Airworthiness Directives; Pacific Aerospace Limited Airplanes
Federal Register, Volume 83 Issue 53 (Monday, March 19, 2018)
Federal Register Volume 83, Number 53 (Monday, March 19, 2018)
Rules and Regulations
Pages 11873-11875
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2018-05355
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2018-0210; Product Identifier 2018-CE-004-AD; Amendment 39-19229; AD 2018-06-09
RIN 2120-AA64
Airworthiness Directives; Pacific Aerospace Limited Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Final rule; request for comments.
-----------------------------------------------------------------------
SUMMARY: We are adopting a new airworthiness directive (AD) for Pacific Aerospace Limited Model 750XL airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as the possibility for the control column to snag on the cockpit control tee handles on certain airplanes. We are issuing this AD to require actions to address the unsafe condition on these products.
DATES: This AD is effective April 9, 2018.
The Director of the Federal Register approved the incorporation by reference of a certain publication listed in the AD as of April 9, 2018.
We must receive comments on this AD by May 3, 2018.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this AD, contact Pacific Aerospace Limited, Airport Road, Hamilton, Private Bag 3027, Hamilton 3240, New Zealand; phone: +64 7843 6144; fax: +64 843 6134; email: email protected; internet: www.aerospace.co.nz. You may view this referenced service information at the FAA, Policy and Innovation Division, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148. It is also available on the internet at http://www.regulations.gov by searching for locating Docket No. FAA-2018-0210.
Examining the AD Docket
You may examine the AD docket on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-
0210; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for Docket Operations (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Mike Kiesov, Aerospace Engineer, FAA, Small Airplane Standards Branch, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4144; fax: (816) 329-4090; email: email protected.
SUPPLEMENTARY INFORMATION:
Discussion
The Civil Aviation Authority, which is the aviation authority for New Zealand, has issued CAA AD DCA/750XL/22, dated December 19, 2017 (referred to after this as ``the MCAI''), to correct an unsafe condition for Pacific Aerospace Limited Model 750XL airplanes. To accompany that MCAI, the CAA issued Notification of Airworthiness Directive issued for New Zealand Aeronautical Products IAW ICAO Annex 8, dated December 21, 2017; the Notification states:
This CAA AD is prompted by a ground inspection which found it is possible for the control column to snag on the cockpit control tee handles on certain aircraft. When the tee handle is pulled out to the maximum limit it fouls with the control column in the extreme forward right and left positions. The tee handles are mounted below the switch panels adjacent to the centre console.
This CAA AD with effective date 28 December 2017 mandates the inspection and corrective actions per the Accomplishment
Page 11874
Instructions in Pacific Aerospace Mandatory Service Bulletin (MSB) PACSB/XL/093 issue 1, dated 15 December 2017, or later approved revision.
You may examine the MCAI on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-
0210.
Related Service Information Under 1 CFR Part 51
Pacific Aerospace Limited has issued Pacific Aerospace Mandatory Service Bulletin PACSB/XL/093, Issue 1, dated December 15, 2017. The service information describes procedures for inspecting the ventilation, heater, and air filter bypass control tee handles for snagging of the control column, and adjustment of the control tee handle if necessary. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of the AD.
FAA's Determination and Requirements of the AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with this State of Design Authority, they have notified us of the unsafe condition described in the MCAI and service information referenced above. We are issuing this AD because we evaluated all information provided by the State of Design Authority and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.
FAA's Determination of the Effective Date
An unsafe condition exists that requires the immediate adoption of this AD. The FAA has found that the risk to the flying public justifies waiving notice and comment prior to adoption of this rule because interference with the control column operations can result in the flight controls becoming jammed, which could result in uncontrollable flight. Therefore, we find good cause that notice and opportunity for prior public comment are impracticable. In addition, for the reason(s) stated above, we find that good cause exists for making this amendment effective in less than 30 days.
Comments Invited
This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2018-0210; Directorate Identifier 2018-CE-004-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD because of those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this AD.
Costs of Compliance
We estimate that this AD will affect 22 products of U.S. registry. We also estimate that it would take about 2 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour.
Based on these figures, we estimate the cost of the AD on U.S. operators to be $3,740, or $170 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in ``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
2. The FAA amends Sec. 39.13 by adding the following new AD:
2018-06-09 Pacific Aerospace Limited: Amendment 39-19229; Docket No. FAA-2018-0210; Directorate Identifier 2018-CE-004-AD.
(a) Effective Date
This airworthiness directive (AD) becomes effective April 9, 2018.
(b) Affected ADs
None.
(c) Applicability
This AD applies to Pacific Aerospace Limited Models 750XL airplanes, all serial numbers up to and including serial number XL215, certificated in any category.
(d) Subject
Air Transport Association of America (ATA) Code 27: Flight Controls.
(e) Reason
This AD was prompted by mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as the possibility for the control column to snag on the cockpit control tee handles on certain aircraft. We are issuing this AD to prevent the control tee handles from snagging the control column and becoming jammed, which could result in uncontrollable flight.
Page 11875
(f) Actions and Compliance
Unless already done, do the actions in paragraph (f)(1) and (2) of this AD following the Accomplishment Instructions in Pacific Aerospace Mandatory Service Bulletin PACSB/XL/093, Issue 1, dated December 15, 2017.
(1) Within 30 days after April 9, 2018 (the effective date of this AD), inspect the ventilation, heater, and air filter bypass control tee handles (as applicable) for snagging of the control column.
(2) If the control column snags the adjacent heater, ventilation, or an engine air filter bypass control tee handle during the inspection required in paragraph (f)(1) of this AD, before further flight, reorient the affected tee handle.
(g) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, Small Airplane Standards Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Mike Kiesov, Aerospace Engineer, FAA, Small Airplane Standards Branch, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4144; fax: (816) 329-
4090; email: email protected. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.
(2) Contacting the Manufacturer: For any requirement in this AD to obtain corrective actions from a manufacturer, the action must be accomplished using a method approved by the Manager, Standards Office, FAA; or the Civil Aviation Authority of New Zealand (CAA).
(h) Related Information
Refer to the MCAI by the CAA, AD DCA/750XL/23, dated December 28, 2017; and Pacific Aerospace Mandatory Service Bulletin PACSB/XL/
093, Issue 1, dated December 15, 2017, for related information. You may examine the MCAI on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2018-0210.
(i) Material Incorporated by Reference
(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.
(i) Pacific Aerospace Mandatory Service Bulletin PACSB/XL/093, Issue 1, dated December 15, 2017.
(ii) Reserved.
(3) For service information identified in this AD, contact Pacific Aerospace Limited, Airport Road, Hamilton, Private Bag 3027, Hamilton 3240, New Zealand; phone: +64 7843 6144; fax: +64 843 6134; email: email protected; internet: www.aerospace.co.nz.
(4) You may view this service information at the FAA, Policy and Innovation Division, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148. It is also available on the internet at http://www.regulations.gov by searching for locating Docket No. FAA-2018-
0210.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.
Issued in Kansas City, Missouri, on March 9, 2018.
Pat Mullen,
Acting Deputy Director, Policy & Innovation Division, Aircraft Certification Service.
FR Doc. 2018-05355 Filed 3-16-18; 8:45 am
BILLING CODE 4910-13-P
