Airworthiness directives: Stemme GmbH & Co. KG,

[Federal Register: July 14, 1999 (Volume 64, Number 134)]

[Rules and Regulations]

[Page 37841-37842]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr14jy99-3]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-CE-07-AD; Amendment 39-11222; AD 99-15-03]

RIN 2120-AA64

Airworthiness Directives; Stemme GmbH & Co. KG Model S10-VT Sailplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

SUMMARY: This amendment adopts a new airworthiness directive (AD) that applies to certain Stemme GmbH & Co. KG (Stemme) Model S10-VT sailplanes. This AD requires modifying the wastegate control in order to eliminate heat damage. This AD is the result of mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Germany. The actions specified by this AD are intended to prevent the wastegate control from malfunctioning because of heat damage, which could result in loss of automatic manifold pressure control and engine damage.

DATES: Effective August 31, 1999.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of August 31, 1999.

ADDRESSES: Service information that applies to this AD may be obtained from Stemme GmbH & Co. KG, Gustav-Meyer-Allee 25, D-13355 Berlin, Germany; telephone: 49.33.41.31.11.70; facsimile: 49.33.41.31.11.73. This information may also be examined at the Federal Aviation Administration (FAA), Central Region, Office of the Regional Counsel, Attention: Rules Docket No. 99-CE-07-AD, Room 1558, 601 E. 12th Street, Kansas City, Missouri 64106; or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Mr. Mike Kiesov, Aerospace Engineer, FAA, Small Airplane Directorate, 1201 Walnut, suite 900, Kansas City, Missouri 64106; telephone: (816) 426-6934; facsimile: (816) 426-2169.

[[Page 37842]]

SUPPLEMENTARY INFORMATION:

Events Leading to the Issuance of This AD

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD that would apply to certain Stemme Model S10-VT sailplanes was published in the Federal Register as a notice of proposed rulemaking (NPRM) on April 26, 1999 (64 FR 20229). The NPRM proposed to require modifying the wastegate control in order to eliminate heat damage. Accomplishment of the proposed action as specified in the NPRM would be required in accordance with Stemme Service Bulletin No. A31-10-034, Amendment 01.a, pages 3 and 4, dated July 24, 1998.

The NPRM was the result of mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Germany.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were received on the proposed rule or the FAA's determination of the cost to the public.

The FAA's Determination

After careful review of all available information related to the subject presented above, the FAA has determined that air safety and the public interest require the adoption of the rule as proposed except for minor editorial corrections. The FAA has determined that these minor corrections will not change the meaning of the AD and will not add any additional burden upon the public than was already proposed.

Cost Impact

The FAA estimates that 6 sailplanes in the U.S. registry will be affected by this AD, that it will take approximately 4 workhours per sailplane to accomplish this action, and that the average labor rate is approximately $60 an hour. Parts cost approximately $150 per sailplane. Based on these figures, the total cost impact of this AD on U.S. operators is estimated to be $2,340, or $390 per sailplane.

Regulatory Impact

The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the final evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701.

   Sec. 39.13 [Amended]

2. Section 39.13 is amended by adding a new airworthiness directive (AD) to read as follows:

   99-15-03 Stemme GMBH & Co. KG: Amendment 39-11222; Docket No. 99- CE-07-AD.

   Applicability: Model S10-VT sailplanes, serial numbers 11-004 through 11-006 and 11-008 through 11-013, certificated in any category.

   Note 1: This AD applies to each sailplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For sailplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD.

   The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

   Compliance: Required within the next 3 calendar months after the effective date of this AD, unless already accomplished.

   To prevent the wastegate control from malfunctioning because of heat damage, which could result in loss of automatic manifold pressure control and engine damage, accomplish the following:

   (a) Modify the wastegate control in order to eliminate heat damage, in accordance with the Instructions section of Stemme Service Bulletin No. A31-10-034, Amendment 01.a, pages 3 and 4, dated July 24, 1998.

   (b) Special flight permits may be issued in accordance with Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the sailplane to a location where the requirements of this AD can be accomplished.

   (c) An alternative method of compliance or adjustment of the compliance time that provides an equivalent level of safety may be approved by the Manager, Small Airplane Directorate, FAA, 1201 Walnut, suite 900, Kansas City, Missouri 64106. The request shall be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and then send it to the Manager, Small Airplane Directorate.

   Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Small Airplane Directorate.

   (d) Questions or technical information related to Stemme Service Bulletin No. A31-10-034, Amendment 01.a, dated July 24, 1998, should be directed to Stemme GmbH & Co. KG, Gustav-Meyer-Allee 25, D-13355 Berlin, Germany; telephone: 49.33.41.31.11.70; facsimile: 49.33.41.31.11.73. This service information may be examined at the FAA, Central Region, Office of the Regional Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri 64106.

   (e) The modification required by this AD shall be done in accordance with Stemme GmbH & Co. KG Service Bulletin No. A31-10- 034, Amendment 01.a, pages 3 and 4, dated July 24, 1998. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Stemme GmbH & Co. KG, Gustav-Meyer- Allee 25, D-13355 Berlin, Germany. Copies may be inspected at the FAA, Central Region, Office of the Regional Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW, suite 700, Washington, DC.

   Note 3: The subject of this AD is addressed in German AD 1998- 400, dated October 22, 1998.

   (f) This amendment becomes effective on August 31, 1999.

   Issued in Kansas City, Missouri, on July 2, 1999. Marvin R. Nuss, Acting Manager, Small Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 99-17677Filed7-13-99; 8:45 am]

   BILLING CODE 4910-13-U