Airworthiness Directives: McDonnell Douglas Corporation Model MD-11 and MD-11F Airplanes
Federal Register: December 31, 2009 (Volume 74, Number 250)
Rules and Regulations
Page 69249-69252
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
DOCID:fr31de09-3
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration 14 CFR Part 39
Docket No. FAA-2009-0686; Directorate Identifier 2009-NM-044-AD;
Amendment 39-16155; AD 2009-26-16
RIN 2120-AA64
Airworthiness Directives; McDonnell Douglas Corporation Model MD- 11 and MD-11F Airplanes
AGENCY: Federal Aviation Administration (FAA), DOT.
ACTION: Final rule.
SUMMARY: We are adopting a new airworthiness directive (AD) for certain
Model MD-11 and MD-11F airplanes. This AD requires a one-time inspection to determine if wires touch the upper surface of the center upper auxiliary fuel tank and marking the location, if necessary; a one-time inspection of all wire bundles above the center upper auxiliary fuel tank for splices and damage; a one-time inspection for damage to the fuel vapor barrier seal and upper surface of the center upper auxiliary fuel tank; and corrective actions, if necessary. This
AD also requires installation of nonmetallic barrier/shield sleeving, new clamps, new attaching hardware, and a new extruded channel. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to reduce the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors, could result
Page 69250
in fuel tank explosions and consequent loss of the airplane.
DATES: This AD is effective February 4, 2010.
The Director of the Federal Register approved the incorporation by reference of a certain publication listed in the AD as of February 4, 2010.
ADDRESSES: For service information identified in this AD, contact
Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, California 90846- 0001; telephone 206-544-5000, extension 2; fax 206-766-5683; e-mail dse.boecom@boeing.com; Internet https://www.myboeingfleet.com.
Examining the AD Docket
You may examine the AD docket on the Internet at http:// www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The address for the
Docket Office (telephone 800-647-5527) is the Document Management
Facility, U.S. Department of Transportation, Docket Operations, M-30,
West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE.,
Washington, DC 20590.
FOR FURTHER INFORMATION CONTACT: Samuel Lee, Aerospace Engineer,
Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification
Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5262; fax (562) 627-5210.
SUPPLEMENTARY INFORMATION:
Discussion
We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an airworthiness directive (AD) that would apply to certain McDonnell Douglas Corporation Model MD-11 and MD-11F airplanes.
That NPRM was published in the Federal Register on August 19, 2009 (74
FR 41813). That NPRM proposed to require a one-time inspection to determine if wires touch the upper surface of the center upper auxiliary fuel tank and marking the location, if necessary; a one-time inspection of all wire bundles above the center upper auxiliary fuel tank for splices and damage; a one-time inspection for damage to the fuel vapor barrier seal and upper surface of the center upper auxiliary fuel tank; and corrective actions, if necessary. That NPRM also proposed to require installation of nonmetallic barrier/shield sleeving, new clamps, new attaching hardware, and a new extruded channel.
Comments
We gave the public the opportunity to participate in developing this AD. We considered the comments received from the two commenters.
Request To Include Boeing Information Notice MD11-28-126 IN 02 in the
Final Rule
FedEx requests that Boeing Information Notice MD11-28-126 IN 02, dated July 1, 2009, be incorporated into the final rule. FedEx states that without including the information notice, FedEx will not be able to comply with the AD unless an Alternative Method of Compliance (AMOC) is granted. We partially agree. Boeing issued Information Notice MD11- 28-126 IN 02 to clarify the group applicability. The information notice is not approved by the FAA; therefore, we do not require the information notice for accomplishment of work and it is not incorporated into the requirements of this final rule. Note 1 has been added to this AD to explain that the information notice provides clarification of the airplane groups identified in the service bulletin.
Request for Compliance Time Extension
KLM requests that we extend the compliance time so that it will fall during regularly scheduled maintenance periods. KLM states that the 60-month compliance time specified in the NPRM does not take into consideration the impact on operators of accessing the area above the center upper auxiliary fuel tank, which is only opened during 72-month intervals. KLM states the work-hours and costs specified in the NPRM are unrealistic because the inspection is not done in the 72-month period.
We do not agree with the commenter's request to extend the compliance time. We have determined that the compliance time, as proposed, represents the maximum interval of time allowable for the affected airplanes to continue to safely operate before the modification is done. Since maintenance schedules vary among operators, there would be no assurance that the airplane would be modified during that maximum interval. However, operators may request an AMOC in accordance with the procedures specified in paragraph (j) of this AD.
We have not changed the AD in this regard.
Explanation of Changes Made to This AD
We have revised this AD to identify the legal name of the manufacturer as published in the most recent type certificate data sheet for the affected airplane models.
Conclusion
We reviewed the relevant data, considered the comments received, and determined that air safety and the public interest require adopting the AD with the changes described previously. We also determined that these changes will not increase the economic burden on any operator or increase the scope of the AD.
Costs of Compliance
We estimate that this AD affects 111 airplanes of U.S. registry.
The following table provides the estimated costs for U.S. operators to comply with this AD.
Estimated Costs
Number of U.S.-
Action
Work hours
Average labor
Parts
Cost per product
registered
Fleet cost rate per hour
airplanes
Inspection/Installation \1\.
136 to 154..........
$80 $9,405 to $12,201.. $20,285 to $24,521.
111 $2,251,635 to
$2,721,831.
\1\ Depending on airplane configuration.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. ``Subtitle VII: Aviation
Programs,'' describes in more detail the scope of the Agency's authority.
Page 69251
We are issuing this rulemaking under the authority described in
``Subtitle VII, Part A, Subpart III, Section 44701: General requirements.'' Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings
This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866,
(2) Is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979), and
(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
You can find our regulatory evaluation and the estimated costs of compliance in the AD Docket.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment 0
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES 0 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended] 0 2. The FAA amends Sec. 39.13 by adding the following new AD: 2009-26-16 McDonnell Douglas Corporation: Amendment 39-16155. Docket
No. FAA-2009-0686; Directorate Identifier 2009-NM-044-AD.
Effective Date
(a) This airworthiness directive (AD) is effective February 4, 2010.
Affected ADs
(b) None.
Applicability
(c) This AD applies to McDonnell Douglas Corporation Model MD-11 and MD-11F airplanes; certificated in any category; as identified in
Boeing Service Bulletin MD11-28-126, Revision 1, dated June 18, 2009.
Note 1: Boeing Information Notice MD11-28-126 IN 02, dated July 1, 2009, provides guidance that clarifies the airplane groups identified in Boeing Service Bulletin MD11-28-126, Revision 1, dated
June 18, 2009.
Subject
(d) Air Transport Association (ATA) of America Code 28: Fuel.
Unsafe Condition
(e) This AD results from fuel system reviews conducted by the manufacturer. The Federal Aviation Administration is issuing this AD to reduce the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
Compliance
(f) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the actions have already been done.
Actions
(g) Within 60 months after the effective date of this AD: Do the actions specified in paragraphs (g)(1), (g)(2), (g)(3), (g)(4), and
(g)(5) of this AD, and do all applicable corrective actions, in accordance with the Accomplishment Instructions of Boeing Service
Bulletin MD11-28-126, Revision 1, dated June 18, 2009, except as required by paragraph (h) of this AD. Do all applicable corrective actions before further flight.
(1) Do a general visual inspection to determine if wires touch the upper surface of the center upper auxiliary fuel tank, and mark the location, as applicable.
(2) Do a detailed inspection for splices and damage of all wire bundles above the center upper auxiliary fuel tank.
(3) Do a detailed inspection for damage (burn marks) on the upper surface of the center upper auxiliary fuel tank.
(4) Do a detailed inspection for damage (burn marks) on the fuel vapor barrier seal.
(5) Install nonmetallic barrier/shield sleeving, new clamps, new attaching hardware, and a new extruded channel.
(h) If damage (burn marks) is found on the upper surface of the center upper auxiliary fuel tank during any inspection required by paragraph (g)(3) of this AD, and Boeing Service Bulletin MD11-28- 126, Revision 1, dated June 18, 2009, specifies to contact The
Boeing Company for repair instructions: Before further flight, repair the auxiliary fuel tank using a method approved in accordance with the procedures specified in paragraph (j)(3) of this AD.
Actions Accomplished According to Previous Issue of Service Bulletin
(i) Actions accomplished before the effective date of this AD according to Boeing Service Bulletin MD11-28-126, dated March 3, 2009, are considered acceptable for compliance with the corresponding actions specified in this AD.
Alternative Methods of Compliance (AMOCs)
(j)(1) The Manager, Los Angeles Aircraft Certification Office
(ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Samuel Lee, Aerospace Engineer, Propulsion
Branch, ANM-140L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone
(562) 627-5262; fax (562) 627-5210.
(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19.
Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office.
The AMOC approval letter must specifically reference this AD.
(3) An AMOC that provides an acceptable level of safety may be used for any repair of the center upper auxiliary tank required by this AD, if it is approved by a Structures Authorized Representative for the Boeing Commercial Airplanes Delegation Option Authorization
Organization who has been authorized by the Manager, Los Angeles
ACO, to make those findings. For a repair method to be approved, the repair must meet the certification basis of the airplane, and the approval must specifically refer to this AD.
Material Incorporated by Reference
(k) You must use Boeing Service Bulletin MD11-28-126, Revision 1, dated June 18, 2009, to do the actions required by this AD, unless the AD specifies otherwise.
(1) The Director of the Federal Register approved the incorporation by reference of this service information under 5
U.S.C. 552(a) and 1 CFR part 51.
(2) For service information identified in this AD, contact
Boeing Commercial Airplanes, Attention: Data & Services Management, 3855 Lakewood Boulevard, MC D800-0019, Long Beach, California 90846- 0001; telephone 206-544-5000, extension 2; fax 206-766-5683; e-mail dse.boecom@boeing.com; Internet https://www.myboeingfleet.com.
(3) You may review copies of the service information at the FAA,
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton,
Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152.
(4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records
Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go
Page 69252
to: http://www.archives.gov/federal_register/code_of_federal_ regulations/ibr_locations.html.
Issued in Renton, Washington, on December 16, 2009.
Stephen P. Boyd,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
FR Doc. E9-30709 Filed 12-30-09; 8:45 am
BILLING CODE 4910-13-P
