Airworthiness directives: Learjet,

[Federal Register: November 1, 2000 (Volume 65, Number 212)]

[Rules and Regulations]

[Page 65257-65258]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr01no00-3]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-132-AD; Amendment 39-11950; AD 2000-22-04]

RIN 2120-AA64

Airworthiness Directives; Learjet Model 45 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to certain Learjet Model 45 series airplanes, that requires repetitive application of grease to the rotating disk assembly of the nose landing gear squat switch mechanism. Application of grease to the squat switch assembly is necessary to prevent moisture contamination and subsequent formation of ice. Such ice formation could result in bending or damaging of the nose landing gear squat switch assembly, which could drive the nose wheel to an uncommanded angle against the force of the steering system. This condition, if not corrected, could result in the airplane departing from the runway at high speeds during landing.

DATES: Effective December 6, 2000.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of December 6, 2000.

ADDRESSES: The service information referenced in this AD may be obtained from Learjet Inc., One Learjet Way, Wichita, Kansas 67209- 2942. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid- Continent Airport, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Shane Bertish, Aerospace Engineer, Systems and Equipment Branch, ACE-116W, FAA, Small Airplane Directorate, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas 67209; telephone (316) 946-4156; fax (316) 946-4407.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Learjet Model 45 series airplanes was published in the Federal Register on June 27, 2000 (65 FR 39578). That action proposed to require repetitive application of grease to the rotating disk assembly of the nose landing gear squat switch mechanism.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Interim Action

This is considered to be interim action. The manufacturer has advised that it currently is developing a modification that will positively address the unsafe condition addressed by this AD. Once this modification is developed and approved, and parts are available, the FAA may consider additional rulemaking.

Cost Impact

There are approximately 69 Learjet Model 45 series airplanes of the affected design in the worldwide fleet. The FAA estimates that 45 airplanes of U.S. registry will be affected by this AD, that it will take approximately 1 work hour per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $2,700, or $60 per airplane, per application.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of

[[Page 65258]]

the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

   2000-22-04 Learjet: Amendment 39-11950. Docket 2000-NM-132-AD.

   Applicability: Model 45 series airplanes, serial numbers 45-001 through 45-114 inclusive; certificated in any category.

   Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

   Compliance: Required as indicated, unless accomplished previously.

   To prevent the airplane from departing the runway at high speeds during landing due to bending and damage to the squat switch assembly of the nose landing gear, accomplish the following:

   Application of Grease

   (a) Within 30 days after the effective date of this AD, apply grease to the rotating disk assembly of the squat switch mechanism of the nose wheel in accordance with Bombardier Aerospace Service Information Letter SIL 32-016, dated March 30, 2000. Thereafter, repeat this application at intervals not to exceed 30 days.

   Alternative Methods of Compliance

   (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO.

   Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.

   Special Flight Permit

   (c) Special flight permits may be issued in accordance with Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

   Incorporation by Reference

   (d) The application of grease shall be done in accordance with Bombardier Aerospace Service Information Letter SIL 32-016, dated March 30, 2000. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Learjet Inc., One Learjet Way, Wichita, Kansas 67209-2942. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

   Effective Date

   (e) This amendment becomes effective on December 6, 2000.

   Issued in Renton, Washington, on October 23, 2000. Donald L. Riggin, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 00-27630Filed10-31-00; 8:45 am]

   BILLING CODE 4910-13-P