Airworthiness standards: 500 series airplanes,

[Federal Register: March 8, 2002 (Volume 67, Number 46)]

[Rules and Regulations]

[Page 10601-10603]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr08mr02-1]

Rules and Regulations Federal Register

This section of the FEDERAL REGISTER contains regulatory documents having general applicability and legal effect, most of which are keyed to and codified in the Code of Federal Regulations, which is published under 50 titles pursuant to 44 U.S.C. 1510.

The Code of Federal Regulations is sold by the Superintendent of Documents. Prices of new books are listed in the first FEDERAL REGISTER issue of each week.

[[Page 10601]]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 25

[Docket No. NM211, Special Conditions No. 25-197-SC]

Special Conditions: Boeing Model 737-300, -400, and -500 Series Airplanes; High Intensity Radiated Fields (HIRF)

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final special conditions; request for comments.

SUMMARY: These special conditions are issued for Boeing Model 737-300, -400, and -500 series airplanes modified by Hollingsead International. These airplanes will have novel and unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. The modification incorporates the installation of Rockwell Collins Global Navigation Landing Unit (GNLU-920) Multi-Mode Receiver (MMR) system. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for the protection of these systems from the effects of high-intensity radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that provided by the existing airworthiness standards.

DATES: The effective date of these special conditions is February 25, 2002. Comments must be received on or before March 29, 2002.

ADDRESSES: Comments on these special conditions may be mailed in duplicate to: Federal Aviation Administration, Transport Airplane Directorate, Attn: Rules Docket (ANM-113), Docket No. NM211, 1601 Lind Avenue SW., Renton, Washington, 98055-4056; or delivered in duplicate to the Transport Airplane Directorate at the above address. All comments must be marked: Docket No. NM211. Comments may be inspected in the Rules Docket weekdays, except Federal holidays, between 7:30 a.m. and 4 p.m.

FOR FURTHER INFORMATION CONTACT: Gregory Dunn, FAA, Airplane and Flight Crew Interface Branch, ANM-111, Transport Airplane Directorate, Aircraft Certification Service, 1601 Lind Avenue SW., Renton, Washington, 98055-4056; telephone (425) 227-2799; facsimile (425) 227- 1320.

SUPPLEMENTARY INFORMATION:

Comments Invited

The FAA invites interested persons to participate in this rulemaking by submitting written comments, data, or views. The most helpful comments reference a specific portion of the special conditions, explain the reason for any recommended change, and include supporting data. We ask that you send us two copies of written comments.

We will file in the docket all comments we receive, as well as a report summarizing each substantive public contact with FAA personnel concerning these special conditions. The docket is available for public inspection before and after the comment closing date. If you wish to review the docket in person, go to the address in the ADDRESSES section of this preamble between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

We will consider all comments we receive on or before the closing date for comments. We will consider comments filedlate if it is possible to do so without incurring expense or delay. We may change these special conditions in light of the comments we receive.

If you want the FAA to acknowledge receipt of your comments on this proposal, include with your comments a pre-addressed, stamped postcard on which the docket number appears. We will stamp the date on the postcard and mail it to you.

Background

On January 8, 2002, Hollingsead International, 7416 Hollister Avenue, Goleta, California 93117, applied for a supplemental type certificate (STC) to modify Boeing Model 737-300, -400, and -500 series airplanes approved under Type Certificate No. A16WE. The Model 737 series airplanes range from 101 feet, 9 inches long to 119 feet 7 inches in length and have a wingspan of 94 feet, 9 inches. The height at vertical stabilizer to ground is 36 feet, 6 inches. The passenger load is from 140 to 188 passengers, and the range is from 2785 to 3910 statute miles. The modification incorporates the installation of a dual Rockwell Collins GNLU-920 Multi-Mode Receiver (MMR) system. Each system consists of a Rockwell Collins GNLU-920 MMR and a Gables Engineering MMR Control Panel. The Rockwell Collins GNLU-920 MMR is a single integrated unit that enables approaches using instrument landing systems, microwave systems and global navigation satellite system functions. These functions can be susceptible to disruption to both command and response signals as a result of electrical and magnetic interference caused by high-intensity radiated fields (HIRF) external to the airplane. This disruption of signals could result in loss of critical flight displays and annunciations, or could present misleading information to the pilot.

Type Certification Basis

Under the provisions of 14 CFR 21.101, Hollingsead International must show that the Boeing Model 737-300, -400, and -500 series airplanes, as changed, continue to meet the applicable provisions of the regulations incorporated by reference in Type Certificate No. A16WE, or the applicable regulations in effect on the date of application for the change. The regulations incorporated by reference in the type certificate are commonly referred to as the ``original type certification basis.'' The certification basis for the modified Boeing Model 737-300, -400, and -500 series airplanes includes 14 CFR part 25, dated November 14, 1984, as amended by amendments 25-1 through 25-51, except for special conditions and exceptions noted in Type Certificate Data Sheet (TCDS) A16WE.

If the Administrator finds that the applicable airworthiness regulations (that is, 14 CFR part 25, as amended) do not contain adequate or appropriate safety standards for the Boeing Model 737-300, -400, and -500 series airplanes because of novel or unusual design features, special conditions are

[[Page 10602]]

prescribed under the provisions of 14 CFR 21.16.

In addition to the applicable airworthiness regulations and special conditions, the Boeing Model 737-300, -400, and -500 series airplanes must comply with the fuel vent and exhaust emission requirement of 14 CFR part 34 and the noise certification requirement of part 36.

Special conditions, as defined in 14 CFR 11.19, are issued in accordance with Sec. 11.38, and become part of the type certification basis in accordance with 14 CFR 21.101(b)(2).

Special conditions are initially applicable to the model for which they are issued. Should Hollingsead International apply at a later date for a supplemental type certificate to modify any other model already included on the same type certificate to incorporate the same novel or unusual design features, these special conditions would also apply to the other model under the provisions of 14 CFR 21.101(a)(1).

Novel or Unusual Design Features

The modified Boeing Model 737-300, -400, and -500 series airplanes will incorporate the Rockwell Collins GNLU-920 MMR system, which perform critical functions. The MMR System contains electronic equipment for which the current airworthiness standards (14 CFR part 25) do not contain adequate or appropriate safety standards that address protecting this equipment from the adverse effects of HIRF. Accordingly, these instruments are considered to be a ``novel or unusual design feature.''

Discussion

There is no specific regulation that addresses protection requirements for electrical and electronic systems from HIRF. Increased power levels from ground-based radio transmitters and the growing use of sensitive avionics/electronics and electrical systems to command and control airplanes have made it necessary to provide adequate protection.

To ensure that a level of safety is achieved equivalent to that intended by the regulations incorporated by reference, special conditions are needed for the Boeing Model 737-300, -400 and -500 series airplanes modified to include Rockwell Collins GNLU-920 MMR System. These special conditions will require that this new system, which perform critical functions, be designed and installed to preclude component damage and interruption of function due to both the direct and indirect effects of HIRF.

High-Intensity Radiated Fields (HIRF)

With the trend toward increased power levels from ground-based transmitters, plus the advent of space and satellite communications, coupled with electronic command and control of the airplane, the immunity of critical digital avionic/electronics and electrical systems to HIRF must be established.

It is not possible to precisely define the HIRF to which the airplane will be exposed in service. There is also uncertainty concerning the effectiveness of airframe shielding for HIRF. Furthermore, coupling of electromagnetic energy to cockpit-installed equipment through the cockpit window apertures is undefined. Based on surveys and analysis of existing HIRF emitters, an adequate level of protection exists when compliance with the HIRF protection special condition is shown in accordance with either paragraph 1 OR 2 below:

1. A minimum threat of 100 volts rms (root-mean-square) per meter electric field strength from 10 KHz to 18 GHz.

   1. The threat must be applied to the system elements and their associated wiring harnesses without the benefit of airframe shielding.

   2. Demonstration of this level of protection is established through system tests and analysis.

2. A threat external to the airframe of the field strengths indicated in Table 1 for the frequency ranges indicated. Both peak and average field strength components from Table 1 are to be demonstrated.

   Table 1

   Field strength (volts per meter) Frequency

   ------------------------- Peak Average

   10 kHz-100 kHz................................

   50

   50 100 kHz-500 kHz...............................

   50

   50 500 kHz-2 MHz.................................

   50

   50 2 MHz-30 MHz..................................

   100

   100 30 MHz-70 MHz.................................

   50

   50 70 MHz-100 MHz................................

   50

   50 100 MHz-200 MHz...............................

   100

   100 200 MHz-400 MHz...............................

   100

   100 400 MHz-700 MHz...............................

   700

   50 700 MHz-1 GHz.................................

   700

   100 1 GHz-2 GHz...................................

   2000

   200 2 GHz-4 GHz...................................

   3000

   200 4 GHz-6 GHz...................................

   3000

   200 6 GHz-8 GHz...................................

   1000

   200 8 GHz-12 GHz..................................

   3000

   300 12 GHz-18 GHz.................................

   2000

   200 18 GHz-40 GHz.................................

   600

   200

   The field strengths are expressed in terms of peak of the root-mean- square (rms) over the complete modulation period.

   The threat levels identified above are the result of an FAA review of existing studies on the subject of HIRF, in light of the ongoing work of the Electromagnetic Effects Harmonization Working Group of the Aviation Rulemaking Advisory Committee.

   Applicability

   As discussed above, these special conditions are applicable to Boeing Model 737-300, -400 and -500 series airplanes modified by Hollingsead International to include the Rockwell Collins GNLU-920 MMR. Should Hollingsead International apply at a later date for a supplemental type certificate to modify any other model already included on Type Certificate A16WE to incorporate the same novel or unusual design features, these special conditions would apply to that model as well under the provisions of 14 CFR 21.101(a)(1).

   Conclusion

   This action affects only certain design features on Boeing Model 737-300, -400 and -500 series airplanes modified by Hollingsead International. It is not a rule of general applicability and affects only the applicant who applied to the FAA for approval of these features on the airplane.

   The substance of the special conditions for this airplane has been subjected to the notice and comment procedure in several prior instances and has been derived without substantive change from those previously issued. Because a delay would significantly affect the certification of the airplane, which is imminent, the FAA has determined that prior public notice and comment are unnecessary and impracticable, and good cause exists for adopting these special conditions upon issuance. The FAA is requesting comments to allow interested persons to submit views that may not have been submitted in response to the prior opportunities for comment described above.

   List of Subjects in 14 CFR Part 25

   Aircraft, Aviation safety, Reporting and recordkeeping requirements.

   [[Page 10603]]

   The authority citation for these special conditions is as follows:

   Authority: 49 U.S.C. 106(g), 40113, 44701, 44702, 44704.

   The Special Conditions

   Accordingly, pursuant to the authority delegated to me by the Administrator, the following special conditions are issued as part of the supplemental type certification basis for Boeing Model 737-300, - 400 and -500 series airplanes modified by Hollingsead International.

1. Protection from Unwanted Effects of High-Intensity Radiated Fields (HIRF). Each electrical and electronic system that performs critical functions must be designed and installed to ensure that the operation and operational capability of these systems to perform critical functions are not adversely affected when the airplane is exposed to high-intensity radiated fields.

2. For the purpose of these special conditions, the following definition applies:

   Critical Functions. Functions whose failure would contribute to or cause a failure condition that would prevent the continued safe flight and landing of the airplane.

   Issued in Renton, Washington, on February 25, 2002. Vi L. Lipski, Manager, Transport Airplane Directorate, Aircraft Certification Service.

   [FR Doc. 02-5626Filed3-7-02; 8:45 am]

   BILLING CODE 4910-13-P