Airworthiness Directives; Piper Aircraft, Inc. Airplanes
Federal Register, Volume 80 Issue 236 (Wednesday, December 9, 2015)
Federal Register Volume 80, Number 236 (Wednesday, December 9, 2015)
Proposed Rules
Pages 76398-76400
From the Federal Register Online via the Government Publishing Office www.gpo.gov
FR Doc No: 2015-30882
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
Docket No. FAA-2015-7205; Directorate Identifier 2015-CE-025-AD
RIN 2120-AA64
Airworthiness Directives; Piper Aircraft, Inc. Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
-----------------------------------------------------------------------
SUMMARY: We propose to supersede Airworthiness Directive (AD) 96-12-12, which applies to certain Piper Aircraft, Inc. Models PA-31, PA-31-300, PA-31-325, and PA-31-350 airplanes. AD 96-12-12 currently requires a one-time inspection of the bulkhead assembly at fuselage station (FS) 317.75 for cracks and the installation of one of two reinforcement kits determined by whether cracks were found during the inspection. Since we issued AD 96-12-12, bulkhead cracks were found on airplanes that had complied with AD 96-12-12 and on additional airplanes not affected by AD 96-12-12. This proposed AD would require repetitive inspections of the bulkhead assembly at FS 317.75 for cracks, repair of cracks as necessary, and the installation of a reinforcement modification. We are proposing this AD to correct the unsafe condition on these products.
DATES: We must receive comments on this proposed AD by January 25, 2016.
ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Piper Aircraft, Inc., 2926 Piper Drive, Vero Beach, FL 32960; telephone: (415) 330-9500; email: sales@atp.com; and Internet: http://www.piper.com/technical-publications/. You may view this referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-
7205; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Gregory ``Keith'' Noles, Aerospace Engineer, FAA, Atlanta Aircraft Certification Office (ACO), 1701 Columbia Avenue, College Park, Georgia 30337; phone: (404) 474-5551; fax: (404) 474-5606; email: gregory.noles@faa.gov.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2015-7205; Directorate Identifier 2015-CE-025-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
On May 30, 1996, we issued AD 96-12-12, Amendment 39-9654 (61 FR 28732, June 6, 1996) (``AD 96-12-12''), for certain Piper Aircraft, Inc. Models PA-31, PA-31-300, PA-31-325, and PA-31-350 airplanes. AD 96-12-12 requires a one-time inspection of the bulkhead assembly at fuselage station (FS) 317.75 for cracks and the installation of one of two reinforcement kits, determined by whether cracks were found during the inspection. AD 96-12-12 resulted from cracks found in the FS 317.75 upper bulkhead. We issued AD 96-12-12 to prevent structural failure of the vertical fin forward spar caused by cracks in the FS 317.75 upper bulkhead, which could lead to loss of control.
Actions Since AD 96-12-12 Was Issued
Since we issued AD 96-12-12, cracks were found on the bulkhead assembly of airplanes in compliance with AD 96-12-12 and on additional airplanes not affected by AD 96-12-12 but of a similar type design. Piper Aircraft, Inc. has issued new service information that gives instructions for repair of the cracks and instructions for the installation of a reinforcement modification to prevent cracks from developing.
Related Service Information Under 1 CFR Part 51
We reviewed Piper Aircraft, Inc. Service Bulletin No. 1273A, dated October 22, 2015. The service bulletin describes procedures for inspecting the bulkhead assembly at FS 317.75, repairing any cracks found, and installation of a reinforcement modification to prevent cracks from developing. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of this NPRM.
FAA's Determination
We are proposing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.
Proposed AD Requirements
This proposed AD would retain none of the requirements of AD 96-12-
12. This NPRM would add airplanes to the Applicability, paragraph (c) of this proposed AD. This proposed AD would also require accomplishing the actions specified in the service information described previously. Airplanes in compliance with AD 96-12-12 must be re-inspected, repaired if necessary, and modified following the new service information.
Page 76399
Costs of Compliance
We estimate that this proposed AD affects 977 airplanes of U.S. registry.
We estimate the following costs to comply with this proposed AD:
Estimated Costs
----------------------------------------------------------------------------------------------------------------
Cost per Cost on U.S.
Action Labor cost Parts cost product operators
----------------------------------------------------------------------------------------------------------------
Inspection of the bulkhead assembly. 2 work-hours x $85 per Not applicable. $170 $166,090
hour = $170.
Repair/reinforcement of bulkhead 8 work-hours x $85 per $500 1,180 1,152,860
assembly. hour = $680.
----------------------------------------------------------------------------------------------------------------
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the proposed regulation:
(1) Is not a ``significant regulatory action'' under Executive Order 12866,
(2) Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 Amended
0
2. The FAA amends Sec. 39.13 by removing Airworthiness Directive (AD) 96-12-12, Amendment 39-9654 (61 FR 28732, June 6, 1996), and adding the following new AD:
Piper Aircraft, Inc.: Docket No. FAA-2015-7205; Directorate Identifier 2015-CE-025-AD.
(a) Comments Due Date
The FAA must receive comments on this AD action by January 25, 2016.
(b) Affected ADs
This AD replaces 96-12-12, Amendment 39-9654 (61 FR 28732, June 6, 1996) (``AD 96-12-12'').
(c) Applicability
This AD applies to the following Piper Aircraft, Inc. airplanes listed in paragraphs (c)(1) and (c)(2) of this AD, certificated in any category:
(1) Models PA-31, PA-31-300, and PA-31-325: Serial numbers 31-2 through 31-900 and 31-7300901 through 31-8312019; and
(2) Model PA-31-350: Serial numbers 31-5001 through 31-5004 and 31-7305005 through 31-8553002.
Note 1 to paragraph (c)(1) of this AD: The Model PA-31 may also be identified as a PA-31-310, even though the PA-31-310 is not a model recognized by the Federal Aviation Administration (FAA) on the type certificate data sheet.
(d) Subject
Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 53, Fuselage.
(e) Unsafe Condition
This AD was prompted by bulkhead cracks found on airplanes that had complied with AD 96-12-12 and on additional airplanes not affected by AD 96-12-12. We are issuing this AD to prevent structural failure of the vertical fin forward spar caused by cracks in the fuselage station (FS) at 317.75 upper bulkhead, which could lead to loss of control.
(f) Compliance
Comply with this AD within the compliance times specified, unless already done.
(g) Inspection/Repair
(1) Before or upon accumulating 2,000 hours time-in-service (TIS) or within the next 100 hours TIS after the effective date of this AD, whichever occurs later, and repetitively thereafter at intervals not to exceed 100 hours TIS, inspect the bulkhead assembly at FS 317.75 for cracks following Part I of the Instructions in Piper Aircraft, Inc. Service Bulletin No. 1273A, dated October 22, 2015.
(2) If any cracks are found during the inspection required in paragraph (g)(1) of this AD, before further flight, repair the cracks and install the reinforcement modification following Part I of the Instructions in Piper Aircraft, Inc. Service Bulletin No. 1273A, dated October 22, 2015. This repair/modification terminates the requirements for the repetitive inspections required in paragraph (g)(1) of this AD.
(3) You may do the modification required in paragraph (h) of this AD to terminate the repetitive inspections required in paragraph (g)(1) of this AD.
(h) Modification
Unless already done as a repair for cracks found in the inspection required in paragraph (g)(1) of this AD, before or upon accumulating 2,500 hours TIS or within the next 500 hours after the effective date of this AD, whichever occurs later, install the reinforcement modification following Part II of the Instructions in Piper Aircraft, Inc. Service Bulletin No. 1273A, dated October 22, 2015. This modification terminates the repetitive inspections required in paragraph (g)(1) of this AD.
Page 76400
(i) Credit for Actions Accomplished in Accordance With Previous Service Information
This AD allows credit for the inspection required in paragraph (g)(1) of this AD and the repair required in paragraph (g)(2) of this AD, if done before the effective date of this AD, following Part I of the Instructions in Piper Aircraft, Inc. Service Bulletin No. 1273, dated June 4, 2015. This AD also allows credit for the modification required in paragraph (h) of this AD, if done before the effective date of this AD, following Part II of the Instructions in Piper Aircraft, Inc. Service Bulletin No. 1273, dated June 4, 2015.
(j) Alternative Methods of Compliance (AMOCs)
(1) The Manager, Atlanta Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in Related Information, paragraph (j)(1) of this AD.
(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.
(k) Related Information
(1) For more information about this AD, contact Gregory ``Keith'' Noles, Aerospace Engineer, FAA, Atlanta ACO, 1701 Columbia Avenue, College Park, Georgia 30337; phone: (404) 474-5551; fax: (404) 474-5606; email: gregory.noles@faa.gov.
(2) For service information identified in this AD, contact Piper Aircraft, Inc. 2926 Piper Drive, Vero Beach, FL 32960; telephone: (415) 330-9500; email: sales@atp.com; and Internet: http://www.piper.com/technical-publications/. You may view this referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.
Issued in Kansas City, Missouri, on December 1, 2015.
Pat Mullen,
Acting Manager, Small Airplane Directorate, Aircraft Certification Service.
FR Doc. 2015-30882 Filed 12-8-15; 8:45 am
BILLING CODE 4910-13-P
