Agency Information Collection Activities; Proposals, Submissions, and Approvals
Federal Register: June 10, 2008 (Volume 73, Number 112)
Notices
Page 32704-32706
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
DOCID:fr10jn08-39
ENVIRONMENTAL PROTECTION AGENCY
EPA-HQ-OECA-2007-0064; FRL-8577-4
Agency Information Collection Activities; Submission to OMB for
Review and Approval; Comment Request; NESHAP for Leather Finishing
Operations (Renewal), EPA ICR Number 1985.04, OMB Control Number 2060- 0478
AGENCY: Environmental Protection Agency (EPA).
ACTION: Notice.
SUMMARY: In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection
Request (ICR) has been forwarded to the Office of Management and Budget
(OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost.
DATES: Additional comments may be submitted on or before July 10, 2008.
ADDRESSES: Submit your comments, referencing docket ID number EPA-HQ-
OECA-2007-0064, to (1) EPA online using http://www.regulations.gov (our preferred method), or by e-mail to docket.oeca@epa.gov, or by mail to:
EPA Docket Center (EPA/DC), Environmental Protection Agency,
Enforcement and
Page 32705
Compliance Docket and Information Center, mail code 2201T, 1200
Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget
(OMB), Attention: Desk Officer for EPA, 725 17th Street, NW.,
Washington, DC 20503.
FOR FURTHER INFORMATION CONTACT: Learia Williams, Compliance Assessment and Media Programs Division, Office of Compliance, Mail Code 2223A,
Environmental Protection Agency, 1200 Pennsylvania Avenue, NW.,
Washington, DC 20460; telephone number: (202) 564-4113; fax number:
(202) 564-0050; e-mail address: williams.learia@epa.gov.
SUPPLEMENTARY INFORMATION: EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On March 9, 2007 (72 FR 10735), EPA sought comments on this
ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to EPA and OMB within 30 days of this notice.
EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2007-0064, which is available for public viewing online at http://www.regulations.gov, in person viewing at the
Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC),
EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The
EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is (202) 566-1744, and the telephone number for the Enforcement and Compliance Docket is (202) 566-1927.
Use EPA's electronic docket and comment system at http:// www.regulations.gov, to submit or view public comments, access the index listing of the contents of the docket, and to access those documents in the docket that are available electronically. Once in the system, select ``docket search,'' then key in the docket ID number identified above. Please note that EPA's policy is that public comments, whether submitted electronically or in paper, will be made available for public viewing at http://www.regulations.gov, as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about the electronic docket, go to http:// www.regulations.gov.
Title: NESHAP for Leather Finishing Operations (Renewal).
ICR Numbers: EPA ICR Number 1985.04, OMB Control Number 2060-0478.
ICR Status: This ICR is scheduled to expire on September 30, 2008.
Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB.
An Agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB control number. The OMB control numbers for EPA's regulations in title 40 of the CFR, after appearing in the Federal Register when approved, are listed in 40 CFR part 9, and displayed either by publication in the Federal Register or by other appropriate means, such as on the related collection instrument or form, if applicable. The display of OMB control numbers in certain EPA regulations is consolidated in 40 CFR part 9.
Abstract: The National Emission Standards for Hazardous Air
Pollutants (NESHAP) for Leather Finishing Operations were proposed on
October 2, 2000 (65 FR 58702), and promulgated on February 27, 2002.
These standards apply to any existing, reconstructed, or new leather finishing operations. A leather finishing operation is a single process or group of processes used to adjust and improve the physical and aesthetic characteristics of the leather surface through multistage application of a coating comprised of dyes, pigments, film-forming materials and performance modifiers dissolved or suspended in liquid carriers. A leather finishing operation is only subject to the regulation if it is a major source of hazardous air pollutant (HAP), emitting or has the potential to emit any single HAP at the rate of 10 tons (9.07 megagrams) or more per year or any combination of HAP at a rate of 25 tons (22.68 megagrams).
Owners and operators must submit notification reports upon the construction or reconstruction of any leather finishing operation. Any leather finishing operation that starts up after proposal but before promulgation must submit an initial notification similar to the one submitted by existing sources. Each new or reconstructed source that starts up after promulgation must submit a series of notifications in addition to the initial notification that include notification of intent to construct or reconstruct and notification of startup. Upon the collection of twelve months of data after the date of initial notification, owners or operators of leather finishing operations must submit an annual compliance status certification report and annually thereafter. Owners or operators of a leather finishing operation subject to the rule must maintain a file of these measurements, and retain the file for at least five years following the date of such measurements, maintenance reports, and records.
Notifications are to inform the Agency or delegated authority when a source becomes subject to the standard. The reviewing authority may then inspect the source to ensure that the pollution control devices are properly installed and operating and that the standards are being met. Performance test reports are required as these are the Agency's records of a source's initial capability to comply with the emission standards and to serve as a record of the operating conditions under which compliance was achieved. The information generated by monitoring, recordkeeping and reporting requirements described in this ICR are used by the Agency to ensure that facilities that are affected by the standard continue to operate the control equipment and achieve continuous compliance with the regulation.
All reports are sent to the delegated state or local authority. In the event that there is no such delegated authority, the reports are sent directly to the EPA regional office. This information is being collected to assure compliance with 40 CFR part 63, subpart TTTT, as authorized in sections 112 and 114(a) of the Clean Air Act. The required information consists of emissions data and other information that have been determined to be private.
An Agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Number for EPA's regulations listed in 40 CFR part 9 and 48 CFR chapter 15 are identified on the form and/or instrument, if applicable.
Burden Statement: The annual public reporting and recordkeeping burden for this collection of information is estimated to average 33 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose and provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purposes of collecting, validating, and verifying information, processing and
Page 32706
maintaining information, and disclosing and providing information. All existing ways will have to adjust to comply with any previously applicable instructions and requirements that have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information.
Respondents/Affected Entities: Leather finishing operations.
Estimated Number of Respondents: 10.
Frequency of Response: Initially, occasionally, and annually.
Estimated Total Annual Hour Burden: 334.
Estimated Total Annual Cost: $21,279.00, inclusion of labor costs.
There are no annualized capital/startup and annual O&M costs associated with this ICR.
Changes in the Estimates: There is no change in the labor hours or cost in this ICR compared to the previous ICR. This is due to two considerations: (1) The regulations have not changed over the past three years and there are not anticipated changes over the next three years; and (2) the growth rate for the industry is very low, negative or non-existent, so there is no significant change in the overall burden.
Since there are no changes in the regulatory requirements and there is no significant industry growth, the labor hours and cost figures in the previous ICR are used in this ICR, and there is no change in burden to industry.
Dated: May 29, 2008.
Sara Hisel-McCoy,
Director, Collection Strategies Division.
FR Doc. E8-13016 Filed 6-9-08; 8:45 am
BILLING CODE 6560-50-P
