Airworthiness Directives: Agusta S.p.a. Model A109E and A119 Helicopters
Federal Register: March 19, 2008 (Volume 73, Number 54)
Proposed Rules
Page 14733-14735
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
DOCID:fr19mr08-27
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration 14 CFR Part 39
Docket No. FAA-2008-0327; Directorate Identifier 2007-SW-21-AD
RIN 2120-AA64
Airworthiness Directives; Agusta S.p.a. Model A109E and A119
Helicopters
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
SUMMARY: We propose to adopt a new airworthiness directive (AD) for the specified helicopters. This proposed AD results from a mandatory continuing airworthiness information (MCAI) AD originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The European Aviation Safety Agency
(EASA), the Technical Agent for Italy, with which we have a bilateral agreement, states in the MCAI:
Some cases of interference between the hydraulic pipe, P/N 109- 0761-65-103, and the tail rotor control rod assembly have been detected on Model A109E helicopters.
The interference, if not corrected, could damage the hydraulic pipes and lead to the loss of the hydraulic system No. 1 in flight.
This AD * * * is issued to extend the same mandatory corrective actions to A119 model due to its design similarity with A109E.
The proposed AD would require actions that are intended to address this unsafe condition.
DATES: We must receive comments on this proposed AD by April 18, 2008.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http:// www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590, between 9 a.m. and 5 p.m.,
Monday through Friday, except Federal holidays.
You may get the service information identified in this proposed AD from Agusta, 21017 Cascina Costa di Samarate (VA) Italy, Via Giovanni
Agusta 520, telephone 39 (0331) 229111, fax 39 (0331) 229605-222595.
Examining the AD Docket: You may examine the AD docket on the
Internet at http://www.regulations.gov or in person at the Docket
Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the economic evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647- 5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Uday Garadi, Aviation Safety Engineer,
FAA, Rotorcraft Directorate, Regulations and Guidance Group, Fort
Worth, Texas 76193-0110, telephone (817) 222-5123, fax (817) 222-5961.
SUPPLEMENTARY INFORMATION:
Streamlined Issuance of AD
The FAA is implementing a new process for streamlining the issuance of ADs related to MCAI. This streamlined process will allow us to adopt
MCAI safety requirements in a more efficient manner and will reduce safety risks to the public. This process continues to follow all FAA AD issuance processes to meet legal, economic, Administrative Procedure
Act, and Federal Register requirements. We also continue to meet our technical decisionmaking responsibilities to identify and correct unsafe conditions on U.S.-certificated products.
This proposed AD references the MCAI and related service information that we considered in forming the engineering basis to correct the unsafe condition. The proposed AD contains text copied from the MCAI and for this reason might not follow our plain language principles.
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2008-0327;
Directorate Identifier 2007-SW-21-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http:// www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
The European Aviation Safety Agency (EASA), which is the Technical
Agent for the Member States of the European Community, has issued an
MCAI in the form of EASA AD No. 2007-0231, dated August 23, 2007
(referred to after this as ``the MCAI''), to correct an unsafe condition for these Italian-certificated products. The MCAI states:
Some cases of interference between the hydraulic pipe, P/N 109- 0761-65-103, and the tail rotor control rod assembly have been detected on Model A109E helicopters.
The interference, if not corrected, could damage the hydraulic pipes and lead to the loss of the hydraulic system No. 1 in flight.
This AD * * * is issued to extend the same mandatory corrective actions to A119 model due to its design similarity with A109E.
You may obtain further information by examining the MCAI and service information in the AD docket.
Relevant Service Information
Agusta has issued Bollettino Tecnico (BT) No. 109EP-73, dated
December 4, 2006, applicable to Model A109E helicopters, and BT No. 119-22, dated July 11, 2007, applicable to Model A119 helicopters. The actions described in the MCAI are intended to correct the same unsafe condition as that identified in the service information.
FAA's Determination and Requirements of This Proposed AD
These model helicopters have been approved by the aviation authority of Italy, and are approved for operation in the United
States. Pursuant to our bilateral agreement with this State of Design
Authority, we have been notified of the unsafe condition described in the MCAI and service information. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of these same type designs.
Differences Between This AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in
Page 14734
general, agree with their substance. However, this AD requires replacement of hydraulic lines within 180 days, unless previously accomplished, instead of replacing the hydraulic lines on the dates specified in the MCAI. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information. These differences are highlighted in the
``Differences Between the FAA AD and the MCAI'' section in the proposed
AD.
Costs of Compliance
We estimate that this proposed AD would affect about 78 helicopters of U.S. registry and that it would take about 2 work-hours per helicopter to inspect and 16 work-hours per helicopter to replace the hydraulic lines. The average labor rate is $80 per work-hour. Required parts would cost about $562 per helicopter, assuming these parts are no longer under warranty. However, because the service information lists these parts as covered under warranty, we have assumed that there will be no charge for these parts.
Therefore, as we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $112,320, or $1,440 per helicopter.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared an economic evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended] 2. The FAA amends Sec. 39.13 by adding the following new AD:
Agusta. S.p.a.: Docket No. FAA-2008-0327; Directorate Identifier 2007-SW-21-AD.
Comments Due Date
(a) We must receive comments by April 18, 2008.
Other Affected ADs
(b) None.
Applicability
(c) This AD applies to Agusta S.p.a. Model A109E and A119 helicopters, with hydraulic lines, part number (P/N) 109-0761-64-103 or P/N 109-0761-65-103, installed, certificated in any category.
Reason
(d) The mandatory continuing airworthiness information (MCAI) states:
Some cases of interference between the hydraulic pipe, P/N 109- 0761-65-103, and the tail rotor control rod assembly have been detected on Model A109E helicopters.
The interference, if not corrected, could damage the hydraulic pipes and lead to the loss of the hydraulic system No. 1 in flight.
This AD * * * is issued to extend the same mandatory corrective actions to A119 model due to its design similarity with A109E.
Actions and Compliance
(e) Within the next 50 hours time-in-service (TIS), unless accomplished previously, and thereafter at intervals not to exceed 100 hours TIS:
(1) Inspect for interference between the hydraulic lines, P/N 109-0761-64-103 and P/N 109-0761-65-103, and the tail rotor control rod assembly, P/N 109-0032-01-41, in accordance with the Compliance
Instructions, Part I, paragraph 3, of Agusta Bollettino Tecnico (BT)
No. 109EP-73, dated December 4, 2006 (BT A109E), which is applicable to Model A109E helicopters, or BT 119-22, dated July 11, 2007 (BT 119-22), which is applicable to Model A119 helicopters.
(2) If you find interference between the hydraulic lines and the tail rotor control rod assembly, replace the hydraulic lines, P/N 109-0761-64-103 and P/N 109-0761-65-103, with hydraulic lines, P/N 109-0763-96-101 and P/N 109-0763-97-101, respectively, in accordance with the Compliance Instructions, Part II of BT A109E or BT 119-22, whichever is applicable to your model helicopter.
(f) Within 180 days, replace hydraulic lines, P/N 109-0761-64- 103 and P/N 109-0761-65-103, with hydraulic lines, P/N 109-0763-96- 101 and P/N 109-0763-97-101, respectively, in accordance with the
Compliance Instructions, Part II, of BT A109E or BT 119-22, whichever is applicable to your model helicopter.
Differences Between the FAA AD and the MCAI
(g) This AD requires replacement of hydraulic lines, P/N 109- 0761-64-103 and P/N 109-0761-65-103, within 180 days, unless previously accomplished, instead of replacing the hydraulic lines on the dates specified in the MCAI.
Subject
(h) Air Transport Association of America (ATA) Code 2910--Main
Hydraulic System.
Other Information
(i) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager,
Regulations and Policy Group, FAA, has the authority to approve
AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Uday Garadi, Aviation Safety
Engineer, FAA, Rotorcraft Directorate, Regulations and Guidance
Group, Fort Worth, Texas 76193-0110, telephone (817) 222-5123, fax
(817) 222-5961.
(2) Airworthy Product: Use only FAA-approved corrective actions.
Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent) if the
State of Design has an appropriate bilateral agreement with the
United States. You are required to assure the product is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the
Office of Management and Budget (OMB)
Page 14735
has approved the information collection requirements and has assigned OMB Control Number 2120-0056.
Related Information
(j) MCAI EASA AD No 2007-0231, dated August 23, 2007 contains related information.
Issued in Fort Worth, Texas, on March 10, 2008.
Mark R. Schilling,
Acting Manager, Rotorcraft Directorate, Aircraft Certification Service.
FR Doc. E8-5495 Filed 3-18-08; 8:45 am
BILLING CODE 4910-13-P
