Airworthiness directives: BAE Systems (Operations) Ltd.,
[Federal Register: January 7, 2004 (Volume 69, Number 4)]
[Rules and Regulations]
[Page 869-871]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr07ja04-6]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
[Docket No. 2002-NM-144-AD; Amendment 39-13421; AD 2004-01-07]
RIN 2120-AA64
Airworthiness Directives; BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to certain BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ series airplanes. This AD requires one-time inspections of the inner webs and flanges at frames 15, 18, 41, and 43 for evidence of corrosion or cracking; and corrective actions if necessary. This action is necessary to detect and correct corrosion and cracking of the inner webs and flanges at frames 15, 18, 41, and 43, which could result in reduced structural integrity of the airplane. This action is intended to address the identified unsafe condition.
DATES: Effective February 11, 2004.
The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of February 11, 2004.
ADDRESSES: The service information referenced in this AD may be obtained from British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Todd Thompson, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-1175; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ series
[[Page 870]]
airplanes was published in the Federal Register on November 13, 2003 (68 FR 64288). That action proposed to require one-time inspections of the inner webs and flanges at frames 15, 18, 41, and 43 for evidence of corrosion or cracking, and corrective actions if necessary.
Comments
Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.
Conclusion
After careful review of the available data, the FAA has determined that air safety and the public interest require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 55 airplanes of U.S. registry will be affected by this AD, that it will take approximately 10 work hours per airplane to accomplish the required inspections, and that the average labor rate is $65 per work hour. Based on these figures, the cost impact of this AD on U.S. operators is estimated to be $35,750, or $650 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
Regulatory Impact
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
0 Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0 2. Section 39.13 is amended by adding the following new airworthiness directive:
2004-01-07 BAE Systems (Operations) Limited (Formerly British Aerospace Regional Aircraft): Amendment 39-13421. Docket 2002-NM- 144-AD.
Applicability: Model BAe 146 and Avro 146-RJ series airplanes, certificated in any category; except those airplanes on which either BAe Modification HCM30514A or HCM30514C, and either HCM30514B or HCM30514D, have been accomplished.
Compliance: Required as indicated, unless accomplished previously.
To detect and correct corrosion and cracking of the inner webs and flanges at frames 15, 18, 41, and 43, which could result in reduced structural integrity of the airplane, accomplish the following:
Inspection
(a) Except as provided by paragraph (c) of this AD: Do a detailed inspection of frames 15, 18, 41, and 43 (including any applicable repair) by accomplishing all actions specified in the Accomplishment Instructions of BAE Systems (Operations) Limited Inspection Service Bulletin ISB.53-165, dated December 11, 2001. Do the inspection at the applicable time specified in paragraph (b) of this AD.
Note 1: For the purposes of this AD, a detailed inspection is defined as: ``An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.''
Compliance Times
(b) Do the inspection required by paragraph (a) of this AD at the applicable time specified in paragraph D., ``Compliance,'' of the service bulletin, except where the service bulletin specifies ``time period from first flight'' or ``years of age,'' this AD establishes the thresholds in terms of years after the date of issuance of the original Airworthiness Certificate or the date of issuance of the Export Certificate of Airworthiness, whichever is earlier. Where the service bulletin specifies compliance times relative to the date of the service bulletin, this AD requires compliance times relative to the effective date of this AD.
Corrective Actions
(c) If any discrepancy is found during any inspection required by paragraph (a) of this AD, before further flight, accomplish the applicable repair in accordance with the Accomplishment Instructions of BAE Systems (Operations) Limited Inspection Service Bulletin ISB.53-165, dated December 11, 2001. If the service bulletin specifies to contact the manufacturer for appropriate action, before further flight, repair per a method approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate; or the Civil Aviation Authority (or its delegated agent).
Submission of Inspection Results Not Required
(d) Although the service bulletin referenced in this AD specifies to submit information to the manufacturer, this AD does not include such a requirement.
Alternative Methods of Compliance
(e) In accordance with 14 CFR 39.19, the Manager, International Branch, ANM-116, FAA, is authorized to approve alternative methods of compliance for this AD.
Incorporation by Reference
(f) Unless otherwise specified in this AD, the actions shall be done in accordance with BAE Systems (Operations) Limited Inspection Service Bulletin ISB.53-165, dated December 11, 2001. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Note 2: The subject of this AD is addressed in British airworthiness directive 004-12-2001.
Effective Date
(g) This amendment becomes effective on February 11, 2004.
[[Page 871]]
Issued in Renton, Washington, on December 29, 2003. Ali Bahrami, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 04-128 Filed 1-6-04; 8:45 am]
BILLING CODE 4910-13-P
