Airworthiness Directives; Fokker Services B.V. Airplanes
Federal Register, Volume 80 Issue 85 (Monday, May 4, 2015)
Federal Register Volume 80, Number 85 (Monday, May 4, 2015)
Proposed Rules
Pages 25247-25249
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2015-10180
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2015-0933; Directorate Identifier 2014-NM-098-AD
RIN 2120-AA64
Airworthiness Directives; Fokker Services B.V. Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for all Fokker Services B.V. Model F.27 Mark 200, 300, 400, 500, 600, and 700 airplanes. This proposed AD was prompted by a design review, which revealed that no controlled bonding provisions are present on a number of critical locations inside the fuel tank or connected to the fuel tank wall; and no anti-spray cover is installed on the fuel shut-off valve (FSOV) in both wings. This proposed AD would require installing additional bonding provisions in the fuel tank, installing an anti-
spray cover on the FSOV, and revising the airplane maintenance program by incorporating fuel airworthiness limitation items and critical design configuration control limitations. We are proposing this AD to prevent an ignition source in the fuel tank vapor space, which could result in a fuel tank explosion and consequent loss of the airplane.
DATES: We must receive comments on this proposed AD by June 18, 2015.
ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
0933; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received and other information. The street address for the Docket Operations office (telephone 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1137; fax 425-227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2015-0933; Directorate Identifier 2014-NM-098-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the
Page 25248
closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA Airworthiness Directive 2014-0099, dated April 30, 2014 (referred to after this as the Mandatory Continuing Airworthiness Information, or ``the MCAI''), to correct an unsafe condition for all Fokker Services B.V. Model F.27 Mark 200, 300, 400, 500, 600, and 700 airplanes. The MCAI states:
Prompted by an accident * * *, the FAA published Special Federal Aviation Regulation (SFAR) 88, and the Joint Aviation Authorities (JAA) published Interim Policy INT/POL/25/12.
The review conducted by Fokker Services on the Fokker 27 design in response to these regulations revealed that no controlled bonding provisions are present on a number of critical locations, inside the fuel tank or connected to the fuel tank wall, and no anti-spray cover is installed on the Fueling Shut-Off Valve (FSOV) in both wings.
This condition, if not corrected, could create an ignition source in the fuel tank vapour space, possibly resulting in a fuel tank explosion and consequent loss of the aeroplane.
To address this potential unsafe condition, Fokker Services developed a set of bonding modifications and anti-spray covers, introduced with Service Bulletin (SB) SBF27-28-071 Revision 1 (R1), that require opening of the fuel tank access panels. More information on this subject can be found in Fokker Services All Operators Message AOF27.043#03.
For the reasons described above, this EASA AD requires installation of additional bonding provisions, and of anti-spray covers on the FSOV, that require opening of the fuel tank access panels.
Required actions also include revising the airplane maintenance program by incorporating fuel airworthiness limitation items and critical design configuration control limitations. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-0933.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
This proposed AD would require revisions to certain operator maintenance documents to include new actions (e.g., inspections) and Critical Design Configuration Control Limitations (CDCCLs). Compliance with these actions and CDCCLs is required by 14 CFR 91.403(c). For airplanes that have been previously modified, altered, or repaired in the areas addressed by this AD, the operator may not be able to accomplish the actions described in the revisions. In this situation, to comply with 14 CFR 91.403(c), the operator must request approval for an alternative method of compliance according to paragraph (j) of this AD. The request should include a description of changes to the required inspections that will ensure the continued operational safety of the airplane.
Costs of Compliance
We estimate that this proposed AD affects 15 airplanes of U.S. registry.
We estimate the following costs to comply with this proposed AD:
Estimated Costs
----------------------------------------------------------------------------------------------------------------
Cost per Cost on U.S.
Action Labor cost Parts cost product operators
----------------------------------------------------------------------------------------------------------------
Installation of bonding provisions, 70 work-hours x $85 per $0 $5,950 $89,250
anti-spray cover, and maintenance hour = $5,950.
program revision.
----------------------------------------------------------------------------------------------------------------
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
-
Is not a ``significant regulatory action'' under Executive Order 12866;
-
Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
-
Will not affect intrastate aviation in Alaska; and
-
Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Page 25249
Sec. 39.13 Amended
0
-
The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
Fokker Services B.V.: Docket No. FAA-2015-0933; Directorate Identifier 2014-NM-098-AD.
(a) Comments Due Date
We must receive comments by June 18, 2015.
(b) Affected ADs
None.
(c) Applicability
This AD applies to Fokker Services B.V. Model F.27 Mark 200, 300, 400, 500, 600, and 700 airplanes, certificated in any category, all serial numbers.
(d) Subject
Air Transport Association (ATA) of America Code 28, Fuel.
(e) Reason
This AD was prompted by a design review, which revealed that no controlled bonding provisions are present on a number of critical locations inside the fuel tank or connected to the fuel tank wall; and no anti-spray cover is installed on the fuel shut-off valve (FSOV) in both wings. We are issuing this AD to prevent an ignition source in the fuel tank vapor space, which could result in a fuel tank explosion and consequent loss of the airplane.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Installation of Bonding Provisions and Anti-Spray Cover
At the next scheduled opening of the fuel tanks after the effective date of this AD, but no later than 84 months after the effective date of this AD: Install additional bonding provisions at the applicable locations, and install an anti-spray cover on the FSOV in both wings, using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA.
(h) Revision of Maintenance or Inspection Program
Within 30 days after installing the bonding provisions and anti-
spray cover specified in paragraph (g) of this AD: Revise the airplane maintenance or inspection program, as applicable, by incorporating fuel airworthiness limitation items and Critical Design Configuration Control Limitations (CDCCLs), using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA.
(i) No Alternative Actions, Intervals, and/or CDCCLs
After accomplishing the revision required by paragraph (h) of this AD, no alternative actions (e.g., inspections), intervals, or CDCCLs may be used unless the actions, intervals, or CDCCLs are approved as an alternative method of compliance (AMOC) in accordance with the procedures specified in paragraph (j) of this AD.
(j) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch; ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; telephone 425-227-1137; fax 425-227-1137. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA; or the EASA; or Fokker Services B.V.'s EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.
(k) Related Information
Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA Airworthiness Directive 2014-0099, dated April 30, 2014, for related information. This MCAI may be found in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-0933.
Issued in Renton, Washington, on April 17, 2015.
Victor Wicklund,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
FR Doc. 2015-10180 Filed 5-1-15; 8:45 am
BILLING CODE 4910-13-P
