aft fairings of the struts of the number 1 and number 2 engines. Such a failure could allow leaked flammable fluids in the drain systems to discharge on to the heat shields of the aft fairings of the engine struts, which could result in an undetected and uncontrollable fire.

   Compliance

   (e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

   Replacement

   (f) Within 60 months after the effective date of this AD, remove the drain tube assemblies and support clamps on the aft fairing of the struts of engine number 1 and engine number 2. These are to be replaced with new drain tube assemblies and clamps, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 737-54-1043, dated May 2, 2007.

   Alternative Methods of Compliance (AMOCs)

   (g)(1) The Manager, Seattle Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.

   (2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

   Issued in Renton, Washington, on October 9, 2007. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E7-20469 Filed 10-16-07; 8:45 am]

   BILLING CODE 4910-13-P