Airworthiness directives: Empresa Brasileira de Aeronautica S.A. (EMBRAER),
[Federal Register: June 12, 2003 (Volume 68, Number 113)]
[Rules and Regulations]
[Page 35157-35158]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr12jn03-4]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2002-NM-88-AD; Amendment 39-13189; AD 2003-12-04]
RIN 2120-AA64
Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model EMB-135 and -145 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to certain EMBRAER Model EMB-135 and -145 series airplanes, that requires replacing the four Gamah clamp/sleeve joints on an engine bleed air duct with new threaded coupling assemblies. For certain airplanes, this AD also requires replacing the two supports for the engine bleed air duct with two new supports. The actions specified by this AD are intended to prevent hot air leaks from the bleed air duct due to disconnection of the duct joint, which could result in heat damage to components near the duct, and consequent increased risk of fire in the rear baggage compartment. This action is intended to address the identified unsafe condition.
DATES: Effective July 17, 2003. The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of July 17, 2003.
ADDRESSES: The service information referenced in this AD may be obtained from Empresa Brasileira de Aeronautica S.A. (EMBRAER), PO Box 343--CEP 12.225, Sao Jose dos Campos--SP, Brazil. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2125; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain EMBRAER Model EMB-135 and -145 series airplanes was published in the Federal Register on January 30, 2003 (68 FR 4725). That action proposed to require replacing the four Gamah clamp/sleeve joints on an engine bleed air duct with new threaded coupling assemblies. For certain airplanes, that action also proposed to require replacing the two supports for the engine bleed air duct with two new supports.
Comments
Interested persons have been afforded an opportunity to participate in the making of this amendment. Due consideration has been given to the comments received.
Support for the Proposed AD
One commenter has no objections to the proposed AD.
Requests To Cite Recent Service Bulletin Versions
The proposed AD cited EMBRAER Service Bulletin 145-36-0024, dated May 31, 2001, as the appropriate source of service information for the proposed requirements. Several commenters request that the FAA revise the proposed AD to reflect the most current revision levels of the service bulletin revisions. (Change 01 of the service bulletin was issued August 7, 2002, and Change 02 was issued December 13, 2002.) One commenter requests that the proposed AD be revised to also allow future revisions of the service bulletin for compliance with the AD to avoid the need for requests and approvals of alternative methods of compliance.
The FAA partially agrees with the requests. Because the actions in both revisions are essentially the same as those in the original service bulletin, paragraph (a) in this final rule has been revised to cite Change 02 and to provide credit for work accomplished in accordance with the original or Change 01 of the service bulletin. However, to use a later revision of the cited service bulletin, affected operators must request approval of an alternative method of compliance under the provisions of paragraph (c) of this final rule. In an AD, use of the phrase ``or later FAA-approved revisions'' in reference to a specific service bulletin violates Office of the Federal Register regulations for approving materials that are incorporated by reference.
Request To Revise Applicability of Proposed AD
One commenter notes that in Change 02 of the service bulletin the effectivity was revised. Because the applicability of the proposed AD excluded certain airplanes listed in the original version of the service bulletin, the commenter requests that the applicability of the proposed AD be revised to refer to Change 02 of the service bulletin.
The FAA agrees. Certain airplanes were removed from the effectivity of the revised service bulletin. Therefore, the applicability statement of this final rule has been revised accordingly.
Conclusion
After careful review of the available data, including the comments noted above, the FAA has determined that air safety and the public interest require the adoption of the rule with the changes described previously. The FAA has determined that these changes will neither increase the economic burden on any operator nor increase the scope of the AD.
Changes to 14 CFR Part 39/Effect on the AD
On July 10, 2002, the FAA issued a new version of 14 CFR part 39 (67 FR 47997, July 22, 2002), which governs the FAA's airworthiness directives system. The regulation now includes material that relates to altered products, special flight permits, and alternative methods of compliance. However, for clarity and consistency in this final rule, we have retained the language of the NPRM regarding that material.
Cost Impact
The FAA estimates that 346 airplanes of U.S. registry will be affected by this AD, that it will take approximately 3 work hours per airplane to accomplish the replacement, and that the average labor rate is $60 per work hour. Required parts will cost approximately between $1,978 and $2,007 per airplane. Based on these figures, the cost impact of the AD on U.S. operators of these airplanes is estimated to be between $746,668 and $756,702; or between $2,158 and $2,187 per airplane.
The cost impact figures discussed above are based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time
[[Page 35158]]
necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
Regulatory Impact
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
0 Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0 2. Section 39.13 is amended by adding the following new airworthiness directive:
2003-12-04--Empresa Brasileira de Aeronautica S.A. (EMBRAER): Amendment 39-13189. Docket 2002-NM-88-AD.
Applicability: Model EMB-135 and -145 series airplanes, as listed in EMBRAER Service Bulletin 145-36-0024, Change 02, dated December 13, 2002; excluding those airplanes listed in ``In- production effectivity'' in paragraph 1.A., ``Effectivity,'' of the service bulletin; certificated in any category.
Note 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent hot air leaks from the bleed air duct due to disconnection of the duct joint, which could result in heat damage to components near the duct, and consequent increased risk of fire in the rear baggage compartment, accomplish the following:
Replacement
(a) Within 1,000 flight hours after the effective date of this AD, do the actions specified in paragraphs (a)(1) and (a)(2) of this AD, as applicable, per EMBRAER Service Bulletin 145-36-0024, Change 02, dated December 13, 2002. Accomplishment of those actions in accordance with EMBRAER Service Bulletin 145-36-0024, dated May 31, 2001; or Change 01, dated August 7, 2002; are acceptable for compliance with the requirements of this paragraph.
(1) For all airplanes: Replace the four Gamah clamp/sleeve joints from the bleed line at the baggage compartment between frames 68 and 69 with new threaded coupling assemblies (including re- identifying, cleaning, and lubricating the bleed ducts; and installing protection sleeves).
(2) For airplanes having serial numbers listed in paragraph 3.G. of the Accomplishment Instructions of the service bulletin: Replace the two supports for the engine bleed air duct with two new supports, having part number 145-35923-007.
Parts Installation
(b) As of the effective date of this AD, no person shall install parts listed in paragraphs (b)(1) and (b)(2) of this AD, as applicable.
(1) For all airplanes: Gamah clamp/sleeve joints, from the bleed line at the baggage compartment between frames 68 and 69, having part number G30020CD, G30020TD, G30020C, or G30020T.
(2) For airplanes having serial numbers listed in paragraph 3.G. of the Accomplishment Instructions of EMBRAER Service Bulletin 145- 36-0024, Change 02, dated December 13, 2002: Supports for the engine bleed air duct, with part number 145-35923-007.
Alternative Methods of Compliance
(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.
Note 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.
Special Flight Permits
(d) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
Incorporation by Reference
(e) Unless otherwise specified in this AD, the actions must be done in accordance with EMBRAER Service Bulletin 145-36-0024, Change 02, dated December 13, 2002. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Empresa Brasileira de Aeronautica S.A. (EMBRAER), PO Box 343--CEP 12.225, Sao Jose dos Campos--SP, Brazil. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Note 3: The subject of this AD is addressed in Brazilian airworthiness directive 2001-09-03, dated October 2, 2001.
Effective Date
(f) This amendment becomes effective on July 17, 2003.
Issued in Renton, Washington, on June 4, 2003. Kalene C. Yanamura, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 03-14524 Filed 6-11-03; 8:45 am]
BILLING CODE 4910-13-P
