Airworthiness Directives: Boeing Model 737-600, -700, -700C, -800, -900, and -900ER Series Airplanes
Federal Register: August 5, 2008 (Volume 73, Number 151)
Rules and Regulations
Page 45350-45351
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
DOCID:fr05au08-5
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration 14 CFR Part 39
Docket No. FAA-2008-0413; Directorate Identifier 2008-NM-003-AD;
Amendment 39-15631; AD 2008-16-13
RIN 2120-AA64
Airworthiness Directives; Boeing Model 737-600, -700, -700C, - 800, -900, and -900ER Series Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Final rule.
SUMMARY: We are adopting a new airworthiness directive (AD) for certain
Boeing Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. This AD requires replacing the pushrods for the left and right elevator tab control mechanisms with new, improved pushrods. This
AD results from a report of a rod end fracture on a rudder power control unit (PCU) control rod, which is similar to the ones used for the elevator tab pushrods. Analysis revealed that the fractured rod end had an incorrect hardness, which had probably occurred during the manufacture of the control rod. We are issuing this AD to prevent fracture of the elevator tab pushrod ends, which could result in excessive in-flight vibrations of the elevator tab, possible loss of the elevator tab, and consequent loss of controllability of the airplane.
DATES: This AD is effective September 9, 2008.
The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of September 9, 2008.
ADDRESSES: For service information identified in this AD, contact
Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124- 2207.
Examining the AD Docket
You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The address for the
Docket Office (telephone 800-647-5527) is the Document Management
Facility, U.S. Department of Transportation, Docket Operations, M-30,
West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE.,
Washington, DC 20590.
FOR FURTHER INFORMATION CONTACT: Tamara Anderson, Aerospace Engineer,
Airframe Branch, ANM-120S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6421; fax (425) 917-6590.
SUPPLEMENTARY INFORMATION:
Discussion
We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an airworthiness directive (AD) that would apply to certain Boeing Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. That NPRM was published in the Federal Register on
April 24, 2008 (73 FR 22090). That NPRM proposed to require replacing the pushrods for the left and right elevator tab control mechanisms with new, improved pushrods.
Comments
We gave the public the opportunity to participate in developing this AD. We considered the two comments received. Boeing concurs with the contents of the NPRM, and Continental Airlines has no issues with the NPRM.
Conclusion
We reviewed the relevant data, considered the comments received, and determined that air safety and the public interest require adopting the AD as proposed.
Costs of Compliance
We estimate that this AD affects 715 airplanes of U.S. registry. We also estimate that it takes about 4 work-hours per product to comply with this AD. The average labor rate is $80 per work-hour. Required parts cost about $8,036 per product. Based on these figures, we estimate the cost of this AD to the U.S. operators to be $5,974,540, or
$8,356 per product.
Page 45351
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866,
(2) Is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979), and
(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
You can find our regulatory evaluation and the estimated costs of compliance in the AD Docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment 0
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2008-16-13 Boeing: Amendment 39-15631. Docket No. FAA-2008-0413;
Directorate Identifier 2008-NM-003-AD.
Effective Date
(a) This airworthiness directive (AD) is effective September 9, 2008.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Boeing Model 737-600, -700, -700C, -800,
-900, and -900ER series airplanes, certificated in any category; line numbers 1 through 2196 inclusive.
Unsafe Condition
(d) This AD results from a report of a rod end fracture on a rudder power control unit (PCU) control rod, which is similar to the ones used for the elevator tab pushrods. Analysis revealed that the fractured rod end had an incorrect hardness, which had probably occurred during the manufacture of the control rod. We are issuing this AD to prevent fracture of the elevator tab pushrod ends, which could result in excessive in-flight vibrations of the elevator tab, possible loss of the elevator tab, and consequent loss of controllability of the airplane.
Compliance
(e) Comply with this AD within the compliance times specified, unless already done.
Pushrod Replacement
(f) At the time specified in paragraph 1.E., ``Compliance,'' of
Boeing Special Attention Service Bulletin 737-27-1284, dated
November 28, 2007; except, where the service bulletin specifies a compliance time after the date on the service bulletin, this AD requires compliance within the specified compliance time after the effective date of this AD: Replace the pushrods for the left and right elevator tab control mechanisms with new, improved pushrods by doing all the actions in accordance with the Accomplishment
Instructions of Boeing Special Attention Service Bulletin 737-27- 1284, dated November 28, 2007.
Parts Installation
(g) As of the effective date of this AD, no person may install a pushrod assembly, part number 65-45166-24, on any airplane.
Alternative Methods of Compliance (AMOCs)
(h)(1) The Manager, Seattle Aircraft Certification Office (ACO),
FAA, ATTN: Tamara Anderson, Aerospace Engineer, Airframe Branch,
ANM-120S, FAA, Seattle ACO, 1601 Lind Avenue, SW., Renton,
Washington 98057-3356; telephone (425) 917-6421; fax (425) 917-6590; has the authority to approve AMOCs for this AD, if requested, using the procedures found in 14 CFR 39.19.
(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19.
Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA
Flight Standards District Office (FSDO), or lacking a PI, your local
FSDO.
(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD, if it is approved by an
Authorized Representative for the Boeing Commercial Airplanes
Delegation Option Authorization Organization who has been authorized by the Manager, Seattle ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane.
Material Incorporated by Reference
(i) You must use Boeing Special Attention Service Bulletin 737- 27-1284, dated November 28, 2007, to do the actions required by this
AD, unless the AD specifies otherwise.
(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5
U.S.C. 552(a) and 1 CFR part 51.
(2) For service information identified in this AD, contact
Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207.
(3) You may review copies of the service information incorporated by reference at the FAA, Transport Airplane
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the
National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_ regulations/ibr_locations.html.
Issued in Renton, Washington, on July 23, 2008.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
FR Doc. E8-17748 Filed 8-4-08; 8:45 am
BILLING CODE 4910-13-P
