Airworthiness Directives: Boeing Model 757 Airplanes
Federal Register: September 29, 2009 (Volume 74, Number 187)
Proposed Rules
Page 49827-49829
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
DOCID:fr29se09-17
Proposed Rules
Federal Register
This section of the FEDERAL REGISTER contains notices to the public of the proposed issuance of rules and regulations. The purpose of these notices is to give interested persons an opportunity to participate in the rule making prior to the adoption of the final rules.
Page 49827
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration 14 CFR Part 39
Docket No. FAA-2009-0795; Directorate Identifier 2009-NM-083-AD
RIN 2120-AA64
Airworthiness Directives; Boeing Model 757 Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
SUMMARY: We propose to adopt a new airworthiness directive (AD) for certain Boeing Model 757 airplanes. This proposed AD would require inspecting to verify the part number of the low-pressure flex-hoses of the flightcrew and supernumerary oxygen system installed under the oxygen mask stowage box at a flightcrew and supernumerary oxygen mask location, and replacing with a new non-conductive low-pressure flex- hose of the oxygen system if necessary. This proposed AD results from reports of a low-pressure flex-hose of a flightcrew oxygen system that burned through due to inadvertent electrical current from a short circuit in an adjacent audio select panel. We are proposing this AD to prevent inadvertent electrical current which can cause the low-pressure flex-hose of a flightcrew or supernumerary oxygen system to melt or burn, resulting in oxygen system leakage and smoke or fire.
DATES: We must receive comments on this proposed AD by November 13, 2009.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http:// www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590, between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact
Boeing Commercial Airplanes, Attention: Data & Services Management,
P.O. Box 3707, MC 2H-65, Seattle, Washington 98124-2207; telephone 206- 544-5000, extension 1; fax 206-766-5680; e-mail me.boecom@boeing.com;
Internet https://www.myboeingfleet.com. You may review copies of the referenced service information at the FAA, Transport Airplane
Directorate, 1601 Lind Avenue, SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152.
Examining the AD Docket
You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone 800-647-5527) is in the
ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Robert Hettman, Aerospace Engineer,
Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle
Aircraft Certification Office, 1601 Lind Avenue, SW., Renton,
Washington 98057-3356; telephone (425) 917-6457; fax (425) 917-6590.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2009-0795;
Directorate Identifier 2009-NM-083-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.
We will post all comments we receive, without change, to http:// www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
We have received reports of a low-pressure flex-hose of a flightcrew oxygen system that burned through due to inadvertent electrical current from a short circuit in an adjacent audio select panel. An electrical current went through the support structure to a flightcrew mask stowage box. This caused the spring inside the low- pressure oxygen hose to act as an electrical conductor and heat up, causing the hose to burn through. This condition, if not corrected, could cause the low-pressure flex-hose of the flightcrew or supernumerary oxygen system to melt or burn, resulting in oxygen system leakage and smoke or fire.
Relevant Service Information
We have reviewed Boeing Service Bulletins 757-35A0015, Revision 2; and 757-35A0016, Revision 1; both dated June 15, 2000. The service bulletins describe procedures for replacing the existing low-pressure flex-hoses of the flightcrew and supernumerary oxygen system installed under the oxygen mask stowage box at the flightcrew and supernumerary oxygen mask location with new non-conductive low-pressure flex-hoses of the oxygen system.
FAA's Determination and Requirements of This Proposed AD
We are proposing this AD because we evaluated all relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of these same type designs. This proposed AD would require accomplishing the actions specified in the service information described previously, except as discussed under ``Differences Between the Proposed AD and the Service
Bulletins.''
Page 49828
Differences Between the Proposed AD and the Service Bulletins
Although Boeing Service Bulletins 757-35A0015, Revision 2; and 757- 35A0016, Revision 1; both dated June 15, 2000; recommend accomplishing the replacement ``at the earliest opportunity when manpower, material and facilities are available,'' we have determined that this imprecise compliance time would not address the identified unsafe condition in a timely manner. In developing an appropriate compliance time for this proposed AD, we considered not only the manufacturer's recommendation, but the degree of urgency associated with addressing the subject unsafe condition, the average utilization of the affected fleet, and the time necessary to perform the modifications. In light of all of these factors, we find a compliance time of 36 months for completing the required actions to be warranted, in that it represents an appropriate interval of time for affected airplanes to continue to operate without compromising safety. This difference has been coordinated with Boeing.
Boeing Service Bulletin 757-35A0015, Revision 2, dated June 15, 2000, lists Boeing Model 757-200C in the Effectivity paragraph; however, we have confirmed with Boeing that its intent was to list
Boeing Model 757-200CB. We have included Model 757-200CB in the
Applicability paragraph of this proposed AD.
Other Rulemaking
The oxygen mask installations on certain Boeing Model 737, 747, and 767 airplanes are almost identical to those on the affected 757 airplanes. Therefore, all of these airplanes may be subject to the identified unsafe condition. We are considering similar rulemaking related to the identified unsafe condition for certain Boeing Model 737, 747, and 767 airplanes.
Costs of Compliance
We estimate that this proposed AD would affect 485 airplanes of
U.S. registry. We also estimate that it would take 1 work-hour per product to comply with this proposed AD. The average labor rate is $80 per work-hour. Based on these figures, we estimate the cost of this proposed AD to the U.S. operators to be $38,800, or $80 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation: 1. Is not a ``significant regulatory action'' under Executive Order 12866, 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979), and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
You can find our regulatory evaluation and the estimated costs of compliance in the AD Docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended] 2. The FAA amends Sec. 39.13 by adding the following new AD:
Boeing: Docket No. FAA-2009-0795; Directorate Identifier 2009-NM- 083-AD.
Comments Due Date
(a) We must receive comments by November 13, 2009.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Boeing Model 757-200, -200CB, -200PF, and
-300 series airplanes, certificated in any category; as identified in the service bulletins listed in Table 1 of this AD.
Table 1--Applicability
Boeing service bulletin--
Revision--
Dated--
Applicable model/series--
757-35A0015..................
2 June 15, 2000... 757-200, 757-200CB, 757-200PF 757-35A0016..................
1 June 15, 2000... 757-300
Subject
(d) Air Transport Association (ATA) of America Code 35: Oxygen.
Unsafe Condition
(e) This AD results from reports of a low-pressure flex-hose of a flightcrew oxygen system that burned through due to inadvertent electrical current from a short circuit in an adjacent audio select panel. We are issuing this AD to prevent inadvertent electrical current which can cause the low-pressure flex-hoses used in the flightcrew and supernumerary oxygen system to melt or burn, resulting in oxygen system leakage and smoke or fire.
Compliance
(f) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the actions have already been done.
Inspection
(g) Within 36 months after the effective date of this AD, do an inspection to determine whether any low-pressure flex-hose of the flightcrew and supernumerary oxygen systems installed under the oxygen mask stowage location has a part number identified in Table 2 of this AD. A review of airplane maintenance records is acceptable in lieu of this inspection if the part number of
Page 49829
the low-pressure flex-hoses of the flightcrew and supernumerary oxygen system can be conclusively determined from that review.
(1) For any hose having a part number identified in Table 2 of this AD, before further flight, replace the hose with a new or serviceable part, in accordance with the Accomplishment Instructions of the applicable service bulletin identified in Table 1 of this AD.
(2) For any hose not having a part number identified in Table 2 of this AD, no further action is required by this paragraph.
Parts Installation
(h) As of the effective date of this AD, no person may install a flightcrew or supernumerary oxygen hose with a part number identified in Table 2 of this AD on any airplane.
Table 2--Applicable Part Numbers
Equivalent Boeing supplier part Nos.--
Boeing specification part No.--
AVOX (formerly
Sierra Engineering
Spencer Fluid
Puritan Bennett
Hydraflow
Sierra
Engineering)
60B50059-70.........................................
835-01-70
9513-20S5-18.0
ZH784-20
38001-70
9513-835-01-70 60B50059-81.........................................
835-01-81
9513-20S5-24.0
ZH784-81
38001-81
9513-835-01-81
Actions Accomplished According to Previous Issue of Service Bulletin
(i) Actions accomplished before the effective date of this AD in accordance with Boeing Alert Service Bulletin 757-35A0015, dated
September 2, 1999, or Revision 1, dated November 11, 1999; or Boeing
Alert Service Bulletin 757-35A0016, dated November 11, 1999; are considered acceptable for compliance with the corresponding actions specified in this AD.
Alternative Methods of Compliance (AMOCs)
(j)(1) The Manager, Seattle Aircraft Certification Office (ACO),
FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to
ATTN: Robert Hettman, Aerospace Engineer, Cabin Safety and
Environmental Systems Branch, ANM-150S, FAA, Seattle ACO, 1601 Lind
Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917- 6457; fax (425) 917-6590. Or, e-mail information to 9-ANM-Seattle-
ACO-AMOC-Requests@faa.gov.
(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19.
Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office.
The AMOC approval letter must specifically reference this AD.
Issued in Renton, Washington, on September 18, 2009.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
FR Doc. E9-23421 Filed 9-28-09; 8:45 am
BILLING CODE 4910-13-P
