Airworthiness directives: McDonnell Douglas,

[Federal Register: June 11, 2003 (Volume 68, Number 112)]

[Proposed Rules]

[Page 34849-34851]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr11jn03-31]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2002-NM-103-AD]

RIN 2120-AA64

Airworthiness Directives; McDonnell Douglas MD-90-30 Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

SUMMARY: This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model MD-90-30 airplanes. This proposal would require a one-time general visual inspection of the circuit breakers to determine if discrepant circuit breakers are installed, and corrective action if necessary. This action is necessary to prevent internal overheating and arcing of circuit breakers and airplane wiring due to long-term use and breakdown of internal components of the circuit breakers, which could result in smoke and fire in the flight compartment and main cabin. This action is intended to address the identified unsafe condition.

DATES: Comments must be received by July 28, 2003.

ADDRESSES: Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2002-NM-103-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

[[Page 34850]]

Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: 9-anm-nprmcomment@faa.gov. Comments sent via fax or the Internet must contain ``Docket No. 2002- NM-103-AD'' in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 or 2000 or ASCII text.

The service information referenced in the proposed rule may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California.

FOR FURTHER INFORMATION CONTACT: George Mabuni, Aerospace Engineer, Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5341; fax (562) 627-5210.

SUPPLEMENTARY INFORMATION:

Comments Invited

Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.

Submit comments using the following format:

[sbull] Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.

[sbull] For each issue, state what specific change to the proposed AD is being requested.

[sbull] Include justification (e.g., reasons or data) for each request.

Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: ``Comments to Docket Number 2002-NM-103-AD.'' The postcard will be date stamped and returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2002-NM-103-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

Discussion

As part of its practice of re-examining all aspects of the service experience of a particular aircraft whenever an accident occurs, the FAA has become aware of incidents of smoke and electrical odor in the flight compartment and cabin area of McDonnell Douglas Model DC-9-81, - 82, and -83 airplanes. Investigation revealed that long-term use and breakdown of the internal components of circuit breakers manufactured by Wood Electric Corporation or Wood Electric Division of Potter Brumfield Corporation contributed to internal overheating and arcing of the circuit breakers. This condition, if not corrected, could result in smoke and fire in the flight compartment and main cabin.

Although no Model MD-90-30 airplanes were delivered with circuit breakers manufactured by Wood Electric Corporation or Wood Electric Division of Potter Brumfield Corporation, they may have been installed during maintenance. Therefore, these models may be subject to this same unsafe condition.

Explanation of Relevant Service Information

The FAA has reviewed and approved Boeing Alert Service Bulletin MD90-24A081, Revision 01, dated March 7, 2003. (The original issue of the service bulletin specified installation of incorrect circuit breakers for the Wood Electric circuit breakers, if installed.) Revision 01 of the service bulletin describes procedures for a one-time visual inspection to determine if discrepant circuit breakers are installed (includes circuit breakers manufactured by Wood Electric and Wood Electric Division of Potter Brumfield Corporations, and incorrect circuit breakers installed per Boeing Alert Service Bulletin MD90- 24A081, dated February 14, 2002), and replacement of any discrepant circuit breaker with a new, approved circuit breaker. Accomplishment of the actions specified in Revision 01 of the service bulletin is intended to adequately address the identified unsafe condition.

Explanation of Requirements of Proposed Rule

Since an unsafe condition has been identified that is likely to exist or develop on other products of this same type design, the proposed AD would require accomplishment of the actions specified in Revision 01 of the service bulletin described previously.

Changes to 14 CFR Part 39/Effect on the Proposed AD

On July 10, 2002, the FAA issued a new version of 14 CFR part 39 (67 FR 47997, July 22, 2002), which governs the FAA's airworthiness directives system. The regulation now includes material that relates to altered products, special flight permits, and alternative methods of compliance. Because we have now included this material in part 39, we no longer need to include it in each individual AD.

Cost Impact

There are approximately 126 airplanes of the affected design in the worldwide fleet. The FAA estimates that 21 airplanes of U.S. registry would be affected by this proposed AD, that it would take approximately 20 work hours per airplane to accomplish the proposed inspection of the circuit breakers (over 700 installed on each airplane), and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $25,200, or $1,200 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up,

[[Page 34851]]

planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this proposed regulation (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

   McDonnell Douglas: Docket 2002-NM-103-AD.

   Applicability: Model MD-90-30 airplanes, as listed in Boeing Alert Service Bulletin MD90-24A081, Revision 01, dated March 7, 2003; certificated in any category.

   Compliance: Required as indicated, unless accomplished previously.

   To prevent internal overheating and arcing of circuit breakers and airplane wiring due to long-term use and breakdown of internal components of the circuit breakers, which could result in smoke and fire in the flight compartment and main cabin, accomplish the following:

   Inspection and Replacement

   (a) Within 18 months after the effective date of this AD: Perform a one-time general visual inspection of the circuit breakers to determine if discrepant circuit breakers are installed (includes circuit breakers manufactured by Wood Electric and Wood Electric Division of Brumfield Potter Corporations, and incorrect circuit breakers installed per Boeing Alert Service Bulletin MD90-24A081, dated February 14, 2002), per Boeing Alert Service Bulletin MD90- 24A081, Revision 01, dated March 7, 2003.

   Note 1: For the purposes of this AD, a general visual inspection is defined as: ``A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made from within touching distance unless otherwise specified. A mirror may be necessary to enhance visual access to all exposed surfaces in the inspection area. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or droplight and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.''

   (1) If no discrepant circuit breaker is found: No further action is required by this paragraph.

   (2) If any discrepant circuit breaker is found: Before further flight, replace the circuit breaker with a new, approved circuit breaker, per the service bulletin.

   Part Installation

   (b) As of the effective date of this AD, no person shall install a circuit breaker manufactured by Wood Electric Corporation or Wood Electric Division of Potter Brumfield Corporation on any airplane.

   Alternative Methods of Compliance

   (c) In accordance with 14 CFR 39.19, the Manager, Los Angeles Aircraft Certification Office, FAA, is authorized to approve alternative methods of compliance for this AD.

   Issued in Renton, Washington, on June 5, 2003. Ali Bahrami, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 03-14674 Filed 6-10-03; 8:45 am]

   BILLING CODE 4910-13-P