Airworthiness directives: Fokker,

[Federal Register: June 27, 2001 (Volume 66, Number 124)]

[Proposed Rules]

[Page 34134-34136]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr27jn01-27]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2001-NM-24-AD]

RIN 2120-AA64

Airworthiness Directive; Fokker Model F27 Mark 100, 200, 300, 400, 500, 600, and 700 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

SUMMARY: This document proposes the adoption of a new airworthiness directive (AD) that is applicable to all Fokker Model F27 Mark 100, 200, 300, 400, 500, 600, and 700 series airplanes. This proposal would require a one-time

[[Page 34135]]

inspection for correct installation of the left- and right-hand fuel differential pressure (FDP) switches and for correct connection of the pressure sensing lines to the switches. It would also require corrective action, if necessary. This action is prompted by reports of incorrect installation of the FDP switches and the resulting cross- connection of the pressure sensing lines to those switches. This action is necessary to ensure that a warning light goes on when the fuel filter is partially blocked by ice, so that the blockage of the fuel filter does not increase, leading to reduced fuel flow to the engine and possibly to an engine flame-out. This action is intended to address the identified unsafe condition.

DATES: Comments must be received by July 27, 2001.

ADDRESSES: Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-24-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: 9-anm-nprmcomment@faa.gov. Comments sent via fax or the Internet must contain ``Docket No. 2001-NM-24-AD'' in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.

The service information referenced in the proposed rule may be obtained from Fokker Services B.V., P.O. Box 231, 2150 AE Nieuw-Vennep, the Netherlands. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington.

FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, International Branch, FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington 98055-4056; telephone (425) 227-2125; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.

Submit comments using the following format:

Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.

For each issue, state what specific change to the proposed AD is being requested.

Include justification (e.g., reasons or data) for each request.

Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filedin the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: ``Comments to Docket Number 2001-NM-24-AD.'' The postcard will be date stamped and returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket Number 2001-NM-24-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

Discussion

Fokker has issued an information sheet indicating that on several occasions fuel differential pressure (FDP) switches have been installed upside down in their mountings and, as a result, the pressure sensing lines to those switches have been cross-connected. With this incorrect installation, the light which warns the flight crew that the fuel filter is partially blocked by ice would not light up. Without this warning, blockage of the fuel filter could continue, leading to reduced fuel flow to the engine and possibly to an engine flame-out. Fokker has also introduced changes to the F27 Maintenance Manual to emphasize the correct position of the fuel differential pressure switch and identification of the fuel lines to the switch.

Explanation of Relevant Service Information

Fokker has issued Service Bulletin F27/28-63, dated November 21, 1999, which describes procedures for a one-time inspection for correct installation of the left- and right-hand FDP switches, correct connection of the pressure sensing lines to the FDP switches, and corrective action, if necessary.

U.S. Type Certification of the Airplane

These airplane models are manufactured in the Netherlands and are type certificated for operation in the United States under the provisions of Sec. 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement.

Explanation of Requirements of Proposed Rule

Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.

Cost Impact

The FAA estimates that 44 airplanes of U.S. registry would be affected by this proposed AD, that it would take approximately 1 work hour per airplane to accomplish the proposed one-time inspection, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $2,640, or $60 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and

[[Page 34136]]

the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this proposed regulation (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

   Fokker Services B.V.: Docket 2001-NM-24-AD.

   Applicability: All Model F27 Mark 100, 200, 300, 400, 500, 600, and 700 series airplanes, certificated in any category.

   Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

   Compliance: Required as indicated, unless accomplished previously.

   To ensure that a warning light goes on when the fuel filter is partially blocked by ice, so that the blockage of the fuel filter does not continue, leading to reduced fuel flow to the engine and possibly to an engine flame-out, accomplish the following:

   Inspection

   (a) Within 60 days from the effective date of this AD: Perform a one-time general visual inspection for correct installation of the left-and right-hand fuel differential pressure (FDP) switches and for correct connection of the pressure sensing lines to the FDP switches, in accordance with the Accomplishment Instructions of Fokker Service Bulletin F27/28-63, dated November 21, 1999. If the switches are found to be installed incorrectly, as specified in the service bulletin, prior to further flight, re-install the switches and re-connect the pressure sensing lines to the switches, in accordance with the service bulletin.

   Note 2: For the purposes of this AD, a general visual inspection is defined as: ``A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or drop-light, and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.''

   Alternative Methods of Compliance

   (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

   Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

   Special Flight Permits

   (c) Special flight permits may be issued in accordance with Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

   Issued in Renton, Washington, on June 20, 2001. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 01-16052Filed6-26-01; 8:45 am]

   BILLING CODE 4910-13-U