Airworthiness directives: Empresa Brasileira de Aeronautica S.A. (EMBRAER),
[Federal Register: November 9, 2005 (Volume 70, Number 216)]
[Proposed Rules]
[Page 67948-67949]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr09no05-27]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
[Docket No. FAA-2005-22871; Directorate Identifier 2005-NM-191-AD]
RIN 2120-AA64
Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model EMB-120, -120ER, -120FC, -120QC, and -120RT Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of Transportation (DOT).
ACTION: Notice of proposed rulemaking (NPRM).
SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain EMBRAER Model EMB-120, -120ER, -120FC, -120QC, and -120RT airplanes. This proposed AD would require installing a rivet and washer in the hole of the upper frame of the auxiliary power unit (APU) firewall. This proposed AD results from a report indicating that, during production, a pinhole was left open at the upper frame of the APU firewall. We are proposing this AD to ensure that the APU compartment is isolated from the rest of the airplane in the event of an APU fire.
DATES: We must receive comments on this proposed AD by December 9, 2005.
ADDRESSES: Use one of the following addresses to submit comments on this proposed AD.
DOT Docket Web site: Go to http://dms.dot.gov and follow
the instructions for sending your comments electronically.
Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your
comments electronically.
Mail: Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street SW., Nassif Building, room PL-401, Washington, DC 20590.
Fax: (202) 493-2251.
Hand Delivery: Room PL-401 on the plaza level of the Nassif Building, 400 Seventh Street SW., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Contact Empresa Brasileira de Aeronautica S.A. (EMBRAER), P.O. Box 343-CEP 12.225, Sao Jose dos Campos--SP, Brazil, for service information identified in this proposed AD.
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2125; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to submit any relevant written data, views, or arguments regarding this proposed AD. Send your comments to an address listed in the ADDRESSES section. Include the docket number ``FAA-2005- 22871; Directorate Identifier 2005-NM-191-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the proposed AD. We will consider all comments received by the closing date and may amend the proposed AD in light of those comments.
We will post all comments we receive, without change, to http://dms.dot.gov , including any personal information you provide. We will
also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of that web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78), or you may visit http://dms.dot.gov.
Examining the Docket
You may examine the AD docket on the Internet at http://dms.dot.gov , or in person at the Docket Management Facility office
between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Management Facility office (telephone (800) 647- 5227) is located on the plaza level of the Nassif Building at the DOT street address stated in the ADDRESSES section. Comments will be available in the AD docket shortly after the Docket Management System receives them.
Discussion
The Departmento de Aviacao Civil (DAC), which is the airworthiness authority for Brazil, notified us that an unsafe condition may exist on certain EMBRAER Model EMB-120, -120ER, -120FC, -120QC, and -120RT airplanes. The DAC advises that a pinhole used for the manufacturing process was left open. The hole was at the upper frame of the auxiliary power unit (APU) firewall. To meet the sealing requirements for the firewall, a rivet and stainless steel washer must be installed. In the event of an APU fire, a hole in the firewall would not isolate the APU compartment from the rest of the airplane.
Relevant Service Information
EMBRAER has issued Service Bulletin 120-53-0080, dated November 30, 2004. The service bulletin describes procedures for installing a rivet and stainless steel washer in the hole of the upper frame of the APU firewall. Accomplishing the actions specified in the service information is intended to adequately address the unsafe condition. The DAC mandated the service information and issued Brazilian airworthiness directive 2005-08-03, dated September 5, 2005, to ensure the continued airworthiness of these airplanes in Brazil.
FAA's Determination and Requirements of the Proposed AD
These airplane models are manufactured in Brazil and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, the DAC has kept the FAA informed of the situation described above. We have examined the DAC's findings, evaluated all pertinent information, and determined that we need to issue an AD for airplanes of this type design that are certificated for operation in the United States.
Therefore, we are proposing this AD, which would require accomplishing the actions specified in the service information described previously, except as discussed below.
Differences Between the Proposed AD and the Brazilian Airworthiness Directive
The Brazilian airworthiness directive applies to ``all Embraer EMB- 120( ) aircraft models in operation.'' However, this proposed AD would apply only to the airplanes with the serial numbers identified in the EMBRAER service bulletin. Airplanes not identified receive an equivalent modification during production.
[[Page 67949]]
Costs of Compliance
The following table provides the estimated costs for U.S. operators to comply with this proposed AD.
Estimated Costs
Number of U.S.- Action
Work hours Average labor
Parts
Cost per
registered Fleet cost rate per hour
airplane
airplanes
Rivet installation........................
1
$65 Operator-supplied............
$65
108
$7,020
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, ``General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the proposed regulation:
-
Is not a ``significant regulatory action'' under Executive Order 12866;
-
Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
-
Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
-
The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
-
The Federal Aviation Administration (FAA) amends Sec. 39.13 by adding the following new airworthiness directive (AD):
Empresa Brasileira de Aeronautica S.A. (EMBRAER): Docket No. FAA- 2005-22871; Directorate Identifier 2005-NM-191-AD.
Comments Due Date
(a) The FAA must receive comments on this AD action by December 9, 2005.
Affected ADs
(b) None.
Applicability
(c) This AD applies to EMBRAER Model EMB-120, -120ER, -120FC, - 120QC, and -120RT airplanes, certificated in any category; as identified in EMBRAER Service Bulletin 120-53-0080, dated November 30, 2004.
Unsafe Condition
(d) This AD results from a report indicating that, during production, a pinhole was left open at the upper frame of the auxiliary power unit (APU) firewall. We are issuing this AD to ensure that the APU compartment is isolated from the rest of the airplane in the event of an APU fire.
Compliance
(e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
Rivet Installation
(f) Within 4,000 flight hours or 24 months, whichever occurs first after the effective date of this AD: Install a rivet and washer in the hole of the upper frame of the APU firewall, in accordance with EMBRAER Service Bulletin 120-53-0080, dated November 30, 2004.
Alternative Methods of Compliance (AMOCs)
(g)(1) The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.
(2) Before using any AMOC approved in accordance with Sec. 39.19 on any airplane to which the AMOC applies, notify the appropriate principal inspector in the FAA Flight Standards Certificate Holding District Office.
Related Information
(h) Brazilian airworthiness directive 2005-08-03, dated September 5, 2005, also addresses the subject of this AD.
Issued in Renton, Washington, on October 26, 2005. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 05-22304 Filed 11-8-05; 8:45 am]
BILLING CODE 4910-13-U
