Airworthiness Directives; Pacific Aerospace Limited Airplanes
Federal Register, Volume 81 Issue 150 (Thursday, August 4, 2016)
Federal Register Volume 81, Number 150 (Thursday, August 4, 2016)
Rules and Regulations
Pages 51330-51332
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2016-18265
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2016-8838; Directorate Identifier 2016-CE-020-AD; Amendment 39-18601; AD 2016-16-03
RIN 2120-AA64
Airworthiness Directives; Pacific Aerospace Limited Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Final rule; request for comments.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for Pacific Aerospace Limited Models FU24-954 and FU24A-954 airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as cracked elevator torque tubes. We are issuing this AD to require actions to address the unsafe condition on these products.
DATES: This AD is effective September 8, 2016.
The Director of the Federal Register approved the incorporation by reference of certain publication listed in this AD as of September 8, 2016.
We must receive comments on this AD by September 19, 2016.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this AD, contact Pacific Aerospace Limited, Airport Road, Hamilton, Private Bag 3027, Hamilton 3240, New Zealand; telephone: +64 7 843 6144; facsimile: +64 7 843 6134; email: pacific@aerospace.co.nz; Internet: www.aerospace.co.nz. You may review copies of the referenced service information at the FAA, Small Airplane
Page 51331
Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148. It is also available on the Internet at http://www.regulations.gov by searching for locating Docket No. FAA-2016-8838.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-
8838; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4123; fax: (816) 329-4090; email: karl.schletzbaum@faa.gov.
SUPPLEMENTARY INFORMATION:
Discussion
The Civil Aviation Authority (CAA), which is the aviation authority for New Zealand, has issued AD No. DCA/FU24/184, dated July 7, 2016 (referred to after this as ``the MCAI''), to correct an unsafe condition for Pacific Aerospace Limited Models FU24-954 and FU24A-954 airplanes and was based on mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country. The MCAI states:
This AD is prompted by two reports received by the CAA of finding a crack in the elevator torque tube on two Cresco 08-600 aircraft. The same P/N elevator torque tube if fitted to FU24 and FU24A series aircraft. The AD is issued to prevent failure of the elevator torque tube due to possible fatigue, which could result in cracks, and loss of elevator and aileron control.
The MCAI requires inspecting the elevator torque tube for cracks and replacing the elevator torque tube is any cracks are found. You may examine the MCAI on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-8838.
Related Service Information Under 1 CFR Part 51
Pacific Aerospace Limited (previously Pacific Aerospace Corporation Ltd.) has issued Chapter 27, Flight Controls, dated May 1980, of the Maintenance Manual for the Fletcher FU24 and FU24A Post-954. The information in Chapter 27 of the referenced maintenance manual describes procedures for replacing the elevator torque tube. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of this AD.
FAA's Determination and Requirements of This AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with this State of Design Authority, they have notified us of the unsafe condition described in the MCAI and service information referenced above. We are issuing this AD because we evaluated all information provided by the State of Design Authority and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.
FAA's Determination of the Effective Date
An unsafe condition exists that requires the immediate adoption of this AD. The FAA has found that the risk to the flying public justifies waiving notice and comment prior to adoption of this rule because there are no airplanes currently on the U.S. registry and thus, does not have any impact upon the public. Therefore, we find that notice and opportunity for prior public comment are unnecessary.
Comments Invited
This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2016-8838; Directorate Identifier 2016-CE-020-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD because of those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this AD.
Costs of Compliance
We estimate that this AD will affect 0 products of U.S. registry. We also estimate that it will take about .5 work-hour per product to comply with the basic inspection requirement of this AD. The average labor rate is $85 per work-hour.
Based on these figures, we estimate the cost of the inspection requirement of this AD on U.S. operators to be $42.50 per product.
In addition, we estimate that any necessary follow-on actions will take about 4 work-hours and require parts costing $3,012, for a cost of $3,352 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or negative,
Page 51332
on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
2. The FAA amends Sec. 39.13 by adding the following new AD:
2016-16-03 Pacific Aerospace Limited: Amendment 39-18601; Docket No. FAA-2016-8838; Directorate Identifier 2016-CE-020-AD.
(a) Effective Date
This airworthiness directive (AD) becomes effective September 8, 2016.
(b) Affected ADs
None.
(c) Applicability
This AD applies to Pacific Aerospace Limited Models FU24-954 and FU24A-954 airplanes, all serial numbers, that are:
(1) Equipped with an elevator torque tube, part number (P/N) 242837, 242527, 242835, or 242646; and
(2) Certificated in any category.
(d) Subject
Air Transport Association of America (ATA) Code 27: Flight Controls.
(e) Reason
This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as cracks found in the elevator torque tubes. We are issuing this AD to prevent failure of the elevator torque tube, which could cause loss of elevator and aileron control.
(f) Actions and Compliance
Unless already done, do the following actions.
(1) Within the next 25 hours time-in-service after September 8, 2016 (the effective date of this AD), do a detailed visual inspection of the elevator torque tube for cracks.
(2) Before further flight after the inspection required in paragraph (f)(1) of this AD, replace the elevator torque tube with a serviceable elevator torque tube if any cracks are found. Do the replacement following Chapter 27, Flight Controls, dated May 1980, of the Maintenance Manual for the Fletcher FU24 and FU24A Post-954, Pacific Aerospace Corporation, Ltd.
Note 1 to paragraph (f) of this AD: This AD does not affect the required repetitive inspections of the control column/elevator torque tubes as specified in the FAA-approved maintenance program.
(g) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4123; fax: (816) 329-4090; email: karl.schletzbaum@faa.gov. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(h) Special Flight Permit
Special flight permits are prohibited.
(i) Related Information
Refer to MCAI Civil Aviation Authority (CAA) AD No. DCA/FU24/
184, dated July 7, 2016, for related information. You may examine the MCAI on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-8838.
(j) Material Incorporated by Reference
(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.
(i) Chapter 27, Flight Controls, dated May 1980, of the Maintenance Manual for the Fletcher FU24 and FU24A Post-954, Pacific Aerospace Corporation, Ltd.
(ii) Reserved.
(3) For Pacific Aerospace Limited (previously Pacific Aerospace Corporation Ltd.) service information identified in this AD, contact Pacific Aerospace Limited, Airport Road, Hamilton, Private Bag 3027, Hamilton 3240, New Zealand; telephone: +64 7 843 6144; facsimile: +64 7 843 6134; email: pacific@aerospace.co.nz; Internet: www.aerospace.co.nz.
(4) You may view this service information at FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call 816-329-4148. It is also available on the Internet at http://www.regulations.gov by searching for locating Docket No. FAA-2016-
8838.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.
Issued in Kansas City, Missouri, on July 26, 2016.
Pat Mullen,
Acting Manager, Small Airplane Directorate, Aircraft Certification Service.
FR Doc. 2016-18265 Filed 8-3-16; 8:45 am
BILLING CODE 4910-13-P
