Airworthiness Directives: Airbus A318, A319, A320, and A321 Series Airplanes

Federal Register: May 2, 2008 (Volume 73, Number 86)

Rules and Regulations

Page 24160-24162

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

DOCID:fr02my08-11

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration 14 CFR Part 39

Docket No. FAA-2007-0081; Directorate Identifier 2007-NM-186-AD;

Amendment 39-15497; AD 2008-09-16

RIN 2120-AA64

Airworthiness Directives; Airbus A318, A319, A320, and A321

Series Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of

Transportation (DOT).

ACTION: Final rule.

SUMMARY: We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

A number of occurrences of an incorrect installation of the trimmable horizontal stabilizer actuator (THSA) have been found and reported during the accomplishment of the AIRBUS Service Bulletin

(SB) A320-27-1164 mandated by EASA AD 2006-0223.

These issues could lead to a degradation of the integrity of the

THSA primary load path and to secondary load path partial or full engagement.

* * * * *

Degradation of the THSA primary load path could result in latent

(undetected) loading and eventual failure of the THSA secondary load path, with consequent uncontrolled movement of the horizontal stabilizer and loss of control of the airplane. We are issuing this AD to require actions to correct the unsafe condition on these products.

DATES: This AD becomes effective June 6, 2008.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of June 6, 2008.

ADDRESSES: You may examine the AD docket on the Internet at http:// www.regulations.gov or in person at the U.S. Department of

Transportation, Docket Operations, M-30, West Building, Ground Floor,

Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

FOR FURTHER INFORMATION CONTACT: Tim Dulin, Aerospace Engineer,

International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2141; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products.

That NPRM was published in the Federal Register on October 25, 2007 (72

FR 60591). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

A number of occurrences of an incorrect installation of the trimmable horizontal stabilizer actuator (THSA) have been found and reported during the accomplishment of the AIRBUS Service Bulletin

(SB) A320-27-1164 mandated by EASA AD 2006-0223.

These issues could lead to a degradation of the integrity of the

THSA primary load path and to secondary load path partial or full engagement. This AD therefore mandates a one-time detailed visual inspection of specific parts of the THSA attachments.

Degradation of the THSA primary load path could result in latent

(undetected) loading and eventual failure of the THSA secondary load path, with consequent uncontrolled movement of the horizontal stabilizer and loss of control of the airplane. The corrective actions include doing a one-time detailed visual inspection of the lower and the upper THSA attachments for correct installation and the presence of metallic particles, contacting Airbus for repair instructions if any installation deviations or metallic particles are found, and doing repairs. You may obtain further information by examining the MCAI in the AD docket.

Comments

We gave the public the opportunity to participate in developing this AD. We considered the comment received.

Request to Withdraw the NPRM

The Air Transport Association (ATA), on behalf of its member

Northwest Airlines (NWA), requests that we reconsider the need for this proposed AD. NWA states that the proposed rule is based on reports from

Airbus of a number of occurrences of incorrect THSA installations that resulted from published procedures not being followed either during aircraft production or by operators after delivery of the aircraft. NWA agrees that an incorrectly installed THSA could be a safety concern, but asserts that accomplishing a one-time inspection will not prevent improper THSA installations in the future, and does not understand what corrective action is being taken (or should be taken) to prevent similar installation problems in the future. Furthermore, NWA feels that the airplane maintenance manual (AMM) is clear and concise regarding THSA installation procedures and states that, unless incorrect installations were accomplished during production or the AMM installation instructions were incorrect, a one-time inspection mandated by an AD is unwarranted. NWA asserts that it has accomplished

AD 2007-06-02, amendment 39-14983 (72 FR 12072, March 15, 2007), on all its Model A319 and A320 airplanes with no findings of note. (AD 2007- 06-02, which corresponds to EASA AD 2006-0223, dated July 21, 2006, requires inspections of the upper and lower THSA attachments for proper clearances, and for the presence of cracking, damage, and metallic particles.) NWA concludes that incorrect installations due to operator error should be addressed by actions other than issuing an all-fleet

AD.

Although we understand NWA's concern, we do not agree with this request. If incorrect THSA installation was limited to only one operator (an isolated case of not following maintenance instructions), an AD would not have been an appropriate method of dealing with the situation. However, as THSA installation errors have been reported at multiple operators, and installation errors could result in the identified unsafe condition that is likely to exist or develop on other airplanes, an AD is appropriate. Further, we have determined that, although technically correct, the maintenance instructions were insufficiently clear to ensure that no confusion could occur during installation of the THSA. In regard to future installations, Airbus has informed us that the maintenance instructions have been revised and clarified to prevent confusion during any future installation of the

THSA. We have not changed the AD in this regard.

Conclusion

We reviewed the available data, including the comment received, and determined that air safety and the public interest require adopting the

AD as proposed.

Page 24161

Differences Between This AD and the MCAI or Service Information

We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the

AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a NOTE within the AD.

Costs of Compliance

We estimate that this AD will affect 721 products of U.S. registry.

We also estimate that it will take about 3 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $80 per work-hour. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $173,040, or $240 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation

Programs,'' describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in

``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the

ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment 0

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2008-09-16 Airbus: Amendment 39-15497. Docket No. FAA-2007-0081;

Directorate Identifier 2007-NM-186-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective June 6, 2008.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Airbus A318, A319, A320, and A321 series airplanes, certificated in any category, all certified models, all manufactured serial numbers (MSN) up to and including MSN 2860.

Subject

(d) Air Transport Association (ATA) of America Code 27: Flight

Controls.

Reason

(e) The mandatory continuing airworthiness information (MCAI) states:

A number of occurrences of an incorrect installation of the trimmable horizontal stabilizer actuator (THSA) have been found and reported during the accomplishment of the AIRBUS Service Bulletin

(SB) A320-27-1164 mandated by EASA AD 2006-0223.

These issues could lead to a degradation of the integrity of the

THSA primary load path and to secondary load path partial or full engagement.

This AD therefore mandates a one-time detailed visual inspection of specific parts of the THSA attachments.

Degradation of the THSA primary load path could result in latent

(undetected) loading and eventual failure of the THSA secondary load path, with consequent uncontrolled movement of the horizontal stabilizer and loss of control of the airplane. The corrective actions include doing a one-time detailed visual inspection of the lower and the upper THSA attachments for correct installation and the presence of metallic particles, contacting Airbus for repair instructions if any installation deviations or metallic particles are found, and doing repairs.

Actions and Compliance

(f) Unless already done, do the following actions.

(1) Within 600 flight hours or 750 flight cycles or 100 days after the effective date of this AD, whichever occurs first, inspect the lower and the upper THSA attachments for installation deviations and metallic particles, in accordance with Airbus Service Bulletin

A320-27A1179, dated January 12, 2007; and, if any installation deviations or metallic particles are found, before further flight, contact Airbus for repair instructions and repair.

FAA AD Differences

Note: This AD differs from the MCAI and/or service information as follows: No Difference.

Other FAA AD Provisions

(g) The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager,

International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tim

Dulin, Aerospace Engineer, International Branch, ANM-116, Transport

Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-2141; fax (425) 227-1149. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight

Standards District Office (FSDO), or lacking a PI, your local FSDO.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered

FAA-approved if they

Page 24162

are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the

Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120- 0056.

Related Information

(h) Refer to European Aviation Safety Agency (EASA)

Airworthiness Directive 2007-0178, dated June 22, 2007; and Airbus

Service Bulletin A320-27A1179, dated January 12, 2007; for related information.

Material Incorporated by Reference

(i) You must use Airbus Service Bulletin A320-27A1179, dated

January 12, 2007, to do the actions required by this AD, unless the

AD specifies otherwise.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5

U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact

Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France.

(3) You may review copies at the FAA, Transport Airplane

Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the

National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr- locations.html.

Issued in Renton, Washington, on April 18, 2008.

Ali Bahrami,

Manager, Transport Airplane Directorate, Aircraft Certification

Service.

FR Doc. E8-9441 Filed 5-1-08; 8:45 am

BILLING CODE 4910-13-P