Airworthiness directives: Short Brothers,

[Federal Register: October 30, 2001 (Volume 66, Number 210)]

[Rules and Regulations]

[Page 54651-54652]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr30oc01-5]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2001-NM-175-AD; Amendment 39-12484; AD 2001-22-05]

RIN 2120-AA64

Airworthiness Directives; Short Brothers Model SD3 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to certain Short Brothers Model SD3 series airplanes, that requires an inspection to find discrepancies of the hydraulic pipelines to the 7P panel and adjacent electrical wiring harnesses, and corrective action, if necessary. This action is necessary to find and fix such discrepancies, which could result in electrical arcing between the hydraulic lines and adjacent wiring, and a potential fire. This action is intended to address the identified unsafe condition.

DATES: Effective December 4, 2001.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of December 4, 2001.

ADDRESSES: The service information referenced in this AD may be obtained from Short Brothers, Airworthiness & Engineering Quality, P.O. Box 241, Airport Road, Belfast BT3 9DZ, Northern Ireland. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Todd Thompson, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-1175; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Short Brothers Model SD3 series airplanes was published in the Federal Register on August 17, 2001 (66 FR 43126). That action proposed to require an inspection to find discrepancies of the hydraulic pipelines to the 7P panel and adjacent electrical wiring harnesses, and corrective action, if necessary.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact

The FAA estimates that 75 airplanes of U.S. registry will be affected by this AD, that it will take approximately 1 work hour per airplane to accomplish the required inspection, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $4,500, or $60 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

[[Page 54652]]

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

   2001-22-05 Short Brothers, PLC: Amendment 39-12484. Docket 2001-NM- 175-AD.

   Applicability: This AD applies to the airplanes listed in Table 1, certificated in any category:

   Table 1.--Applicability

   Short Brothers model

   Description

1. SD3-SHERPA series airplanes............ On which Short Brothers Modification K2239 has not been accomplished. 2. SD3-60 SHERPA series airplanes......... On which Short Brothers Modification K6109 has not been accomplished. 3. SD3-60 series airplanes................ On which Short Brothers Modification A8684 has not been accomplished. 4. SD3-30 series airplanes................ On which Short Brothers Modification P4810 has not been accomplished.

   Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been otherwise modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

   Compliance: Required as indicated, unless accomplished previously.

   To find and fix discrepancies of the hydraulic pipelines to the 7P panel and adjacent electrical wiring harnesses, which could result in electrical arcing between the hydraulic lines and adjacent wiring, and a potential fire, accomplish the following:

   Inspection/Corrective Action

   (a) Within 90 days after the effective date of this AD, do a detailed visual inspection to find discrepancies (inadequate clearance, chafing, or damage) of the hydraulic pipelines to the 7P panel and adjacent electrical wiring harnesses, per the Accomplishment Instructions of Shorts Service Bulletins SD3 SHERPA- 24-5, SD330-24-29, SD360-24-25, or SD360 SHERPA-24-4, all dated April 30, 2001; as applicable. Before further flight, fix any discrepancies found per the applicable service bulletin.

   Note 2: For the purposes of this AD, a detailed visual inspection is defined as: ``An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.''

   Alternative Methods of Compliance

   (b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

   Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

   Special Flight Permits

   (c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

   Incorporation by Reference

   (d) The actions shall be done in accordance with Shorts Service Bulletin SD3 SHERPA-24-5, dated April 30, 2001; Shorts Service Bulletin SD330-24-29, dated April 30, 2001; Shorts Service Bulletin SD360-24-25, dated April 30, 2001; or Shorts Service Bulletin SD360 SHERPA-24-4, dated April 30, 2001; as applicable. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Short Brothers, Airworthiness & Engineering Quality, P.O. Box 241, Airport Road, Belfast BT3 9DZ, Northern Ireland. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

   Note 4: The subject of this AD is addressed in British airworthiness directives 006-04-2001, 007-04-2001, 008-04-2001, and 009-04-2001.

   Effective Date

   (e) This amendment becomes effective on December 4, 2001.

   Issued in Renton, Washington, on October 19, 2001. Ali Bahrami, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 01-26956Filed10-29-01; 8:45 am]

   BILLING CODE 4910-13-P