Airworthiness directives: BAE Systems (Operations) Ltd.,

[Federal Register: July 28, 2003 (Volume 68, Number 144)]

[Rules and Regulations]

[Page 44196-44197]

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

[DOCID:fr28jy03-2]

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2002-NM-62-AD; Amendment 39-13246; AD 2003-15-04]

RIN 2120-AA64

Airworthiness Directives; BAE Systems (Operations) Limited (Jetstream) Model 4101 Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to all BAE Systems (Operations) Limited (Jetstream) Model 4101 airplanes, that requires inspection of the drive trunnion pins for the main landing gear (MLG) doors to determine the part number of the pins and corrective action if necessary. The actions specified by this AD are intended to prevent failure of the MLG and consequent reduced controllability of the airplane during takeoff or landing.

DATES: Effective September 2, 2003.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of September 2, 2003.

ADDRESSES: The service information referenced in this AD may be obtained from British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., Suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Todd Thompson, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-1175, fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to all BAE Systems (Operations) Limited (Jetstream) Model 4101 airplanes was published in the Federal Register on April 15, 2003 (68 FR 18168). That action proposed to require inspection of the drive trunnion pins for the main landing gear (MLG) doors to determine the part number of the pins, and corrective action if necessary.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Changes to 14 CFR Part 39/Effect on the AD

On July 10, 2002, the FAA issued a new version of 14 CFR part 39 (67 FR 47997, July 22, 2002), which governs the FAA's airworthiness directives system. The regulation now includes material that relates to altered products, special flight permits, and alternative methods of compliance. However, for clarity and consistency in this final rule, we have retained the language of the NPRM regarding that material.

Change to Labor Rate Estimate

After the proposed AD was issued, we reviewed the figures we use to calculate the labor rate to do the required actions. To account for various inflationary costs in the airline industry, we find it appropriate to increase the labor rate used in these calculations from $60 to $65 per work hour. The economic impact information below has been revised to reflect this increase in the specified hourly labor rate.

Cost Impact

The FAA estimates that 57 airplanes of U.S. registry will be affected by this AD, that it will take approximately 2 work hours per airplane to accomplish the required actions, and that the average labor rate is $65 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $7,410, or $130 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment

0 Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration

[[Page 44197]]

amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended]

0 2. Section 39.13 is amended by adding the following new airworthiness directive:

2003-15-04 BAE Systems (Operations) Limited (Formerly British Aerospace Regional Aircraft): Amendment 39-13246. Docket 2002-NM-62- AD.

Applicability: All Model Jetstream 4101 airplanes, certificated in any category.

Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent failure of the main landing gear (MLG) and consequent reduced controllability of the airplane during takeoff or landing, accomplish the following:

Inspection, and Replacement if Necessary

(a) Within 60 days after the effective date of this AD, perform a general visual inspection of the drive trunnion pins for the MLG doors to determine the part number (P/N) of the pins, per ``Part 1-- Inspection'' of the Accomplishment Instructions of BAE Systems (Operations) Limited Service Bulletin J41-32-080, dated January 24, 2002.

Note 2: For the purposes of this AD, a general visual inspection is defined as: ``A visual examination of an interior or exterior area, installation, or assembly to detect obvious damage, failure, or irregularity. This level of inspection is made from within touching distance unless otherwise specified. A mirror may be necessary to enhance visual access to all exposed surfaces in the inspection area. This level of inspection is made under normally available lighting conditions such as daylight, hangar lighting, flashlight, or droplight and may require removal or opening of access panels or doors. Stands, ladders, or platforms may be required to gain proximity to the area being checked.''

(1) If P/N AIR135154 is found on both pins: No further action is required by this paragraph.

(2) If any pin having P/N AIR134402 is found, or if any pin having no P/N is found: Within 90 days after accomplishing the inspection, replace the pin having P/N AIR134402 or the pin having no P/N, with a new, improved pin, per ``Part 2--Rectification'' of the Accomplishment Instructions of the service bulletin.

Alternative Methods of Compliance

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

Note 3: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

Special Flight Permits

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Incorporation by Reference

(d) The actions shall be done in accordance with BAE Systems (Operations) Limited Service Bulletin J41-32-080, dated January 24, 2002. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., Suite 700, Washington, DC.

Note 4: The subject of this AD is addressed in British airworthiness directive 007-01-2002.

Effective Date

(e) This amendment becomes effective on September 2, 2003.

Issued in Renton, Washington, on July 18, 2003. Ali Bahrami, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

[FR Doc. 03-18790 Filed 7-25-03; 8:45 am]

BILLING CODE 4910-13-P