Airworthiness Directives; Bombardier, Inc. Airplanes
Federal Register, Volume 80 Issue 89 (Friday, May 8, 2015)
Federal Register Volume 80, Number 89 (Friday, May 8, 2015)
Proposed Rules
Pages 26490-26492
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2015-10947
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2015-0929; Directorate Identifier 2014-NM-218-AD
RIN 2120-AA64
Airworthiness Directives; Bombardier, Inc. Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model BD-100-1A10 (Challenger 300) airplanes. This proposed AD was prompted by multiple reports of chafing found on an electrical wiring harness in the aft equipment bay, caused by contact between the wiring harness and a neighboring hydraulic line. This proposed AD would require an inspection, repair if necessary, and modification of the wiring harness installation to ensure that the wiring harness routing is correct and a minimum clearance between the wire and the hydraulic line is maintained. We are proposing this AD to detect and correct chafing on an electrical wiring harness, which could cause an electrical short circuit or lead to a malfunction of the flight control system, the engine indication system, or the hydraulic power control system, and adversely affect the continued safe operation and landing of the airplane.
DATES: We must receive comments on this proposed AD by June 22, 2015.
ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Bombardier, Inc., 400 Cocircte Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone: 514-855-5000; fax: 514-855-7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
0929; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Assata Dessaline, Aerospace Engineer, Avionics and Service Branch, ANE-172, FAA, New York Aircraft Certification Office, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: 516-228-7301; fax: 516-794-5531.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2015-0929; Directorate Identifier 2014-NM-218-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-
2014-32, dated September 8, 2014 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for certain Bombardier, Inc. Model BD-100-
1A10 (Challenger 300) airplanes. The MCAI states:
There have been multiple in-service reports of chafing found on an electrical wiring harness in the aft equipment bay. An investigation determined that the chafing was attributed to contact between the wiring harness and a neighboring hydraulic line. This chafing could cause an electrical short circuit or lead to a malfunction of the flight control system, the engine indication system, or the hydraulic power control system; which could adversely affect the continued safe operation and landing of the aeroplane.
This Canadian AD mandates the inspection general visual inspection, rectification as required repair of damage (including wear and chafing), and modification of the wiring harness installation to ensure the correct wiring routing and a minimum clearance between the wire and the hydraulic line is maintained.
You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
0929.
Related Service Information Under 1 CFR Part 51
Bombardier, Inc. has issued Service Bulletin 100-24-24, dated June 6, 2014. The service information describes procedures for an inspection, repair if necessary, and modification to reroute wiring harness installation to prevent contact with the hydraulic line. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of this NPRM.
Page 26491
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance
We estimate that this proposed AD affects 107 airplanes of U.S. registry.
We also estimate that it would take about 4 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $64 per product. Based on these figures, we estimate the cost of this proposed AD on U.S. operators to be $43,228, or $404 per product.
We have received no definitive data that would enable us to provide cost estimates for the on-condition actions specified in this proposed AD. We have no way of determining the number of aircraft that might need these actions.
According to the manufacturer, all of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all costs in our cost estimate.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a ``significant regulatory action'' under Executive Order 12866;
2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
2. The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
Bombardier, Inc.: Docket No. FAA-2015-0929; Directorate Identifier 2014-NM-218-AD.
(a) Comments Due Date
We must receive comments by June 22, 2015.
(b) Affected ADs
None.
(c) Applicability
This AD applies to Bombardier, Inc. Model BD-100-1A10 (Challenger 300) airplanes, certificated in any category, having serial numbers 20003 through 20382 inclusive, 20384, and 20386.
(d) Subject
Air Transport Association (ATA) of America Code 24, Electrical Power.
(e) Reason
This AD was prompted by multiple reports of chafing found on an electrical wiring harness in the aft equipment bay, caused by contact between the wiring harness and a neighboring hydraulic line. We are issuing this AD to detect and correct chafing on an electrical wiring harness which could cause an electrical short circuit or lead to a malfunction of the flight control system, the engine indication system, or the hydraulic power control system; which could adversely affect the continued safe operation and landing of the airplane.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Inspection, Repair, and Preventive Modification
Within 36 months after the effective date of this AD, do the actions required by paragraph (g)(1) and (g)(2) of this AD.
(1) Do a one-time general visual inspection to detect damage (including wear and chafing) of the wiring harness, in accordance with the Accomplishment Instructions of Bombardier, Inc. Service Bulletin 100-24-24, dated June 6, 2014. Repair any damage before further flight, in accordance with the Accomplishment Instructions of Bombardier, Inc. Service Bulletin 100-24-24, dated June 6, 2014; except, where Bombardier, Inc. Service Bulletin 100-24-24, dated June 6, 2014, specifies to contact Bombardier for repair instructions, repair using a method approved by the Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA; or Transport Canada Civil Aviation (TCCA); or Bombardier, Inc.'s TCCA Design Approval Organization (DAO).
(2) Modify the wiring harness routing in accordance with the Accomplishment Instructions of Bombardier, Inc. Service Bulletin 100-24-24, dated June 6, 2014.
(h) Definition of General Visual Inspection
For the purposes of this AD, a general visual inspection is a visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made from within touching distance unless otherwise specified. A mirror may be necessary to ensure visual access to all surfaces in the inspection area. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or droplight and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.
(i) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York ACO, ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local
Page 26492
Flight Standards District Office, as appropriate. If sending information directly to the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone: 516-228-7300; fax: 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/
certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, New York ACO, ANE-170, FAA; or TCCA; or Bombardier, Inc.'s TCCA DAO. If approved by the DAO, the approval must include the DAO-authorized signature.
(j) Related Information
(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian Airworthiness Directive CF-2014-32, dated September 8, 2014, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-0929.
(2) For service information identified in this AD, contact Bombardier, Inc., 400 Cocircte-Vertu Road West, Dorval, Queacutebec H4S 1Y9, Canada; telephone: 514-855-5000; fax: 514-
855-7401; email thd.crj@aero.bombardier.com; Internet http://www.bombardier.com. You may view this service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.
Issued in Renton, Washington, on April 13, 2015.
Michael Kaszycki,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2015-10947 Filed 5-7-15; 8:45 am
BILLING CODE 4910-13-P
