Airworthiness Directives; General Electric Company Turbofan Engines
Federal Register, Volume 81 Issue 90 (Tuesday, May 10, 2016)
Federal Register Volume 81, Number 90 (Tuesday, May 10, 2016)
Proposed Rules
Pages 28777-28778
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2016-10781
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2016-5872; Directorate Identifier 2016-NE-11-AD
RIN 2120-AA64
Airworthiness Directives; General Electric Company Turbofan Engines
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to adopt a new airworthiness directive (AD) for all General Electric Company (GE) GEnx-1B64/P2, -1B67/P2, -1B70/P2, -1B70C/
P2, -1B70/75/P2, and -1B74/75/P2 turbofan engines with engine assembly, part number (P/N) 2447M10G01 or P/N 2447M10G02, installed. This proposed AD was prompted by a report of a significant fan rub event. This proposed AD would require rework of the engine fan stator module assembly. We are proposing this AD to prevent failure of the fan blades and the load reduction device, loss of power to one or more engines, loss of thrust control, and loss of the airplane.
DATES: We must receive comments on this proposed AD by July 11, 2016.
ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this NPRM, contact General Electric Company, GE Aviation, Room 285, 1 Neumann Way, Cincinnati, OH 45215; phone: 513-552-3272; email: aviation.fleetsupport@ge.com. You may view this service information at the FAA, Engine & Propeller Directorate, 1200 District Avenue, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-
238-7125.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
5872; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Christopher McGuire, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 1200 District Avenue, Burlington, MA 01803; phone: 781-
238-7120; fax: 781-238-7199; email: chris.mcguire@faa.gov.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this NPRM. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2016-5872; Directorate Identifier 2016-NE-11-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this NPRM. We will consider all comments received by the closing date and may amend this NPRM because of those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this NPRM.
Discussion
We received a report of a significant fan rub event involving a GE GEnx-1B Performance Improvement Program 2 (PIP2) engine. The fan rub was caused by partial fan ice shedding. Asymmetric ice shedding can cause large fan imbalances leading to heavy tip rubs. The fan case geometry on PIP2 engines makes these engines susceptible to heavy fan tip rubs. This can cause substantial damage to the engine and an in-
flight non-restartable power loss. We are using calendar time for compliance in this AD because the failure mode is caused by exposure to specific environmental and operational conditions. This defines the overall fleet risk in terms of calendar time, rather than engine cycles or hours.
This condition, if not corrected, could result in failure of the fan blades and the load reduction device, loss of power to one or more engines, loss of thrust control, and loss of the airplane.
Related Service Information Under 1 CFR Part 51
We reviewed GE GEnx-1B Service Bulletin (SB) 72-0314 R00, dated April 1, 2016. The SB describes procedures for increasing the clearance of the fan stator module assembly. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.
FAA's Determination
We are proposing this NPRM because we evaluated all the relevant information and determined the unsafe condition described previously is likely
Page 28778
to exist or develop in other products of the same type design.
Proposed AD Requirements
This NPRM would require accomplishing the actions specified in the service information described previously.
Costs of Compliance
We estimate that this proposed AD will affect 89 engines installed on airplanes of U.S. registry. We also estimate that it will take about 40 hours per engine to comply with this proposed AD. The average labor rate is $85 per hour. Based on these figures, we estimate the total cost of this proposed AD to U.S. operators to be $302,600.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
(1) Is not a ``significant regulatory action'' under Executive Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
-
The FAA amends Sec. 39.13 by adding the following new airworthiness directive (AD):
General Electric Company: Docket No. FAA-2016-5872; Directorate Identifier 2016-NE-11-AD.
(a) Comments Due Date
We must receive comments by July 11, 2016.
(b) Affected ADs
None.
(c) Applicability
This AD applies to all General Electric Company (GE) GEnx-1B64/
P2, -1B67/P2, -1B70/P2, -1B70C/P2, -1B70/75/P2, and -1B74/75/P2 turbofan engines with engine assembly, part number (P/N) 2447M10G01 or P/N 2447M10G02, installed.
(d) Unsafe Condition
This AD was prompted by a report of a significant fan rub event. We are issuing this AD to prevent failure of the fan blades and the load reduction device, loss of power to one or more engines, loss of thrust control, and loss of the airplane.
(e) Compliance
Comply with this AD within the compliance times specified, unless already done.
(1) Modify the fan stator module assembly before December 31, 2016.
(2) Use paragraphs 3.B.(1) through 3.B.(6) or 3.C.(1) through 3.C.(6) of the Accomplishment Instructions of GE GEnx-1B Service Bulletin (SB) 72-0314 R00, dated April 1, 2016, to do the modification.
(f) Credit for Previous Action
You may take credit for the fan stator module assembly modification that is required by paragraph (e) of this AD if you performed the modification before the effective date of this AD using the Accomplishment Instructions, paragraphs 3.B. or 3.C., of GE GEnx-1B SB 72-0309 R00, dated March 11, 2016.
(g) Alternative Methods of Compliance (AMOCs)
The Manager, Engine Certification Office, FAA, may approve AMOCs to this AD. Use the procedures found in 14 CFR 39.19 to make your request. You may email your request to: ANE-AD-AMOC@faa.gov.
(h) Related Information
(1) For more information about this AD, contact Christopher McGuire, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 1200 District Avenue, Burlington, MA 01803; phone: 781-238-7120; fax: 781-238-7199; email: chris.mcguire@faa.gov.
(2) AD 2016-06-08 (81 FR 14704, March 18, 2016) and AD 2016-08-
12 (81 FR 23581, April 22, 2016) pertain to the subject of this proposed AD.
(3) GE GEnx-1B SB 72-0314 R00, dated April 1, 2016 can be obtained from GE using the contact information in paragraph (h)(4) of this proposed AD.
(4) For service information identified in this proposed AD, contact General Electric Company, GE Aviation, Room 285, 1 Neumann Way, Cincinnati, OH 45215; phone: 513-552-3272; email: aviation.fleetsupport@ge.com.
(5) You may view this service information at the FAA, Engine & Propeller Directorate, 1200 District Avenue, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.
Issued in Burlington, Massachusetts, on May 3, 2016.
Colleen M. D'Alessandro,
Manager, Engine & Propeller Directorate, Aircraft Certification Service.
FR Doc. 2016-10781 Filed 5-9-16; 8:45 am
BILLING CODE 4910-13-P
