Airworthiness standards: Special conditions Dassault Model Falcon 10 Series airplanes,
[Federal Register: August 11, 2003 (Volume 68, Number 154)]
[Rules and Regulations]
[Page 47445-47447]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr11au03-1]
Rules and Regulations Federal Register
This section of the FEDERAL REGISTER contains regulatory documents having general applicability and legal effect, most of which are keyed to and codified in the Code of Federal Regulations, which is published under 50 titles pursuant to 44 U.S.C. 1510.
The Code of Federal Regulations is sold by the Superintendent of Documents. Prices of new books are listed in the first FEDERAL REGISTER issue of each week.
[[Page 47445]]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 25
[Docket No. NM260, Special Conditions No. 25-242-SC]
Special Conditions: Dassault Model Falcon 10 Series Airplanes; High Intensity Radiated Fields (HIRF)
AGENCY: Federal Aviation Administration (FAA) DOT.
ACTION: Final special conditions; request for comments.
SUMMARY: These special conditions are issued for the Dassault Model Falcon 10 series airplanes. These airplanes, as modified by Frederick A. Whitson, will have novel and unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. The modification incorporates the installation of the IS&S Digital Air Data System. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for the protection of these systems from the effects of high- intensity radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that provided by the existing airworthiness standards.
DATES: The effective date of these special conditions is July 31, 2003. Comments must be received on or before September 10, 2003.
ADDRESSES: Comments on these special conditions may be mailed in duplicate to: Federal Aviation Administration, Transport Airplane Directorate, Attn: Rules Docket (ANM-113), Docket No. NM260, 1601 Lind Avenue SW., Renton, Washington, 98055-4056; or delivered in duplicate to the Transport Airplane Directorate at the above address. All comments must be marked: Docket No. NM260. Comments may be inspected in the Rules Docket weekdays, except Federal holidays, between 7:30 a.m. and 4 p.m.
FOR FURTHER INFORMATION CONTACT: Greg Dunn, FAA, Airplane and Flight Crew Interface Branch, ANM-111, Transport Airplane Directorate, Aircraft Certification Service, 1601 Lind Avenue SW., Renton, Washington 98055-4056; telephone (425) 227-2799; facsimile (425) 227- 1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
The FAA has determined that notice and opportunity for prior public comment are unnecessary in accordance with 14 CFR 11.38, because the FAA has provided previous opportunities to comment on substantially identical special conditions and has fully considered and addressed all the substantive comments received. Based on a review of the comment history and the comment resolution, the FAA is satisfied that new comments are unlikely. The FAA, therefore, finds that good cause exists for making these special conditions effective upon issuance. However, the FAA invites interested persons to participate in this rulemaking by submitting comments, data, or views. The most helpful comments reference a specific portion of the special conditions, explain the reason for any recommended change, and include supporting data. We ask that you send us two copies of written comments.
We will file in the docket all comments we receive, as well as a report summarizing each substantive public contact with FAA personnel concerning these special conditions. The docket is available for public inspection before and after the comment closing date. If you wish to review the docket in person, go to the address in the ADDRESSES section of this preamble between 7:30 a.m. and 4 p.m., Monday through Friday, except Federal holidays.
We will consider all comments we receive on or before the closing date for comments. We will consider comments filed late if it is possible to do so without incurring expense or delay. We may change these special conditions in light of the comments we receive.
If you want the FAA to acknowledge receipt of your comments on this proposal, include with your comments a pre-addressed, stamped postcard on which the docket number appears. We will stamp the date on the postcard and mail it back to you.
Background
On May 3, 2003, Frederick A. Whitson, 7700 Ouray Road, Albuquerque, NM 87120, applied to the FAA, Fort Worth Special Certification Office, for a supplemental type certificate (STC) to modify certain Dassault Model Falcon 10 series airplanes. These airplanes are two-flightcrew, two-engine airplanes. The proposed modification incorporates the installation of an IS&S Digital Air Data System. This system replaces the equipment originally installed in these airplanes, which was not accurate enough for reduced vertical separation minimum (RVSM) requirements. The information presented by this equipment is flight critical. The IS&S Digital Air Data System to be installed in this airplane has the potential to be vulnerable to high-intensity radiated fields (HIRF) external to the airplane.
Type Certification Basis
Under the provisions of 14 CFR 21.101, Frederick A. Whitson must show that the modified Dassault Model Falcon 10 series airplanes, as changed, continue to meet the applicable provisions of the regulations incorporated by reference in Type Certificate No. A33EU, or the applicable regulations in effect on the date of application for the change. The regulations incorporated by reference in the type certificate are commonly referred to as the ``original type certification basis.''
The regulations incorporated by reference in Type Certificate No. A33EU include 14 CFR part 25 dated February 1, 1964, including Amendments Nos. 25-1 through 25-20. Type Certificate A33EU was issued September 20, 1973.
If the Administrator finds that the applicable airworthiness regulations (i.e., 14 CFR part 25, as amended) do not contain adequate or appropriate safety standards for the modified Dassault Model Falcon 10 series airplanes, as modified by Frederick A. Whitson, because of a novel or unusual design feature, special conditions are prescribed under the provisions of Sec. 21.16.
[[Page 47446]]
In addition to the applicable airworthiness regulations and special conditions, the Dassault Model Falcon 10 series airplanes must comply with the fuel vent and exhaust emission requirement of 14 CFR part 34 and the noise certification requirement of part 36.
Special conditions, as defined in 14 CFR 11.19, are issued in accordance with Sec. 11.38 and become part of the type certification basis in accordance with Sec. 21.101(b)(2).
Special conditions are initially applicable to the model for which they are issued. Should Frederick A. Whitson apply at a later date for a supplemental type certificate to modify any other model included on the same type certificate to incorporate the same novel or unusual design feature, these special conditions would also apply to the other model.
Novel or Unusual Design Features
The modified Falcon 10 will incorporate new avionics/electronics and electrical systems that will perform critical functions. These systems may be vulnerable to HIRF external to the airplane. The current airworthiness standards (14 CFR part 25) do not contain adequate or appropriate safety standards that address protecting this equipment from the adverse effects of HIRF. Accordingly, these instruments are considered to be a novel or unusual design feature.
Discussion
There is no specific regulation that addresses protection requirements for electrical and electronic systems from HIRF. Increased power levels from ground-based radio transmitters and the growing use of sensitive avionics/electronics and electrical systems to command and control airplanes have made it necessary to provide adequate protection.
To ensure that a level of safety is achieved equivalent to that intended by the regulations incorporated by reference, special conditions are needed for the Falcon 10. These special conditions require that new avionics/electronics and electrical systems that perform critical functions be designed and installed to preclude component damage and interruption of function due to both the direct and indirect effects of HIRF.
High-Intensity Radiated Fields (HIRF)
With the trend toward increased power levels from ground-based transmitters, plus the advent of space and satellite communications coupled with electronic command and control of the airplane, the immunity of critical digital avionics/electronics and electrical systems to HIRF must be established.
It is not possible to precisely define the HIRF to which the airplane will be exposed in service. There is also uncertainty concerning the effectiveness of airframe shielding for HIRF. Furthermore, coupling of electromagnetic energy to cockpit-installed equipment through the cockpit window apertures is undefined. Based on surveys and analysis of existing HIRF emitters, an adequate level of protection exists when compliance with the HIRF protection special condition is shown with either paragraph 1 or 2 below:
-
A minimum threat of 100 volts rms (root-mean-square) per meter electric field strength from 10 KHz to 18 GHz.
-
The threat must be applied to the system elements and their associated wiring harnesses without the benefit of airframe shielding.
-
Demonstration of this level of protection is established through system tests and analysis.
-
-
A threat external to the airframe of the field strengths indicated in the following table for the frequency ranges indicated. Both peak and average field strength components from the table are to be demonstrated.
Field strength (volts per meter) Frequency
--------------------- Peak Average
10 kHz-100 kHz....................................
50
50 100 kHz-500 kHz...................................
50
50 500 kHz-2 MHz.....................................
50
50 2 MHz-30 MHz......................................
100
100 30 MHz-70 MHz.....................................
50
50 70 MHz-100 MHz....................................
50
50 100 MHz-200 MHz...................................
100
100 200 MHz-400 MHz...................................
100
100 400 MHz-700 MHz...................................
700
50 700 MHz-1 GHz.....................................
700
100 1 GHz-2 GHz....................................... 2000
200 2 GHz-4 GHz....................................... 3000
200 4 GHz-6 GHz....................................... 3000
200 6 GHz-8 GHz....................................... 1000
200 8 GHz-12 GHz...................................... 3000
300 12 GHz-18 GHz..................................... 2000
200 18 GHz-40 GHz.....................................
600 200
The field strengths are expressed in terms of peak of the root-mean- square (rms) over the complete modulation period.
The threat levels identified above are the result of an FAA review of existing studies on the subject of HIRF, in light of the ongoing work of the Electromagnetic Effects Harmonization Working Group of the Aviation Rulemaking Advisory Committee.
Applicability
As discussed above, these special conditions are applicable to Dassault Model Falcon 10 series airplanes modified by Frederick A. Whitson to include an IS&S Digital Air Data System. Should Frederick A. Whitson apply at a later date for a supplemental type certificate to modify any other model already included on Type Certificate No. A33EU to incorporate the same novel or unusual design feature, these special conditions would apply to that model as well under the provisions of 14 CFR 21.101(a)(1).
Conclusion
This action affects only certain design features on the Dassault Model Falcon 10 series airplanes. It is not a rule of general applicability and affects only the applicant who applied to the FAA for approval of these features on the airplane.
The substance of the special conditions for these airplanes has been subjected to the notice and comment procedure in several prior instances and has been derived without substantive change from those previously issued. Because a delay would significantly affect the certification of the airplane, which is imminent, the FAA has determined that prior public notice and comment are unnecessary and impracticable, and good cause exists for adopting these special conditions upon issuance. The FAA is requesting comments to allow interested persons to submit views that may not have been submitted in response to the prior opportunities for comment described above.
List of Subjects in 14 CFR Part 25
Aircraft, Aviation safety, Reporting and recordkeeping requirements.
The authority citation for these special conditions is as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701, 44702, 44704.
The Special Conditions
Accordingly, pursuant to the authority delegated to me by the Administrator, the following special conditions are issued as part of the supplemental type certification basis for Dassault Model Falcon 10 series airplanes modified by Frederick A. Whitson:
-
Protection From Unwanted Effects of High-Intensity Radiated Fields (HIRF). Each electrical and electronic system that performs critical functions must be designed and installed to ensure that the operation and operational capability of these systems to perform critical functions are not adversely affected when the airplane is exposed to high intensity radiated fields external to the airplane.
[[Page 47447]]
-
For the purpose of these special conditions, the following definition applies:
Critical Functions: Functions whose failure would contribute to or cause a failure condition that would prevent the continued safe flight and landing of the airplane.
Issued in Renton, Washington, on July 31, 2003. Ali Bahrami, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 03-20400 Filed 8-8-03; 8:45 am]
BILLING CODE 4910-13-P
