Airworthiness directives: McDonnell Douglas,
[Federal Register: May 17, 2006 (Volume 71, Number 95)]
[Proposed Rules]
[Page 28619-28622]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr17my06-16]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
[Docket No. FAA-2006-24780; Directorate Identifier 2006-NM-069-AD]
RIN 2120-AA64
Airworthiness Directives; McDonnell Douglas Model DC-10-10, DC- 10-10F, DC-10-15, DC-10-30, DC-10-30F (KC-10A and KDC-10), DC-10-40, and DC-10-40F Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).
ACTION: Notice of proposed rulemaking (NPRM).
SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain McDonnell Douglas airplanes, identified above. This proposed AD would require installing or replacing with improved parts, as applicable, the bonding straps between the metallic
[[Page 28620]]
frame of the fillet and the wing leading edge ribs, on both the left and right sides. This proposed AD results from fuel system reviews conducted by the manufacturer. We are proposing this AD to reduce the potential of ignition sources inside fuel tanks in the event of a severe lightning strike, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
DATES: We must receive comments on this proposed AD by July 3, 2006.
ADDRESSES: Use one of the following addresses to submit comments on this proposed AD.
DOT Docket Web site: Go to http://dms.dot.gov and follow
the instructions for sending your comments electronically.
Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your
comments electronically.
Mail: Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, room PL-401, Washington, DC 20590.
Fax: (202) 493-2251.
Hand Delivery: Room PL-401 on the plaza level of the Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Contact Boeing Commercial Airplanes, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024), for the service information identified in this proposed AD.
FOR FURTHER INFORMATION CONTACT: Samuel Lee, Aerospace Engineer, Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5262; fax (562) 627-5210.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to submit any relevant written data, views, or arguments regarding this proposed AD. Send your comments to an address listed in the ADDRESSES section. Include the docket number ``FAA-2006- 24780; Directorate Identifier 2006-NM-069-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the proposed AD. We will consider all comments received by the closing date and may amend the proposed AD in light of those comments.
We will post all comments we receive, without change, to http://dms.dot.gov , including any personal information you provide. We will
also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of that Web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78), or you may visit http://dms.dot.gov.
Examining the Docket
You may examine the AD docket on the Internet at http://dms.dot.gov , or in person at the Docket Management Facility office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Management Facility office (telephone (800) 647- 5227) is located on the plaza level of the Nassif Building at the DOT street address stated in the ADDRESSES section. Comments will be available in the AD docket shortly after the Docket Management System receives them.
Discussion
The FAA has examined the underlying safety issues involved in fuel tank explosions on several large transport airplanes, including the adequacy of existing regulations, the service history of airplanes subject to those regulations, and existing maintenance practices for fuel tank systems. As a result of those findings, we issued a regulation titled ``Transport Airplane Fuel Tank System Design Review, Flammability Reduction and Maintenance and Inspection Requirements'' (67 FR 23086, May 7, 2001). In addition to new airworthiness standards for transport airplanes and new maintenance requirements, this rule included Special Federal Aviation Regulation No. 88 (``SFAR 88,'' Amendment 21-78, and subsequent Amendments 21-82 and 21-83).
Among other actions, SFAR 88 requires certain type design (i.e., type certificate (TC) and supplemental type certificate (STC)) holders to substantiate that their fuel tank systems can prevent ignition sources in the fuel tanks. This requirement applies to type design holders for large turbine-powered transport airplanes and for subsequent modifications to those airplanes. It requires them to perform design reviews and to develop design changes and maintenance procedures if their designs do not meet the new fuel tank safety standards. As explained in the preamble to the rule, we intended to adopt airworthiness directives to mandate any changes found necessary to address unsafe conditions identified as a result of these reviews.
In evaluating these design reviews, we have established four criteria intended to define the unsafe conditions associated with fuel tank systems that require corrective actions. The percentage of operating time during which fuel tanks are exposed to flammable conditions is one of these criteria. The other three criteria address the failure types under evaluation: single failures, single failures in combination with a latent condition(s), and in-service failure experience. For all four criteria, the evaluations included consideration of previous actions taken that may mitigate the need for further action.
We have determined that the actions identified in this AD are necessary to reduce the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
Engineering review of the extended wing-to-fuselage fillet on certain McDonnell Douglas Model DC-10-10, DC-10-10F, DC-10-15, DC-10- 30, DC-10-30F (KC-10A and KDC-10), DC-10-40, and DC-10-40F airplanes revealed an increase in the nonmetallic area of the fillet. Engineering reviews of the conventional wing-to-fuselage fillet on certain of the same airplane models revealed that the support ribs of the fuselage- mounted fillet are not grounded, but should be. These conditions, in combination with a severe lightning strike and flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
Relevant Service Information
We have reviewed McDonnell Douglas DC-10 Service Bulletin 53-109, Revision 4, dated October 7, 1992 (for airplanes with extended wing-to- fuselage fillets); and McDonnell Douglas DC-10 Service Bulletin 53-111, Revision 3, dated August 24, 1992 (for airplanes with conventional wing-to-fuselage fillets). The service bulletins describe procedures for installing or replacing with improved parts, as applicable, the bonding straps between the metallic frame of the fillet and the wing leading edge ribs, on both the left and right sides. For airplanes with extended wing-to-fuselage fillets, the service bulletin indicates that there are
[[Page 28621]]
six bonding straps. For airplanes with conventional wing-to-fuselage fillets, the service bulletin indicates that there are ten bonding straps. Accomplishing the actions specified in the service information is intended to adequately address the unsafe condition.
FAA's Determination and Requirements of the Proposed AD
We have evaluated all pertinent information and identified an unsafe condition that is likely to exist or develop on other airplanes of this same type design. For this reason, we are proposing this AD, which would require accomplishing the actions specified in the service information described previously, except as discussed under ``Difference Between the Proposed AD and the Service Bulletins.''
Difference Between the Proposed AD and the Service Bulletins
McDonnell Douglas DC-10 Service Bulletin 53-109 recommends doing the installation or replacement at the earliest practical maintenance period, and McDonnell Douglas DC-10 Service Bulletin 53-111 recommends doing the installation or maintenance at the first convenient check, but no later than 7,500 flight-hours after receiving the service bulletin. We have determined that these intervals would not address the identified unsafe condition soon enough to ensure an adequate level of safety for the affected fleet. In developing an appropriate compliance time for this AD, we considered the manufacturer's recommendation, the degree of urgency associated with the subject unsafe condition, and the average utilization of the affected fleet. In light of all of these factors, we find that a compliance time of the earlier of 7,500 flight hours or 60 months after the effective date of this AD represents an appropriate interval of time for affected airplanes to continue to operate without compromising safety. This difference has been coordinated with Boeing, and Boeing concurs.
Costs of Compliance
There are about 457 airplanes of the affected design in the worldwide fleet. This proposed AD would affect about 280 airplanes of U.S. registry. The proposed actions would take between 9 and 17 work hours per airplane, at an average labor rate of $80 per work hour. Required parts would cost between $3,720 and $4,169 per airplane. Based on these figures, the estimated cost of the proposed AD is between $4,440 and $5,529 per airplane, or between $1,243,200 and $1,548,120 for the U.S.-registered fleet.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the proposed regulation:
-
Is not a ``significant regulatory action'' under Executive Order 12866;
-
Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
-
Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
-
The Federal Aviation Administration (FAA) amends Sec. 39.13 by adding the following new airworthiness directive (AD):
McDonnell Douglas: Docket No. FAA-2006-24780; Directorate Identifier 2006-NM-069-AD.
Comments Due Date
(a) The FAA must receive comments on this AD action by July 3, 2006.
Affected ADs
(b) None.
Applicability
(c) This AD applies to McDonnell Douglas Model DC-10-10, DC-10- 10F, DC-10-15, DC-10-30, DC-10-30F (KC-10A and KDC-10), DC-10-40, DC-10-40F, airplanes, certificated in any category; as identified in the applicable service bulletin listed in Table 1 of this AD.
Table 1.--Service Bulletins
Revision McDonnell Douglas DC-10 service bulletin level
Date
For airplanes with--
53-109..................................
4 October 7, 1992 Extended wing-to-fuselage fillets. 53-111..................................
3 August 24, 1992 Conventional wing-to-fuselage fillets.
[[Page 28622]]
Unsafe Condition
(d) This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to reduce the potential of ignition sources inside fuel tanks in the event of a severe lightning strike, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
Compliance
(e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
Installation or Replacement
(f) Within 7,500 flight hours or 60 months after the effective date of this AD, whichever occurs earlier: Install or replace with improved parts, as applicable, the bonding straps between the metallic frame of the fillet and the wing leading edge ribs, on both the left and right sides, in accordance with the Accomplishment Instructions of the applicable service bulletin identified in Table 1 of this AD.
Alternative Methods of Compliance (AMOCs)
(g)(1) The Manager, Los Angeles Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.
(2) Before using any AMOC approved in accordance with Sec. 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office.
Issued in Renton, Washington, on May 8, 2006. Ali Bahrami, Manager, Transport Airplane Directorate, Aircraft Certification Service. [FR Doc. E6-7476 Filed 5-16-06; 8:45 am]
BILLING CODE 4910-13-P
