Airworthiness Directives: McDonnell Douglas Corp. Model DC-10-10, DC-10-10F, and MD-10-10F Airplanes
Federal Register: January 19, 2010 (Volume 75, Number 11)
Proposed Rules
Page 2831-2833
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
DOCID:fr19ja10-16
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration 14 CFR Part 39
Docket No. FAA-2010-0043; Directorate Identifier 2009-NM-128-AD
RIN 2120-AA64
Airworthiness Directives; McDonnell Douglas Corporation Model DC- 10-10, DC-10-10F, and MD-10-10F Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Notice of proposed rulemaking (NPRM).
SUMMARY: We propose to adopt a new airworthiness directive (AD) for certain McDonnell Douglas Model DC-10-10, DC-10-10F, and MD-10-10F airplanes. This proposed AD would require a one-time high frequency eddy current inspection of fastener holes for cracks at the left and right side wing rear spar lower cap at station Xors=345, and other specified and corrective actions if necessary. This proposed AD results from a report of three instances of Model DC-10-10F airplanes having fuel leaks in the wing rear spar lower cap at station Xors=345. We are proposing this AD to prevent cracks in the spar cap, which if not corrected could lead to cracking of the lower wing skin, fuel leaks, and the inability of the structure to sustain limit load.
DATES: We must receive comments on this proposed AD by March 5, 2010.
ADDRESSES: You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http:// www.regulations.gov. Follow the instructions for submitting comments.
Fax: 202-493-2251.
Mail: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New
Jersey Avenue, SE., Washington, DC 20590, between 9 a.m.
Page 2832
and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact
Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, California 90846- 0001; telephone 206-544-5000, extension 2; fax 206-766-5683; e-mail dse.boecom@boeing.com; Internet https://www.myboeingfleet.com. You may review copies of the referenced service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue SW., Renton,
Washington. For information on the availability of this material at the
FAA, call 425-227-1221 or 425-227-1152.
Examining the AD Docket
You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone 800-647-5527) is in the
ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Carl Fountain, Aerospace Engineer,
Airframe Branch, ANM-120L, FAA, Los Angeles Aircraft Certification
Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5322; fax (562) 627-5210.
SUPPLEMENTARY INFORMATION:
Comments Invited
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include ``Docket No. FAA-2010-0043;
Directorate Identifier 2009-NM-128-AD'' at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.
We will post all comments we receive, without change, to http:// www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion
We have received a report of three instances of Model DC-10-10F airplanes having fuel leaks in the wing rear spar lower cap at station
Xors=345. Investigation revealed the fuel leak was due to a crack in the lower cap. This crack extended into all three legs (aft, forward, and vertical) of the spar cap. Analysis of the cracked portion of the spar cap determined that the crack was due to fatigue and began at a fastener hole in the forward leg of the spar cap. This condition, if not corrected, could lead to cracking of the lower wing skin, fuel leaks, and the inability of the structure to sustain limit load.
Relevant Service Information
We have reviewed Boeing Alert Service Bulletin DC10-57A157, dated
May 12, 2009. The service bulletin describes procedures for:
Doing a high frequency eddy current inspection of fastener holes for cracking at the left and right side wing rear spar lower cap.
Cold working open holes and installing new second oversize fasteners in the left and right side wing rear spar lower cap if no cracking is found.
Contacting Boeing for repair instructions and doing the repair if cracking is found.
FAA's Determination and Requirements of This Proposed AD
We are proposing this AD because we evaluated all relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of these same type designs. This proposed AD would require accomplishing the actions specified in the service information described previously, except as discussed under ``Differences Between the Proposed AD and Service
Bulletin.''
Differences Between the Proposed AD and Service Bulletin
The service bulletin specifies to contact the manufacturer for instructions on how to repair certain conditions, but this proposed AD would require repairing those conditions in one of the following ways:
Using a method that we approve; or
Using data that meet the certification basis of the airplane, and that have been approved by the Boeing Commercial
Airplanes Organization Designation Authorization (ODA) that we have authorized to make those findings.
Costs of Compliance
We estimate that this proposed AD would affect 68 airplanes of U.S. registry. The following table provides the estimated costs for U.S. operators to comply with this proposed AD.
Table--Estimated Costs
Number of
Average
Cost per
U.S.-
Action
Work hours labor rate
product
registered
Fleet cost per hour
airplanes
Inspection................................
2
$80
$160
68
$10,880
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the
Page 2833
distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation: 1. Is not a ``significant regulatory action'' under Executive Order 12866, 2. Is not a ``significant rule'' under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979), and 3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
You can find our regulatory evaluation and the estimated costs of compliance in the AD Docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
The Proposed Amendment
Accordingly, under the authority delegated to me by the
Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended] 2. The FAA amends Sec. 39.13 by adding the following new AD:
McDonnell Douglas Corporation: Docket No. FAA-2010-0043; Directorate
Identifier 2009-NM-128-AD.
Comments Due Date
(a) We must receive comments by March 5, 2010.
Affected ADs
(b) None.
Applicability
(c) This AD applies to McDonnell Douglas Corporation Model DC- 10-10, DC-10-10F, and MD-10-10F airplanes, certificated in any category, as specified in Boeing Alert Service Bulletin DC10-57A157, dated May 12, 2009.
Subject
(d) Air Transport Association (ATA) of America Code 57: Wings.
Unsafe Condition
(e) This AD results from a report of three instances of Model
DC-10-10F airplanes having fuel leaks in the wing rear spar lower cap at station Xors=345. The Federal Aviation Administration is issuing this AD to prevent cracking in the spar cap, which could lead to cracking of the lower wing skin, fuel leaks, and the inability of the structure to sustain limit load.
Compliance
(f) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the actions have already been done.
Inspection
(g) Within 3,000 flight cycles after the effective date of this
AD, do a one-time high frequency eddy current inspection for cracking of fastener holes at the left and right side wing rear spar lower cap at station Xors=345, in accordance with the Accomplishment
Instructions of Boeing Alert Service Bulletin DC10-57A157, dated May 12, 2009.
(1) If no cracking is found, before further flight, cold work open holes and install new second oversize fasteners and nut assemblies in the left and right side wing rear spar lower cap, in accordance with the Accomplishment Instructions of Boeing Alert
Service Bulletin DC10-57A157, dated May 12, 2009.
(2) If any cracking is found during any inspection required by this AD, before further flight, repair the left and right side wing rear spar lower cap using a method approved in accordance with the procedures specified in paragraph (h) of this AD.
Alternative Methods of Compliance (AMOCs)
(h)(1) The Manager, Los Angeles Aircraft Certification Office
(ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Carl Fountain, Aerospace Engineer, Airframe
Branch, ANM-120L, FAA, Los Angeles ACO, 3960 Paramount Boulevard,
Lakewood, California 90712-4137; telephone (562) 627-5322; fax (562) 627-5210.
(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19.
Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office.
The AMOC approval letter must specifically reference this AD.
(3) An AMOC that provides an acceptable level of safety may be used for any repair required by this AD, if it is approved by the
Boeing Commercial Airplanes Organization Designation Authorization
(ODA) that has been authorized by the Manager, Los Angeles ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane and 14 CFR 25.571,
Amendment 45, and the approval must specifically refer to this AD.
Issued in Renton, Washington, on January 8, 2010.
Stephen P. Boyd,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
FR Doc. 2010-699 Filed 1-15-10; 8:45 am
BILLING CODE 4910-13-P
