Airworthiness Directives; Bombardier, Inc. Airplanes
Federal Register, Volume 78 Issue 156 (Tuesday, August 13, 2013)
Federal Register Volume 78, Number 156 (Tuesday, August 13, 2013)
Proposed Rules
Pages 49227-49229
From the Federal Register Online via the Government Printing Office www.gpo.gov
FR Doc No: 2013-19534
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2013-0687; Directorate Identifier 2012-NM-118-AD
RIN 2120-AA64
Airworthiness Directives; Bombardier, Inc. Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for all Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This proposed AD was prompted by reports of burr marks on the primary wheels, and cracked rings on the primary wheel shaft, on certain horizontal stabilizer trim actuators (HSTAs). This proposed AD would require replacing certain HSTAs. We are proposing this AD to prevent burr marks on the primary wheels, and cracked rings on the primary wheel shaft, on certain HSTAs, which may lead to a disconnect of the pitch trim surface and subsequent loss of pitch control, resulting in loss of control of the airplane.
DATES: We must receive comments on this proposed AD by September 27, 2013.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Bombardier, Inc., 400 Cocircte-Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-
227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Cesar Gomez, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone (516) 228-7318; fax (516) 794-5531.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2013-0687; Directorate Identifier 2012-NM-118-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the
Page 49228
closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
Transport Canada Civil Aviation, which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-2012-18, dated May 29, 2012 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for the specified products. The MCAI states:
It was discovered that a number of primary wheels on the HSTA P/
N part number 601R92305-5 (or vendor P/N 8396-4) had burr marks. Investigation revealed that the burr marks were a result of incorrectly using the manufacturing process. In addition, some rings that were fitted on the primary wheel shaft were found cracked. If not corrected, this condition may lead to a disconnect of the pitch trim surface and subsequent loss of pitch control.
This Canadian AD mandates the removal of the affected units that have the above described manufacturing defect.
Corrective actions include replacement of certain HSTAs. You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information
Bombardier has issued Service Bulletin 601R-27-159, dated June 15, 2011. The actions described in this service bulletin are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Differences Between This AD and the MCAI or Service Information
While the Applicability of Transport Canada Civil Aviation (TCCA) Canadian AD CF-2012-18, dated May 29, 2012, is Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes, serial numbers 7003 and subsequent, equipped with HSTAs having P/N 601R92305-5 or vendor P/N 8396-4, with serial numbers (S/N)s 287, 724, 813, 841, 998, 1031, 1035, 1049, 1053, 1067, 1068, 1136, 1252, 1268, 1303, 1319, 1338, 1354, 1374, 1378, 1445, 1470, 1498, 1513, 1546, 1632, 1736, 1766, 1846, 1849, 2002 through 2009, 2011, 2013 through 2016, 2019, 2020, and 2022; the applicability of this AD is for all Bombardier, Inc. Model CL-600-
2B19 (Regional Jet Series 100 & 440) airplanes. This has been coordinated with TCCA.
While TCCA Canadian AD CF-2012-18, dated May 29, 2012, does not allow for a records review to verify part numbers, paragraph (g) of this AD does allow for a records review to be used to verify part numbers.
Costs of Compliance
We estimate that this proposed AD affects 575 airplanes of U.S. registry.
We estimate the following costs to comply with this proposed AD:
Estimated Costs
----------------------------------------------------------------------------------------------------------------
Cost per Cost on U.S.
Action Labor cost Parts cost product operators
----------------------------------------------------------------------------------------------------------------
Replacement....................... 19 work-hours x $85 per $0 $1,615 $928,625
hour = $1,615.
----------------------------------------------------------------------------------------------------------------
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
-
Is not a ``significant regulatory action'' under Executive Order 12866;
-
Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
-
Will not affect intrastate aviation in Alaska; and
-
Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
-
The FAA amends Sec. 39.13 by adding the following new AD:
Page 49229
Bombardier, Inc.: Docket No. FAA-2013-0687; Directorate Identifier 2012-NM-118-AD.
(a) Comments Due Date
We must receive comments by September 27, 2013.
(b) Affected ADs
None.
(c) Applicability
This AD applies to all Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes, certificated in any category.
(d) Subject
Air Transport Association (ATA) of America Code 27, Flight Controls.
(e) Reason
This AD was prompted by reports of burr marks on the primary wheels, and cracked rings on the primary wheel shaft, on certain HSTAs. We are issuing this AD to prevent burr marks on the primary wheels, and cracked rings on the primary wheel shaft, on certain HSTAs, which may lead to a disconnect of the pitch trim surface and subsequent loss of pitch control, resulting in loss of control of the airplane.
(f) Compliance
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Inspection
Within 1,000 flight hours or 4 months after the effective date of this AD, whichever occurs first, inspect to determine if any HSTA having part number (P/N) 601R92305-5 or vendor P/N 8396-4, with serial numbers (S/N)s 287, 724, 813, 841, 998, 1031, 1035, 1049, 1053, 1067, 1068, 1136, 1252, 1268, 1303, 1319, 1338, 1354, 1374, 1378, 1445, 1470, 1498, 1513, 1546, 1632, 1736, 1766, 1846, 1849, 2002 through 2009, 2011, 2013 through 2016, 2019, 2020, and 2022 is installed. A review of airplane maintenance records is acceptable in lieu of this inspection if the part number of the HSTA can be conclusively determined from that review.
(h) Replacement
Within 1,000 flight hours or 4 months after the effective date of this AD, whichever occurs first, replace the affected HSTAs identified in paragraph (g) of this AD, with a serviceable HSTA, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 601R-27-159, dated June 15, 2011.
(i) Parts Installation Limitations
As of the effective date of this AD, no person may install any HSTA having P/N 601R92305-5 or vendor P/N 8396-4 with a S/N listed in paragraph (g) of this AD, unless the S/N has the suffix ``A'' beside it.
(j) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office, (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(k) Related Information
(1) Refer to Mandatory Continuing Airworthiness Information Canadian Airworthiness Directive CF-2012-18, dated May 29, 2012, for related information, which can be found in the AD docket on the internet at http://www.regulations.gov.
(2) For service information identified in this AD, contact Bombardier, Inc., 400 Cocircte-Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-
7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
Issued in Renton, Washington, on August 6, 2013.
Jeffrey E. Duven,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2013-19534 Filed 8-12-13; 8:45 am
BILLING CODE 4910-13-P
