Airworthiness Directives: Dassault Model Falcon 2000EX Airplanes

Federal Register: June 18, 2008 (Volume 73, Number 118)

Rules and Regulations

Page 34613-34615

From the Federal Register Online via GPO Access [wais.access.gpo.gov]

DOCID:fr18jn08-5

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration 14 CFR Part 39

Docket No. FAA-2008-0294; Directorate Identifier 2007-NM-288-AD;

Amendment 39-15558; AD 2008-12-14

RIN 2120-AA64

Airworthiness Directives; Dassault Model Falcon 2000EX Airplanes

AGENCY: Federal Aviation Administration (FAA), Department of

Transportation (DOT).

ACTION: Final rule.

SUMMARY: We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

Analyses of in-service reports revealed that in case of failure of the wings' anti-ice valve, indications of untimely anti-icing with the wings' anti-ice selector on ``OFF'' or of insufficient anti-icing with the wings' anti-ice selector on ``AUTO'' might not be properly displayed to the flight crew. It may result, on ground, in potential structural damages due to a leading edge overheat, or in-flight, in an insufficient anti-ice power.

* * * * *

We are issuing this AD to require actions to correct the unsafe condition on these products.

DATES: This AD becomes effective July 23, 2008.

The Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD as of July 23, 2008.

ADDRESSES: You may examine the AD docket on the Internet at http:// www.regulations.gov or in person at the U.S. Department of

Transportation, Docket Operations, M-30, West Building Ground Floor,

Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer,

International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Discussion

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products.

That NPRM was published in the Federal Register on March 13, 2008 (73

FR 13488). That NPRM proposed to correct an unsafe condition for the specified products. The MCAI states:

Analyses of in-service reports revealed that in case of failure of the wings' anti-ice valve, indications of untimely anti-icing with the wings' anti-ice selector on ``OFF'' or of insufficient anti-icing with the wings' anti-ice selector on ``AUTO'' might not be properly displayed to the flight crew. It may result, on ground, in potential structural damages due to a leading edge overheat, or in-flight, in an insufficient anti-ice power.

This Airworthiness Directive (AD) mandates an upgrade of the wings' anti-ice monitoring circuitry per implementation of modifications M2814 (Service Bulletin (SB) F2000EX-116) and M2949

(SB F2000EX-140) to cover the whole monitoring logic of the wings' anti-ice system.

The modifications include adding a relay between the bleed air computer and the wing anti-ice valve; modifying the aircraft wiring; and rerouting an existing wire between the right- and left-hand electrical cabinets. You may obtain further information by examining the MCAI in the AD docket.

Comments

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Conclusion

We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

Differences Between This AD and the MCAI or Service Information

We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use

Page 34614

different words from those in the MCAI to ensure the AD is clear for

U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the

MCAI and related service information.

We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a NOTE within the AD.

Costs of Compliance

We estimate that this AD will affect about 13 products of U.S. registry. We also estimate that it will take about 46 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $80 per work-hour. Required parts will cost about $1,344 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of this AD to the

U.S. operators to be $65,312, or $5,024 per product.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation

Programs,'' describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in

``Subtitle VII, Part A, Subpart III, section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD: 1. Is not a ``significant regulatory action'' under Executive Order 12866; 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD Docket

You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the

ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

List of Subjects in 14 CFR Part 39

Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.

Adoption of the Amendment 0

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2008-12-14 Dassault Aviation: Amendment 39-15558. Docket No. FAA- 2008-0294; Directorate Identifier 2007-NM-288-AD.

Effective Date

(a) This airworthiness directive (AD) becomes effective July 23, 2008.

Affected ADs

(b) None.

Applicability

(c) This AD applies to Dassault Model Falcon 2000EX airplanes; certificated in any category; having serial numbers 1 through 5 and 7 through 27 inclusive.

Subject

(d) Air Transport Association (ATA) of America Code 30: Ice and

Rain Protection.

Reason

(e) The mandatory continuing airworthiness information (MCAI) states:

Analyses of in-service reports revealed that in case of failure of the wings' anti-ice valve, indications of untimely anti-icing with the wings' anti-ice selector on ``OFF'' or of insufficient anti-icing with the wings' anti-ice selector on ``AUTO'' might not be properly displayed to the flight crew. It may result, on ground, in potential structural damages due to a leading edge overheat, or in-flight, in an insufficient anti-ice power.

This Airworthiness Directive (AD) mandates an upgrade of the wings' anti-ice monitoring circuitry per implementation of modifications M2814 (Service Bulletin (SB) F2000EX-116) and M2949

(SB F2000EX-140) to cover the whole monitoring logic of the wings' anti-ice system.

The modifications include adding a relay between the bleed air computer and the wing anti-ice valve; modifying the aircraft wiring; and rerouting an existing wire between the right- and left-hand electrical cabinets.

Actions and Compliance

(f) Within 6 months after the effective date of this AD, unless already done, modify the electrical wiring of the wings' anti-ice system, in accordance with the Accomplishment Instructions of

Dassault Service Bulletin F2000EX-116, dated May 31, 2006; and

Service Bulletin F2000EX-140, dated February 28, 2007.

FAA AD Differences

Note: This AD differs from the MCAI and/or service information as follows: No differences.

Other FAA AD Provisions

(g) The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager,

International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Tom

Rodriguez, Aerospace Engineer, International Branch, ANM-116,

Transport Airplane Directorate, FAA, 1601 Lind Avenue, SW., Renton,

Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149.

Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA

Flight Standards District Office (FSDO), or lacking a PI, your local

FSDO.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered

FAA-approved if they are approved by the State of Design Authority

(or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(3) Reporting Requirements: For any reporting requirement in this AD, under the

Page 34615

provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056.

Related Information

(h) Refer to MCAI European Aviation Safety Agency (EASA)

Airworthiness Directive 2007-0137, dated May 16, 2007; Dassault

Service Bulletin F2000EX-116, dated May 31, 2006; and Dassault

Service Bulletin F2000EX-140, dated February 28, 2007 for related information.

Material Incorporated by Reference

(i) You must use Dassault Service Bulletin F2000EX-116, dated

May 31, 2006 and Dassault Service Bulletin F2000EX-140, dated

February 28, 2007, as applicable, to do the actions required by this

AD, unless the AD specifies otherwise. Dassault Service Bulletin

F2000EX-140, dated February 28, 2007, contains the following effective pages:

Page No.

Shown on page

1-4, 6-8.................................. February 28, 2007. 5......................................... June 14, 2007.

(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5

U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact

Dassault Falcon Jet, P.O. Box 2000, South Hackensack, New Jersey 07606.

(3) You may review copies at the FAA, Transport Airplane

Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the

National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr- locations.html.

Issued in Renton, Washington, on June 3, 2008.

Michael Kaszycki,

Acting Manager, Transport Airplane Directorate, Aircraft Certification

Service.

FR Doc. E8-13320 Filed 6-17-08; 8:45 am

BILLING CODE 4910-13-P