Airworthiness directives: Dornier,
[Federal Register: May 5, 2004 (Volume 69, Number 87)]
[Rules and Regulations]
[Page 24953-24954]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr05my04-13]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
[Docket No. 2003-NM-263-AD; Amendment 39-13605; AD 2004-09-16]
RIN 2120-AA64
Airworthiness Directives; Dornier Model 328-100 and -300 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to all Dornier Model 328-100 and -300 series airplanes, that requires repetitive inspections of the bearing lugs of the rudder spring tab lever assembly for cracking, and corrective action if necessary. This action is necessary to prevent failure of the rudder flight control system due to such cracking, which could result in loss of rudder control and consequent reduced controllability of the airplane. This action is intended to address the identified unsafe condition.
DATES: Effective June 9, 2004.
The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of June 9, 2004.
ADDRESSES: The service information referenced in this AD may be obtained from AvCraft Aerospace GmbH, P.O. Box 1103, D-82230 Wessling, Germany. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http// http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html .
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2125; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to all Dornier Model 328-100 and -300 series airplanes was published in the Federal Register on March 5, 2004 (69 FR 10381). That action proposed to require repetitive inspections of the bearing lugs of the rudder spring tab lever assembly for cracking, and corrective action if necessary.
Comments
We provided the public the opportunity to participate in the development of this AD. No comments have been submitted on the proposed AD or on the determination of the cost to the public.
Conclusion
We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.
Cost Impact
We estimate that 112 airplanes of U.S. registry will be affected by this AD, that it will take about 1 work hour per airplane to do the inspections, and that the average labor rate is $65 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $7,280, or $65 per airplane, per inspection cycle.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
Regulatory Impact
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
[[Page 24954]]
For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
0 Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0 2. Section 39.13 is amended by adding the following new airworthiness directive:
2004-09-16 Fairchild Dornier GmbH (Formerly Dornier Luftfahrt GmbH): Amendment 39-13605. Docket 200-NM-263-AD.
Applicability: All Model 328-100 and -300 series airplanes, certificated in any category.
Compliance: Required as indicated, unless accomplished previously.
To prevent failure of the rudder flight control system due to cracking of the bearing lugs of the rudder spring tab lever assembly, which could result in loss of rudder control and consequent reduced controllability of the airplane, accomplish the following:
Repetitive Inspections
(a) Within 400 flight hours or 2 months after the effective date of this AD, whichever is first: Do detailed and eddy current inspections for cracking of the bearing lugs of the rudder spring tab lever assembly by doing all the actions per Paragraphs 2.A., 2.B., and 2.D. of the Accomplishment Instructions of Dornier Alert Service Bulletin ASB-328-27-036 (for Model 328-100 series airplanes); or ASB-328J-27-013 (for Model 328-300 series airplanes); both dated February 12, 2003; as applicable. If no cracking is found, repeat the inspections thereafter at intervals not to exceed 24 months.
Note 1: For the purposes of this AD, a detailed inspection is defined as: ``An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.''
Corrective Action/Repetitive Inspections
(b) If any cracking is found during any inspection required by paragraph (a) of this AD: Before further flight, replace the spring tab lever assembly with a new assembly by doing all the actions per Paragraph 2.C. of the Accomplishment Instructions of Dornier Alert Service Bulletin ASB-328-27-036; or ASB-328J-27-013, both dated February 12, 2003; as applicable. Repeat the inspections required by paragraph (a) of this AD thereafter at intervals not to exceed 24 months.
(c) Dornier Alert Service Bulletins ASB-328-27-036 and ASB-328J- 27-013, both dated February 12, 2003, recommend reporting crack findings and returning damaged lever assemblies to the manufacturer, but this AD does not contain such requirements.
Note 2: There is no terminating action available at this time for the repetitive inspections required by this AD.
Alternative Methods of Compliance
(d) In accordance with 14 CFR 39.19, the Manager, International Branch, FAA, ANM-116, Transport Airplane Directorate, is authorized to approve alternative methods of compliance for this AD.
Incorporation by Reference
(e) The actions shall be done in accordance with Dornier Alert Service Bulletin ASB-328-27-036, dated February 12, 2003; or Dornier Alert Service Bulletin ASB-328J-27-013, dated February 12, 2003; as applicable. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from AvCraft Aerospace GmbH, P.O. Box 1103, D-82230 Wessling, Germany. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, Call 202-741-6030, or go to: http// http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html .
Note 3: The subject of this AD is addressed in German airworthiness directives 2003-383 and 2003-384, both dated November 13, 2003.
Effective Date
(f) This amendment becomes effective on June 9, 2004.
Issued in Renton, Washington, on April 26, 2004. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 04-10022 Filed 5-4-04; 8:45 am]
BILLING CODE 4910-13-P
