Airworthiness directives: Saab,
[Federal Register: April 30, 2004 (Volume 69, Number 84)]
[Rules and Regulations]
[Page 23643-23644]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr30ap04-2]
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
[Docket No. 2003-NM-130-AD; Amendment 39-13597; AD 2004-09-08]
RIN 2120-AA64
Airworthiness Directives; Saab Model SAAB SF340A and SAAB 340B Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
SUMMARY: This amendment adopts a new airworthiness directive (AD), applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes, that requires relocating the most outboard latch in the right-hand leading edge of the refueling panel, and sealing of the original latch-mounting cutout. This action is necessary to prevent wear of the signal conditioner wiring harness behind the refueling panel, which could result in a short circuit and consequent smoke or fire behind the refueling panel. This action is intended to address the identified unsafe condition.
DATES: Effective June 4, 2004.
The incorporation by reference of a certain publication listed in the regulations is approved by the Director of the Federal Register as of June 4, 2004.
ADDRESSES: The service information referenced in this AD may be obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S- 581.88, Link[ouml]ping, Sweden. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Rosanne Ryburn, Aerospace Engineer; International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2139; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes was published in the Federal Register on March 5, 2004 (69 FR 10374). That action proposed to require relocating the most outboard latch in the right-hand leading edge of the refueling panel, and sealing of the original latch-mounting cutout.
Comments
Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.
Conclusion
The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 273 airplanes of U.S. registry will be affected by this AD, that it will take approximately 2 work hours per airplane to accomplish the required actions, and that the average labor rate is $65 per work hour. Required parts will cost approximately $310 per airplane. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $120,120, or $440 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
Regulatory Impact
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is not a ``significant regulatory action'' under Executive Order 12866; (2) is not a ``significant rule'' under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ``ADDRESSES.''
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment
0 Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0 1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0 2. Section 39.13 is amended by adding the following new airworthiness directive:
2004-09-08 Saab Aircraft AB: Amendment 39-13597. Docket 2003-NM-130- AD.
Applicability: Model SAAB SF340A series airplanes, serial numbers (S/N) 004 through 159 inclusive; and Model SAAB 340B series airplanes, S/Ns 160 through 459 inclusive; certificated in any category.
Compliance: Required as indicated, unless accomplished previously.
To prevent wear of the signal conditioner wiring harness behind the refueling panel, which could result in a short circuit and consequent smoke or fire behind the refueling panel, accomplish the following:
Corrective Action
(a) Within 24 months from the effective date of this AD, relocate the most outboard latch in the right-hand leading edge of the refueling panel, and seal the original latch-mounting cutout in the refueling panel; in accordance with the Accomplishment Instructions of Saab Service Bulletin 340-57-042, dated May 7, 2003.
Alternative Methods of Compliance
(b) In accordance with 14 CFR 39.19, the Manager, International Branch, ANM-116,
[[Page 23644]]
FAA, is authorized to approve alternative methods of compliance for this AD.
Incorporation by Reference
(c) The actions shall be done in accordance with Saab Service Bulletin 340-57-042, dated May 7, 2003. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S- 581.88, Link[ouml]ping, Sweden. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Note 1: The subject of this AD is addressed in Swedish airworthiness directive 1-187, dated May 8, 2003.
Effective Date
(d) This amendment becomes effective on June 4, 2004.
Issued in Renton, Washington, on April 20, 2004. Ali Bahrami, Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 04-9589 Filed 4-29-04; 8:45 am]
BILLING CODE 4910-13-P
