Airworthiness directives: McDonnell Douglas,

[Federal Register: August 31, 2001 (Volume 66, Number 170)]

[Proposed Rules]

[Page 45948-45949]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr31au01-13]

Proposed Rules Federal Register

This section of the FEDERAL REGISTER contains notices to the public of the proposed issuance of rules and regulations. The purpose of these notices is to give interested persons an opportunity to participate in the rule making prior to the adoption of the final rules.

[[Page 45948]]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2001-NM-149-AD]

RIN 2120-AA64

Airworthiness Directives; McDonnell Douglas Model MD-90-30 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

SUMMARY: This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model MD-90-30 series airplanes. This proposal would require an inspection of the aft galley power feeder wire assembly for riding, chafing, and damage located above the main cabin, left side, overwing ceiling panels; and follow-on actions. This action is necessary to prevent damage to the electrical wire insulation of the aft galley power feeder wires, electrical arcing, and potential smoke and/or fire. This action is intended to address the identified unsafe condition.

DATES: Comments must be received by October 15, 2001.

ADDRESSES: Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-149-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: 9-anm-nprmcomment@faa.gov. Comments sent via fax or the Internet must contain ``Docket No. 2001-NM-149-AD'' in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.

The service information referenced in the proposed rule may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California.

FOR FURTHER INFORMATION CONTACT: George Y. Mabuni, Aerospace Engineer, Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5341; fax (562) 627-5210.

SUPPLEMENTARY INFORMATION:

Comments Invited

Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.

Submit comments using the following format:

Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.

For each issue, state what specific change to the proposed AD is being requested.

Include justification (e.g., reasons or data) for each request.

Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filedin the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: ``Comments to Docket Number 2001-NM-149-AD.'' The postcard will be date stamped and returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-149-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

Discussion

The FAA has received a report indicating that the aft galley power feeder wires were found to be riding on the main cabin ceiling supports located in the overwing area. This condition, if not corrected, could result in damage to the electrical wire insulation, electrical arcing, and potential smoke and/or fire.

Explanation of Relevant Service Information

The FAA has reviewed and approved McDonnell Douglas Alert Service Bulletin MD90-24A046, Revision 02, dated March 26, 2001, which describes procedures for a one-time general visual inspection of the aft galley power feeder wire assembly for riding, chafing, and damage located above the main cabin, left side, overwing ceiling panels; and follow-on actions. The follow-on actions include repair of any damage on the outer cable jacket or primary insulation, installation of a splice on the power feeder cable to remove damage, installation of sleeving over the affected area, and a functional test of the galley equipment, as applicable. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition.

Explanation of Requirements of Proposed Rule

Since an unsafe condition has been identified that is likely to exist or develop on other products of this same type design, the proposed AD would

[[Page 45949]]

require accomplishment of the actions specified in the service bulletin described previously.

Cost Impact

There are approximately 26 Model MD-90-30 series airplanes of the affected design in the worldwide fleet. The FAA estimates that 17 airplanes of U.S. registry would be affected by this proposed AD.

It would take approximately 1 work hour per airplane to accomplish the proposed inspection, at an average labor rate of $60 per work hour. Based on these figures, the cost impact of the proposed inspection on U.S. operators is estimated to be $1,020, or $60 per airplane.

It would take approximately 2 work hours per airplane to accomplish the proposed modification, at an average labor rate of $60 per work hour. Based on these figures, the cost impact of the proposed modification on U.S. operators is estimated to be $2,040, or $120 per airplane.

The cost impact figures discussed above are based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this proposed regulation (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Safety.

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

   McDonnell Douglas: Docket 2001-NM-149-AD.

   Applicability: Model MD-90-30 series airplanes, certificated in any category; as identified in McDonnell Douglas Alert Service Bulletin MD90-24A046, Revision 02, dated March 26, 2001.

   Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

   Compliance: Required as indicated, unless accomplished previously.

   To prevent damage to the electrical wire insulation of the aft galley power feeder wires, electrical arcing, and potential smoke and/or fire, accomplish the following:

   Inspection and Follow-On Actions

   (a) Within 90 days after the effective date of this AD, do a one-time general visual inspection of the aft galley power feeder wire assembly for riding, chafing, and damage located above the main cabin, left side, overwing ceiling panels-particularly near the ends of the ceiling supports-in accordance with the Accomplishment Instructions of McDonnell Douglas Alert Service Bulletin MD90- 24A046, Revision 02, dated March 26, 2001.

   Note 2: For the purposes of this AD, a general visual inspection is defined as ``A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or drop-light, and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.''

   Condition 1: Damage to Outer Cable Jacket or Primary Insulation

   (1) If any damage to the outer cable jacket or the primary insulation is found, prior to further flight, repair the scuffed jacket or insulation; and modify the galley power feeder cable installation by installing sleeving over the wire assembly per the alert service bulletin.

   Condition 2: Damage to Power Feeder Cable Conductor

   (2) If any damage to the power feeder cable conductor is found, prior to further flight, repair the damaged cable by installing a splice at the damaged location; modify the galley power feeder cable installation by installing sleeving over the wire assembly; and do a functional test of the galley equipment; per the alert service bulletin.

   Condition 3: No Damage

   (3) If no damage is found, prior to further flight, modify the galley power feeder cable installation by installing sleeving over the wire assembly; per the alert service bulletin.

   Note 3: Accomplishment of the actions required by this AD per McDonnell Douglas Alert Service Bulletin MD90-24A046, dated July 31, 1997; or Revision 01, dated February 16, 1998; is acceptable for compliance with the requirements of this AD.

   Alternative Methods of Compliance

   (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Manager, Los Angeles Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO.

   Note 4: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.

   Special Flight Permit

   (c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

   Issued in Renton, Washington, on August 24, 2001. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 01-21973Filed8-30-01; 8:45 am]

   BILLING CODE 4910-13-P